Tanita WB-300 - Manuals - manualsarea.com

Page 2 - Product Specifications; with Mechanical Height Rod); Important Notes for Users; Handling Tips

1. Product Specifications Product Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . WB-300 (Basic Electronic Medical Beam Scale) WB-300MH (Electronic Medical Beam Scale with Mechanical Height Rod) WB-300DH (Electronic Medical Beam Scale with Digital Height Rod and BMI Functio...

Page 3 - Components Description

3. Components Description 3 Lb/Kg Powe r Cloc k 19:00 124 1– 4 LB Lb/Kg Power Cloc k 19:00 124 1– 4 LB 2 3 4 1 WB-300 7 6 8 Standard Features: WB-300, WB-300MH, WB-300DH Measuring Platform Weight LCD Clock LCD Battery Compartment Height Rod Arm (For WB-300MH and WB-300DH) Height Rod Sliding Block Up...

Page 4 - WB-300DH version only; Right Side Clock LCD

4. Key Operation 4 Weight LCD Right Side Clock LCD WB-300DH version only Right Side Clock LCD WB-300 and WB-300MH versions only

Page 5 - Assembly Instructions; pull wire harness; List of Components

5. Assembly Instructions 1. Carefully remove all components from the box. 2. Place all items on the floor side by side. Make sure not to excessively pull the wire harness that connects the base (1) to the top assembly (6). 3. Carefully pull wire harness on topside of lower pillar (2) as pillar is in...

Page 6 - Level the Scale; rear feet; by hand until the scale becomes stabilized.; Insert the Batteries; Locking Clip; Remove the LCD Cover; Please remove the protection film placed on the LCD before use.

6. Before Use Level the Scale For best results, place the scale on a hard, even surface or carpet without padding. If the four feet located on the bottom of the platform do not make full contact with the floor, adjust the height of the two rear feet by hand until the scale becomes stabilized. Note: ...

Page 7 - Set up the Clock; and PM icon will appear on the right corner of clock.; Setting to Zero

Set up the Clock Entering Clock Adjusting Mode1. Press and hold the ‘Clock’ key on the right display panel for 2 to 3 seconds. The Clock LCD panel will flash ‘12 Hr’ or ‘24 Hr’ depending on the current display mode. 2. Use ‘Up’ or ‘Down’ key to select either 24 Hr or 12 Hr mode. If 12 Hr mode was se...

Page 8 - Instructions for Use; Weighing Procedure; There are three ways to measure weight depending on the situation.

7. Instructions for Use Weighing Procedure There are three ways to measure weight depending on the situation. • Auto-On Function can be used when the scale is in off-mode and the user is not on the scale. • Turn-On Function can be used when the scale is in off-mode and the user is not on the scale. ...

Page 9 - DO NOT press ‘Zero’ key.

Wake-up Function This function can be used if the user wishes to measure the weight immediately after the first reading. The scale must be in off-mode and the user must already be on the scale. 1. Press any key except ‘Zero’ key to activate (wake up) the scale. DO NOT press ‘Zero’ key. 2. Stand stil...

Page 10 - Measuring Height Procedure; Place hand on the Height Rod Arm.

Measuring Height Procedure (WB-300MH and DH) The user should step on the platform without wearing shoes for accurate measurement.Always have someone assist the user for accurate measurement. 1. Adjust the Height Rod Arm position before the user steps on the platform. Place hand on the Height Rod Arm...