Tanaka THT-210, THT-210s, THT-2000, THT-2100, THT-2120, THT-2510, THT-2520, THT-240, THT-2530, THT-2540, HTD-2520PF, HTD-2522PF, HTD-2526PF, HTD-2530PF, HTS-2530PF - Manuals

Page 2 - [email protected]; Owner’s Manual; Before using this unit:; Read the operator’s manual carefully.; WARNING; The engine exhaust from this product

www.tanaka-usa.com 1 [email protected] Owner’s Manual THT-210/210S/2000/2100/2120/2520, THT-240/2510/2530/2540/262 HTD-2520PF/2522PF/2526PF/2530PF, HTS-2530PF Before using this unit: • Read the operator’s manual carefully. • Check that the cutting equipment is correctly assembled and adjusted. ...

Page 3 - [email protected]

www.tanaka-usa.com 2 [email protected] Owner’s Manual THT-210/210S/2000/2100/2120/2520, THT-240/2510/2530/2540/262 HTD-2520PF/2522PF/2526PF/2530PF, HTS-2530PF 1. Recoil Starter 2. Fuel Tank 3. Safety Trigger 4. Throttle Trigger 5. Front Handle 6. Rear Handle 7. Spark Plug 8. Hand Guard 9. Cutti...

Page 5 - [email protected]; Assembly procedures; Remove the four washers and nuts (1) from cutting blade end.

www.tanaka-usa.com 4 [email protected] Owner’s Manual THT-210/210S/2000/2100/2120/2520, THT-240/2510/2530/2540/262 HTD-2520PF/2522PF/2526PF/2530PF, HTS-2530PF 3. Assembly procedures Handle B (3) and Gathering Plate (4) (Fig, 1-1) 1. Remove the four washers and nuts (1) from cutting blade end. N...

Page 6 - Operating procedures; Fuel; Always shut off the engine before refueling.

www.tanaka-usa.com 5 [email protected] Owner’s Manual THT-210/210S/2000/2100/2120/2520, THT-240/2510/2530/2540/262 HTD-2520PF/2522PF/2526PF/2530PF, HTS-2530PF 4. Operating procedures Fuel (Fig. 2-1) WARNING! The hedge trimmer is equipped with a two-stroke engine. Always run the engine on fuel, ...

Page 8 - Cutting; Decrease engine speed, and push ignition switch to stop position.

www.tanaka-usa.com 7 [email protected] Owner’s Manual THT-210/210S/2000/2100/2120/2520, THT-240/2510/2530/2540/262 HTD-2520PF/2522PF/2526PF/2530PF, HTS-2530PF Cutting When cutting, operate engine at full throttle as this maintains proper cutter speed. When trimming top of hedge, hold trimmer so...

Page 9 - MAINTENANCE, REPLACEMENT, OR REPAIR OF THE; The air filter must be cleaned from dust and dirt in order to avoid:

www.tanaka-usa.com 8 [email protected] Owner’s Manual THT-210/210S/2000/2100/2120/2520, THT-240/2510/2530/2540/262 HTD-2520PF/2522PF/2526PF/2530PF, HTS-2530PF 5. Maintenance MAINTENANCE, REPLACEMENT, OR REPAIR OF THE EMISSION CONTROL DEVICES AND SYSTEMS MAY BE PERFORMED BY ANY NONROAD ENGINE RE...

Page 11 - For long-term storage

www.tanaka-usa.com 10 [email protected] Owner’s Manual THT-210/210S/2000/2100/2120/2520, THT-240/2510/2530/2540/262 HTD-2520PF/2522PF/2526PF/2530PF, HTS-2530PF Gear case (Fig. 3-5, 5B) Apply a good quality lithium based grease through the grease fitting until a small amount comes out between th...

Page 14 - 3 [email protected]

www.tanaka-usa.com 13 [email protected] Owner’s Manual THT-210/210S/2000/2100/2120/2520, THT-240/2510/2530/2540/262 HTD-2520PF/2522PF/2526PF/2530PF, HTS-2530PF 6. Specifications cont.