Page 2 - Table of Contents; Introduction
Table of Contents 1. Introduction 1 1.1 Technical Support 1 1.2 FCC Compliance 1 1.3 Safety Compliance 1 1.4 About This Manual 1 1.5 Safety 2 1.5.1 Safety Intended Use 2 1.5.2 General Warnings 2 1.5.3 Safety Notices 2 1.5.4 Battery Safety 4 1.5.5 Repacking of Unit 4 2. Overview 5 2.1 UPS Devices and...
Page 4 - Technical Support; The following symbols are used in this manual:
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 1 1. Introduction Thank you for selecting this uninterruptible power supply (UPS). SurgeX offers the most reliable protection from the harmful effects of electrical line disturbances for your computing an...
Page 5 - Safety; Safety Intended Use; IMPORTANT SAFETY INSTRUCTIONS; To reduce the risk of fire, connect model
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 2 1.5 Safety 1.5.1 Safety Intended Use · This device serves as an uninterruptible power supply for connected loads. The device is in compli - ance with all relevant safety regulations concerning informati...
Page 6 - The UPS must be connected to an earthed mains outlet-socket.
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 3 · The units are heavy. Lifting the units into the rack requires a minimum of two people. · When installing units in racks, do not allow racks to become “top heavy”. Install heaviest equip- ment (typical...
Page 7 - Battery Safety; Voltage is always present on the battery terminals.; Repacking of Unit; Do not remove air from the packaging.
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 4 1.5.4 Battery Safety IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS CAUTION: The batteries installed in the UPS and within the extended battery packs contain electrolyte. Under normal conditions ...
Page 8 - Overview; UPS Devices and Batteries; SurgeX UPS Model; Packing List; Storage Data; Temperature Limits; UPS Shipping Package; One Battery Cable
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 5 2. Overview NOTE: The equipment has been thoroughly checked before shipment. Upon receipt, check the packaging and en - sure that the contents are undamaged and that no items are discarded. Any damage m...
Page 9 - Recharging the UPS During Storage; Storage Temperature; Environmental Conditions; The ideal ambient temperature range is 60°F to 77°F (15°C to 25°C).; Floor Loading
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 6 2.4 Recharging the UPS During Storage Before storing, charge the UPS for five hours. During storage, recharge the battery in accordance with the follow - ing table: Storage Temperature Recharge Frequenc...
Page 10 - Rear Panel View
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 7 2.8 Rear Panel View 2.8.1 Models: UPS-1000-OL 2.8.3 Model: UPS-3000-OL 2.8.2 Model: UPS-2000-OL
Page 13 - Installation; Tower Installation
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 10 3. Installation The UPS and external battery pack are designed to be rack-mounted in four post frames or to be floor standing in a tower configuration. 3.1 Tower Installation ATTENTION: Use all supplie...
Page 14 - Rack Installation; NEVER depend on lower devices to support other devices.; Assembly Steps; Refer to the figure directly below:
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 11 3.2 Rack Installation The UPS and the external battery packs are designed to be rack-mounted in four post frames. The UPS and ex- ternal battery pack use identical mounting hardware and procedures. NOT...
Page 16 - Electrical Preparations; Battery Connections; any other extended battery pack for the corresponding UPS.; UPS Model
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 13 3.3 Electrical Preparations CAUTION: Before connecting any input wiring to the UPS, take precautions to ensure that all cir - cuits being used are the proper voltage and current required for the UPS. C...
Page 18 - Setting Up UPS Parameters; Factory Default Settings; PARAMETER; Changing Default Settings; LCD Display in Bypass Mode
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 15 4. Setting Up UPS Parameters 4.1 Factory Default Settings The UPS is shipped with the following default factory settings. Refer to the table below and also to the table “LCD Display Abbreviation Index”...
Page 19 - Press the “LEFT ARROW” button.; Interface
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 16 1. Press and hold the “SELECT” button for at least five seconds to enter the UPS setting mode. 2. Press the “UP” or the “DOWN” button to scroll thru all of the parameters itemized as (01, 02, 03, 06, 0...
Page 20 - Setting
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 17 4.2.3 Output Frequency Setting (Item 03) Interface Setting You may set the initial frequency on battery mode: 50: output frequency is 50Hz 60: output frequency is 60Hz If converter mode is enabled, the...
Page 22 - UPS Operation; UPS Input Connection
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 19 5. UPS Operation 5.1 UPS Input Connection Plug the input of the UPS into a two-pole, three-wire, grounded receptacle. Avoid using extension cords. ATTENTION: This UPS is supplied with standard power co...
Page 23 - Connect Devices to the UPS; When the UPS is overloaded remove some load immediately.
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 20 5.2 Turn on the UPS (Put the UPS in On-Line Mode) When the input voltage is within the acceptable range press and hold the “ON/Mute” button for at least two sec - onds. A few seconds later the UPS will...
Page 24 - The UPS in Battery Mode; Rack Display; Turn Off the UPS; Press and hold the “OFF/ENTER “button for at least two seconds.
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 21 5.4 The UPS in Battery Mode 1) When the input voltage is not within the acceptable range or there is a mains failure the UPS will enter battery mode. The batteries will continue to provide an uninterru...
Page 25 - INTERFACES; Serial Interface COM 3
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 22 6. INTERFACES The UPS’s are equipped with a serial interface COM 3, USB and an interface slot COM. These interfaces can be used for: 1. Direct communication between UPS and a workstation/server. 2. Int...
Page 26 - Disable and Enable the EPO Function; Maintenance; Cleaning; Do not allow liquid to get inside the UPS.; UPS Storage
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 23 Pin 1 and Pin 2 shown in closed status. 7. Emergency Power Off (EPO) Disable and Enable the EPO Function Keep Pin 1 and Pin 2 closed (shorted) for UPS normal operation. To activate the EPO function, re...
Page 27 - Replacing Batteries; Do not dispose of batteries in a fire. The batteries may explode.
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 24 8.4 Replacing Batteries The UPS does not require maintenance by the user, however, battery maintenance is recommended in accordance with IEEE Recommended Practice for Maintenance, Testing and Replaceme...
Page 29 - contact your local recycling/reuse or hazardous waste center.
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 26 5. Slide in replacement battery pack. Refer to the figure directly below: 6. Reconnect the battery connectors. Use the tie wrap supplied with the replacement battery kit to secure the two halves of the...
Page 30 - Symptom
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 27 9. Troubleshooting 9.1 Troubleshooting Table If the UPS does not function properly, resolve the problem by referring to the table below. Symptom Possible cause Remedy No warning or fault indication and...
Page 35 - APPENDIX A: SPECIFICATIONS; SurgeX UPS
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 32 10 APPENDIX A: SPECIFICATIONS 10.1 SURGEX UPS (100 - 120 Volt UPS’s) Specifications SurgeX UPS 1000 VA Low Voltage Model UPS-1000-OL Type SurgeX Power Rating 1000 VA / 900 W Topology On-Line Double Con...
Page 36 - SPECIFICATIONS CONT.
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 33 SPECIFICATIONS CONT. SURGEX UPS (100 - 120 Volt UPS’s) specifications cont. Front Panel Controls Internal Batteries • User Hot-Swappable (See Instruction Manual) • Type - 12 V, 8.5 AH • Quantity - 2 Ba...
Page 41 - SurgeX Battery Pack
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 39 SPECIFICATIONS CONT. 10.2 Extension battery packs for use with SurgeX UPS SurgeX Battery Pack 1000 VA Low Voltage Model UPS-BPX-1000 Type SurgeX Compatible UPS UPS-1000-OL Voltage (Nominal) 24.0 VDC Ba...
Page 42 - SurgeX UPS Battery Pack
© 2017 AMETEK Electronic Systems Protection / Technical Support: 1-800-645-9721 / espsurgex.com 39 SPECIFICATIONS CONT. Extension battery packs for use with SurgeX specifications cont. SurgeX UPS Battery Pack 2000 VA Low Voltage Model UPS-BPX-2000 Type SurgeX Compatible UPS UPS-2000-OL Voltage (Nomi...
