Superior SSDVT-3530CNE - Manuals

Superior SSDVT-3530CNE – Manual in PDF format online.

Manuals:

Manual

Manual Superior SSDVT-3530CNE

Summary

Page 3 - GENERAL INFORMATION; Installation and repair should be per-; Table 1; Table 2; TABLE OF CONTENTS; INTRODUCTION

3 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. CONGRATULATIONS! In selecting this SUPERIOR Direct-Vent Gas Appliance you have chosen the fi nest and most dependable fi replace to be found anywhere. A beautiful, prestigious, alternative to a wood burning fi replace. Welcome to a Family of tens of...

Page 4 - Table 4; show the appliances' inlet; Table 5; must be disconnected; greater; by closing their; less than; drill size; Table 7; Cleaning Glass; Control Valve; Up; Figure 1

4 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Inlet Gas Supply Pressure (all models) Fuel # Minimum Maximum Natural Gas 5.0" WC (1.24 kPa) 10.5" WC (2.61 kPa) Propane 11.0" WC (2.74 kPa) 13.0" WC (3.23 kPa) Table 4 Gas Pressure - All Models Tables 4, 5 and 6 show the appliances'...

Page 5 - Honeywell Millivolt Gas Valve; Figure 5; Figure 3; Optional Blower OFF/ON Rocker Switch; SIT Millivolt Gas Valve; Figure 4; Honeywell Electronic Gas Valve; Electronic Appliances -

5 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. If your millivolt appliance is equipped with an optional remote switch kit (wall switch, remote control or wall thermostat) and the pilot is lit, the appliance main burner may be turned on and off using the optional switch. When using an optional re...

Page 6 - MAINTENANCE; Front Glass Enclosure Panel, Removal and

6 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. WARNING Turn off gas and electrical power before servicing the appliance. CAUTION Wear gloves and safety Glasses f o r p r o t e c t i o n w h i l e d o i n g required maintenance . IMPORTANT Always verify proper operation after servicing. MAINTENAN...

Page 7 - EXERCISE EXTREME CAUTION; INSTALLING GLASS DOOR; Figure 6

7 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Do not attempt to repaint the appliance until the fi nish is completely cured (see Burn-In Period on Page 4 ) . If the surface later becomes stained or marred, it may be lightly sanded and touched up with spray paint. Front Glass Enclosure Panel, Re...

Page 8 - REFERENCE; Description; Table 8; Bag of Glowing; Placement of Glowing Embers & Install; WARNING; moving Glass Enclosure Panels

8 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. WARNING The size and position of the log set was engineered to give the appli-ance a safe, reliable and attrac-tive fl ame pattern. Any attempt to use a different log set in the fi replace will void the warranty and will result in incomplete combust...

Page 9 - Figure 8; LOG SET

9 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Figure 8 MODEL SSDV-3530Log Placement Instructions LOG SET Catalog Number H3367 * Item Description A Log, Rear B Log, Top Left C Log, Center D Log, Top Right * Item "letters" above correspond to photos B C D A Install the Embers, Volcanic St...

Page 10 - Figure 9; Place Embers and Volcanic Stone as Shown

10 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Figure 9 LOG SET Catalog Number H3368 * Item Description A Log, Rear B Log, Top Left C Log, Center D Log, Top Right * Item "letters" above correspond to photos A C D B MODEL SSDV-4035Log Placement Instructions Install the Embers, Volcanic S...

Page 11 - Burner Air Shutter Adjustment Procedure; Figure

11 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Figure 10 - Burner Flame Appearance Models SSDV-3530 & SSDV-4035 Series BURNER ADJUSTMENTS (QUALIFIED TECHNICIANS ONLY) Flame Appearance and Sooting Proper fl ame appearance is a fl ame which is blue at the base and becomes yellowish-orange in ...

Page 12 - Burner Air Shutter Adjustment; Air Shutter; . Ensure the igniter

12 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Figure 11 Burner Air Shutter Adjustment Adjustment Rod Up(Fully Open Position) Air Shutter Adjustment Rod Down (minimum air opening position) Burner Tube Adjustment Setscrew Electronic Appliance Checkout To light the burner, refer to the lighting i...

Page 13 - TP; Thermopile; Field Wired; Standard OFF/ON Switch; CAUTION; Schematic Representation Only

13 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. WARRANTY Your gas appliance is covered by a limited twenty year warranty. You will fi nd a copy of the war-ranty accompanying this manual. Please read the warranty to be familiar with its coverage. Retain this manual. File it with your other docu-m...

Page 14 - Product Reference Information; Model; ACCESSORY COMPONENTS; The OFF/ON wall switch kit may be used to control

14 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Standard Remote Control System The Model RCL (Standard) Remote Control System, features a simplistic OFF/ON control function for the fi replace. This model includes a hand-held transmitter, a remote receiver with wall-mount cover plate and all hard...

Page 15 - Eyebrow Hood Kits; Polished Brass & Brushed Stainless Louvers Kits; Interior Brick Liner Kits; Screen Panel Kit; Decorative Arch Screen Panel Kit

15 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. ACCESSORY COMPONENTS Interior Brick Liner Kits The brickade liner kits include tan stamped sheetmetal panels for the rear and side walls of the fi rebox. The panels have brick-like features in relief. These kits can be retrofi tted into previously ...

Page 16 - Forced Air Kit; Arch Door Kits; - Piece Door Frame Kits

16 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Forced Air Kit The FBK-100 blower provides constant velocity forced air circulation. The FBK-200 assembly with variable speed, wall-mountable switch provides variable speed forced air circulation. The FBK-250 assembly with variable speed unit-mount...

Page 17 - LIGHTING INSTRUCTIONS – HONEYWELL AND SIT MILLIVOLT GAS VALVE; FOR YOUR SAFETY READ BEFORE LIGHTING; Knob cannot be turned from “PILOT” to “OFF”; SIT; IGNITER

17 LIGHTING INSTRUCTIONS – HONEYWELL AND SIT MILLIVOLT GAS VALVE WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. FOR YOUR SAFETY READ BEFORE LIGHTING A. This appliance has a pilot which must be lighted...

Page 18 - INSTRUCTIONS D’ALLUMAGE – VANNE GAZ MILLIVOLT HONEYWELL ET SIT; INSTRUCTIONS D'ALLUMAGE; Il est impossible de tourner le bouton de “PILOT” à “OFF” à; POUR FERMER LE GAZ QUI ALIMENTE L’APPAREIL; VANNE GAZ; HONEYWELL

18 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. INSTRUCTIONS D’ALLUMAGE – VANNE GAZ MILLIVOLT HONEYWELL ET SIT INSTRUCTIONS D'ALLUMAGE 8. Enfoncez le bouton de réglage jusqu’au fond et gardez-le enfoncé.Allumez immédiatement la veilleuse en déclen...

Page 19 - LIGHTING INSTRUCTIONS — ELECTRONIC; TO TURN OFF GAS TO APPLIANCE; Honeywell Electronic Gas Control Valve

19 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. When lighting the appliance, follow these instructions exactly. B. BEFORE OPERATING smell all arou...

Page 20 - INSTRUCTIONS D’ALLUMAGE — ELECTRONIC; INSTRUCTIONS D’ALLUMAGE; POUR ÉTEINDRE L’APPAREIL; Interrupteur; Vue de face

20 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. INSTRUCTIONS D’ALLUMAGE — ELECTRONIC INSTRUCTIONS D’ALLUMAGE POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE A. Lorsque vous allumez l’appareil, suivez exactement ces instruc-tions. B. A...

Page 21 - Periodically

21 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. MAINTENANCE TASK ACCOMPLISHING PERSON PROCEDURE Inspecting/Cleaning Burner, Logs and Controls Qualifi ed Service Technician Inspect valve and ensure it is properly operating. Check piping for leaks. Vacuum the control compartment, fi replace logs a...

Page 22 - TROUBLESHOOTING GUIDE - MILLIVOLT GAS CONTROL SYSTEM; TROUBLESHOOTING GUIDE - ELECTRONIC IGNITION SYSTEM

22 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. TROUBLESHOOTING GUIDE - MILLIVOLT GAS CONTROL SYSTEM Note: Before troubleshooting the gas control system, Ensure external gas shut off valve, located at gas supply inlet, (and wall switch, iff applicable), is in the “ON” position. Important: Valve ...

Page 23 - TROUBLESHOOTING PROCEDURE - ELECTRONIC IGNITION SYSTEM

23 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. START CHECK • Turn Off Gas Supply. • Ensure Valve Switch Is In ON Position. • Disconnect Control Harness. • Set Thermostat To Call For Heat. • Check for proper volt- age at control harness (see insert A). Voltage should be 24V between thermostat or...

Page 25 - REPLACEMENT PARTS DIAGRAMS

25 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. REPLACEMENT PARTS DIAGRAMS 7 1 2 11 12 15 14 6 21 13 3 17 20 18 16 19 4 26 27 28 29 25 24 32 31 34 30 22 33 23 8 5 9 10

Page 26 - NOTES

26 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. NOTES