Page 2 - taBLe oF contents; introduction; show the appliances' inlet; Table 2; Table 1; GeneraL inForMation
2 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. conGratuLations! In selecting this SUPERIOR Direct-Vent Gas Appliance you have chosen the finest and most dependable fireplace to be found anywhere. A beautiful, prestigious, alternative to a wood burning fireplace. Welcome to a Family of tens of th...
Page 3 - Cleaning Glass; Gas controls / control compartment; The top louvered panel and the bottom; openinG controL; Lower control; up; Figure 1; Table 4; Table 6; must be disconnected; greater; by closing their; less than
3 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Test gauge connections are provided on the front of the millivolt gas control valve, identi- fied IN for the inlet and OUT for the manifold side. A 1/8" NPT Test gauge connection is provided at the inlet and outlet side of the electronic gas con...
Page 4 - Remote Wall Switch, Remote; Variable Flame Height adjustment; Honeywell Millivolt Gas Valve; SIT Millivolt Gas Valve; Honeywell Electronic Gas Valve
4 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. If your millivolt appliance is equipped with an optional remote switch kit (wall switch, remote control or wall thermostat) and the pilot is lit, the appliance main burner may be turned on and off using the optional switch. When using an optional re...
Page 5 - Maintenance; Pages 7 to 9
5 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. WarninG turn off gas and electrical power before servicing the appliance. caution Wear gloves and safety Glasses for protection while doing required maintenance . iMportant always verify proper operation after servicing. Maintenance (see Maintenance...
Page 6 - WarninG; The flame appearance will be dimin-; eXercise eXtreMe caution; instaLLinG GLass door; Figure 6; installing Glass enclosure panels; Reinstalling Control
6 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Do not attempt to repaint the appliance until the finish is completely cured (see Burn-In Period on Page 3 ) . If the surface later becomes stained or marred, it may be lightly sanded and touched up with spray paint. Front Glass enclosure panel, rem...
Page 7 - reFerence; Table 8; Bag of Glowing; Glowing Embers; instaLL LoGs, VoLcanic stone and; Figure 7; Glowing ember/Volcanic stone placement; see
7 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. WarninG the size and position of the log set was engineered to give the appli- ance a safe, reliable and attrac- tive flame pattern. any attempt to use a different log set in the fireplace will void the warranty and will result in incomplete combust...
Page 9 - Figure 9; Burner adJustMents; ensure front glass panel is in place; caution; Burner air shutter adjustment procedure; Rotating the adjustment rod coun-
9 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Figure 9 - Burner Flame appearance Model ssdV-3328 series Burner adJustMents (QuaLiFied tecHnicians onLY) Flame appearance and sooting Proper flame appearance is a flame which is blue at the base and becomes yellowish-orange in the body of the flame...
Page 10 - Burner air shutter adjustment; Figure
0 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Burner air shutter adjustment adjustment rod up (Fully open position) air shutter adjustment rod down (minimum air opening position) Burner tube adjustment setscrew electronic appliance checkout To light the burner, refer to the lighting instruc- ti...
Page 11 - thermopile; Field Wired; standard oFF/on switch; Label all wires prior to discon-; schematic representation only
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. WarrantY Your gas appliance is covered by a limited twenty year warranty. You will find a copy of the war- ranty accompanying this manual. Please read the warranty to be familiar with its coverage. Retain this manual. File it with your other docu- men...
Page 13 - product reference information; Model; accessorY coMponents
3 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. standard remote control system The Model RCL (Standard) Remote Control System, features a simplistic OFF/ON control function for the fireplace. This model includes a hand-held transmitter, a remote receiver with wall-mount cover plate and all hardwa...
Page 14 - eyebrow Hood Kits
4 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. accessorY coMponents interior Brick Liner Kits The brickade liner kits include tan stamped sheetmetal panels for the rear and side walls of the firebox. The panels have brick-like features in relief. These kits can be retrofitted into previously ins...
Page 15 - Forced air Kit; arch door Kits; - piece door Frame Kits; door Frame Kits
5 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Forced air Kit The FBK-100 blower provides constant velocity forced air circulation. The FBK-200 assembly with variable speed, wall-mountable switch provides variable speed forced air circulation. The FBK-250 assembly with variable speed unit-mounta...
Page 16 - LiGHtinG instructions – HoneYWeLL and sit MiLLiVoLt Gas VaLVe; For Your saFetY read BeFore LiGHtinG; Knob cannot be turned from “PILOT” to “OFF”; sit; iGniter
6 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. LiGHtinG instructions – HoneYWeLL and sit MiLLiVoLt Gas VaLVe For Your saFetY read BeFore LiGHtinG a. This appliance has a pilot which must be lighted with a piezo igniter. When lighting the pilot, follow these instructions exactly. B. BeFore operat...
Page 17 - INSTRUCTIONS D’ALLUMAGE – VANNE GAZ MILLIVOLT HONEYWELL ET SIT; INSTRUCTIONS D'ALLUMAGE; VOICI CE QUE VOUS DEVEZ FAIRE SI VOUS DÉCELEZ UNE ODEUR; POUR FERMER LE GAZ QUI ALIMENTE L’APPAREIL; VANNE GAZ; HONEYWELL
7 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. INSTRUCTIONS D’ALLUMAGE – VANNE GAZ MILLIVOLT HONEYWELL ET SIT INSTRUCTIONS D'ALLUMAGE 8. Enfoncez le bouton de réglage jusqu’au fond et gardez-le enfoncé. Allumez immédiatement la veilleuse en déclen...
Page 18 - LiGHtinG instructions — eLectronic; to turn oFF Gas to appLiance; Honeywell electronic Gas control Valve
8 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. a. When lighting the appliance, follow these instructions exactly. B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor. WHat to do iF Y...
Page 19 - INSTRUCTIONS D’ALLUMAGE — ELECTRONIC; INSTRUCTIONS D’ALLUMAGE; VOICI CE QUE VOUS DEVEZ FAIRE SI VOUS DÉCELEZ UNE; Interrupteur; Vue de face
9 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. INSTRUCTIONS D’ALLUMAGE — ELECTRONIC INSTRUCTIONS D’ALLUMAGE POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE A. Lorsque vous allumez l’appareil, suivez exactement ces instruc- tions. B. A...
Page 20 - periodically; Figure 9 on Page 9; do not toucH or atteMpt to cLean GLass
20 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Maintenance tasK accoMpLisHinG person procedure Inspecting/Cleaning Burner, Logs and Controls Qualified Service Technician Inspect valve and ensure it is properly operating. Check piping for leaks. Vacuum the control compartment, fireplace logs and...
Page 22 - trouBLesHootinG procedure - eLectronic iGnition sYsteM
22 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. start cHecK • turn off Gas supply.• ensure Valve switch is in on position.• disconnect control Harness.• set thermostat to call For Heat. • check for proper volt- age at control harness (see insert a). Voltage should be 24V between thermostat or pr...
Page 24 - LHp; repLaceMent parts diaGraMs
24 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Printed in U.S.A. © 2007 by LHP p/n 725,045M reV. n/c 09/2007 LHP reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local d...