Page 2 - Tools Should Include:; TABLE OF CONTENTS; Electrical Wiring – Optional Blower . page 7; GENERAL INFORMATION; Due to high temperatures, the appliance
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 2 Check the inventory list to be sure that you haveall the necessary parts in usable condition. Alsocheck for concealed damage. IMPORTANT SAFETY INFORMATION INSTALLER: PLEASE LEAVE THESE INSTRUC-TIONS WITH THE OWNER. OWNER: PLEASE RETAIN THESE INSTRUC-...
Page 4 - LOCATION OF FIREPLACE; Figure 1; Clearances
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 4 3. Add the BTU/hr of all the fuel burning appli-ances in the space. Vent-Free heater (Max.) ______ BTU/hr Gas appliance #1* ______ BTU/hr Gas appliance #2 + ______ BTU/hr Total = ______ BTU/hr Example: CF6500 Catalytic heater 29,000 BTU/hr Gas applia...
Page 5 - PREINSTALLATION
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 5 WARNING: DO NOT INSTALL THESEAPPLIANCES:• W H E R E C U R T A I N S , F U R N I T U R E , CLOTHING OR OTHER FLAMMABLEOBJECTS ARE LESS THAN 42" FROMTHE FRONT OF THE UNVENTED ROOMHEATER. • IN HIGH TRAFFIC AREAS.• IN WINDY OR DRAFTY AREAS. Ensure th...
Page 7 - Never use an
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 7 The gas control valve is located in the lowercontrol compartment. To access the valve openthe lower control compartment door ( Figure 13 ). The control valve has a ³⁄₈ " NPT thread inlet port and is fitted with a 3" (76 mm) long nipple, ³⁄₈ &...
Page 8 - The header may rest on the top spacers; Burner; Front; The flames should not impinge on the logs.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 8 Figure 16 Note: Supply wires may be alternatively connected to the outlet using the screw terminals, however the black supply wire must be ganged wired to the same terminal that the pre-wired black wire isattached to and the white supply wire must be...
Page 9 - Step 10. Checking the System –
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 9 Figure 18 Step 10. Checking the System – After the gas line is installed, logs are in place and thesystem is leak checked, run initial systemcheckout before closing up the front of theunit. Follow the pilot lighting instructions onpages 16 and 17. No...
Page 10 - Orifice
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 10 Rear Burner Flames – The rear flames rising in front of center and rear logs should be yellowand extend about 2 ¹⁄₂ – 3" above the large logs for natural gas and 1 ¹⁄₂ – 2 ¹⁄₂ ” above for propane gas. Front Burner Flames – The flames at the fron...
Page 11 - Forced Air Kit; The last; Step 11. Installing the Glass Door Frame –; OPTIONAL EQUIPMENT; Figure 15 and Step 7 for detailed; Rocker Switch Switch Kit
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 11 The appliances covered in this manual areheater rated and produce a great deal of heat.Decorative brass trim pieces and hoods maytarnish because of their proximity to the heateropening and front face. Tarnishing of thesepieces is normal, unavoidable...
Page 12 - Flame Adjustments –
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 12 8. CAUTION: DO NOT OPERATE THIS APPLI-ANCE WITH A BROKEN GLASS PANEL. Where broken glass exists, the complete glass enclo-sure panel must be replaced. See the Replace-ment Parts List on page 18 for correct replace-ment part numbers. Glass enclosure ...
Page 14 - ACCESSORIES AND COMPONENTS
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 14 ACCESSORIES AND COMPONENTS Forced Air Kit FAB-1100 Remote Control Kit RCK Rocker Switch Kit RS VF5-BRLK Brass Louver Kits VF6-BRLK 1-Piece Decorative DAT-5000-1 Arch Frame Kit DAT-6000-1 SPK-5000 Screen Panel Kits SPK-6000 Wall Switch Kit WSK Gas Fl...
Page 15 - Front View; Left Side View
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 15 CF5500 SPECIFICATIONS Figure 28 CF6500 SPECIFICATIONS Figure 29 37" (940 mm) 36" (914 mm) 30" (762 mm) 31 ¹⁄₂ " (800 mm) 15" (381 mm) Front View (CF5500) Top View 27" (686 mm) 36" (914 mm) 15 ¹⁄₂ " (394 mm) Left Side ...
Page 16 - TROUBLESHOOTING THE CF MILLIVOLT GAS CONTROL SYSTEM; CORRECTIVE ACTION
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 16 TROUBLESHOOTING THE CF MILLIVOLT GAS CONTROL SYSTEM 1. Spark ignitor will not lightpilot after repeatedtriggering of black button. 2. Pilot will not stay lit aftercarefully following thelighting instructions. 3. Pilot burning, no gas toburner, Valve...
Page 17 - LIGHTING INSTRUCTIONS – MILLIVOLT; FOR YOUR SAFETY READ BEFORE LIGHTING; WHAT TO DO IF YOU SMELL GAS; TO TURN OFF GAS TO APPLIANCE
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 17 LIGHTING INSTRUCTIONS – MILLIVOLT WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSIONMAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. FOR YOUR SAFETY READ BEFORE LIGHTING • Do not use any phone in your b...
Page 18 - DESCRIPTION
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 18 REPLACEMENT PARTS LIST — MILLIVOLT GAS CONTROLS — MILLIVOLT CF5500-CMN CF5500-CMP CF6500-CMN CF6500-CMP CF5500-CMN CF5500-CMP CF6500-CMN CF6500-CMP No. DESCRIPTION Part No. Qty. Part No. Qty. Part No. Qty. Part No. Qty. 1. Gas Fireplace Assembly 128...
Page 19 - REPLACEMENT PARTS
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 19 REPLACEMENT PARTS 12 5 2 4 2 1 6 7 21 3 20 13 7 22 24 23 8 11 10 9 b. a. c. d. (SIT Valve Shown)
Page 20 - SFC
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. 20 Printed in U.S.A. © 1999 by SFC P/N 904538 REV. E 02/2004 Catalytic Gas Fireplace Manufacturer's Limited Warranty 10 Years T H E W A R R A N T Y T h e m a n u f a c t u r e r w a r r a n t s t h e c o m p o n e n t s o f t h i s C a t a l y t i c G ...