Subaru EH025P - Manuals

ENGLISH ( US ) FOREWORD Thank you very much for purchasing a ROBIN ENGINE . Your ROBIN ENGINE can supply the power to operate varioussorts of machines and equipment.Please take a moment to familiarize yourself with the properoperation and maintenance procedures in order to maximizethe safe and effic...

CONTENTS 1. SAFETY PRECAUTIONS ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ 1 2. COMPONENTS ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ 4 3. PRE - OPERATION CHECKS ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ 7 4. OPERATING YOUR ENGINE ・ ・ ・ ・ ・ ・ ・ ・ ・ ...

ENGLISH ( US ) SYMBOLS Read the owner's manual. Stay clear of the hot surface. Exhaust gas is poisonous.Do not operate in an unventilated area. Stop the engine before refueling. Fire, open flame and smoking prohibited. On (Run) Plus ;positive polarity Off (Stop) Battery Engine oil Engine start (Elec...

- 1 - 1. SAFETY PRECAUTIONS ■ Never inhale exhaust gasses. They contain carbon monoxide, a colorless, odorless and extremely dangerous gas which can cause unconsciousness or death. ■ Never operate the engine indoors or in a poorly ventilated area, such as tunnel, cave, etc. ■ Exercise extreme care w...

3. PRE-OPERATION CHECKS - 7 - CHECK ENGINE OIL Before checking or refilling engine oil, besure the engine is located on a stable, levelsurface and stopped. ■ Do not thread the gauge into oil filler tocheck oil level. ■ If the oil level is below the lower levelline on the dipstick, refill with the pr...

4. OPERATING YOUR ENGINE - 8 - ENGLISH ( US ) ON ON OFF ■ Pull the starter handle slowly, untilresistance is felt.This is the "compression" point.Return the handle to its originalposition and pull swiftly. ■ Do not pull out the rope all the way. ■ After starting the engine, allow thestarter ...

- 9 - STOPPING OFF ON OFF 1 ■ Set the throttle lever at the lowspeed position and allow the engineto run at low speed for 2 or 3minutes before stopping. ■ If the stop switch is installed on theengine.Set the stop switch to theposition "OFF or O ". ■ If the stop switch is installed on amachin...

5. EASY TROUBLESHOOTING - 10 - ENGLISH ( US ) WHEN ENGINE DOES NOT START: ■ Perform the following checks before you takethe engine to your Robin dealer. ■ If you still have trouble after completing the checks,take the engine to your nearest Robin dealer. Is there enough compression? 1. Pull the star...

6. MAINTENANCE SCHEDULE - 11 - DAILY INSPECTION Before running the engine, check the following service items. MAINTENANCE, REPLACEMENT OR REPAIR OF EMISSION CONTROL DEVICESAND SYSTEMS MAY BE PERFORMED BY ANY NON-ROAD ENGINE REPAIRESTABLISHMENT OR INDIVIDUAL. Excessive vibration,noise Clean air clean...

- 12 - ENGLISH ( US ) NOTE : Replace rubber hoses for passage every one year. If and when fuel leakage isfound, replace hose at once. Periodic Maintenance Schedule table * Note 1 : Initial oil change should be performed after first twenty (20) hours of operation. Thereafter change oil every fifty (5...

7. "HOW-TO" MAINTENANCE - 13 - INSPECTING THE SPARKPLUG ■ Clean off carbon deposits on thespark plug electrode using a plugcleaner or wire brush. ■ Check electrode gap.Adjust gap 0.7 mm to 0.8 mm (0.03 inches) ■ Use a proper spark plug : NGK CMR6A 0.7 to 0.8 mm(0.03 in.) ENGINE OIL CHANGE ■ ...

- 14 - ENGLISH ( US ) 3) Remove the oil gauge, then tilt the engine and drain the oil into a pan orother receptacle.(EH035V) Remove the oil drainscrew and drain the oil. 4) Put the engine on a level surface, then fill with the oil up to the point ofoverflowing the filler neck. Pour theoil in from a ...

- 16 - ENGLISH ( US ) FUEL PIPE REPLACEMENT Replace the fuel pipe every 1 year. If the fuel leakage is found on the fuelpipe, replace it immediately. CHECKING BOLTS, NUTSAND SCREWS Retighten loose bolts and nuts. Check for fuel and oil leaks.Replace damaged parts with new ones.Keep safety in your mi...

8. PREPARATIONS FOR STORAGE - 17 - ENGINE OIL ■ Change the engine oil with fresh oil. ■ Remove the spark plug, pour about 2cc engine oil into the cylinder, slowlypull the starter handle of the recoilstarter 2 or 3 times, and tighten thespark plug. CLEAN AND STORE ■ Slowly pull the recoil starter han...