Stiebel Eltron DEL18AU - Manuals

OPERATION Settings and displays EN GL ISH www.stiebel-eltron.com DEL AU| 5 4. Settings and displays 4.1 User interface M1 Tmax M2 D 00000 40 72 6 2 3 1 5 4 1 Temperature selector 2 LED scalding risk indicator 3 Memory keys M1 and M2 4 Display 5 Temperature limit T max Display symbols 1 2 3 4 D 00000...

OPERATION Cleaning, care and maintenance 6 | DEL AU www.stiebel-eltron.com 4.3 Inlet temperature information If the inlet temperature is higher than the preferred temperature, e.g. if water has been preheated by solar energy, the display alter- nates between showing "hot" and the measured in...

EN GL ISH www.stiebel-eltron.com DEL AU| 7 INSTALLATION Safety INSTALLATION 7. Safety Only a qualified contractor should carry out installation, commis- sioning, maintenance and repair of the appliance. 7.1 General safety instructions We guarantee trouble-free function and operational reliability on...

8 | DEL AU www.stiebel-eltron.com INSTALLATION Installation 9.1 Installation site ! Material losses Only install the appliance in rooms free from the risk of frost. f f Always install the appliance vertically near the draw-off point. The appliance is suitable for undersink and oversink installations...

EN GL ISH www.stiebel-eltron.com DEL AU| 9 INSTALLATION Installation 160 30 1 26 �0 2� 02 �0 82 4� 1 Installation aid f f Prepare the power cable. Preparing the water connection ! Material losses Carry out all water connection and installation work in accordance with regulations. D 00000 41 72 0 f f...

10 | DEL AU www.stiebel-eltron.com INSTALLATION Installation D 00000 41 72 3 f f Screw the pre-assembled parts with flat gaskets to the cold water and DHW pipes of the appliance. f f Fit the cold water inlet pipe and the DHW outlet pipe from the pipework with flat gaskets to the extensions from the ...

EN GL ISH www.stiebel-eltron.com DEL AU| 11 INSTALLATION Installation f f When installing connection pipes that are not offset, break off the tabs on the cover guides. f f Click the cover guides into place in the pipe apertures. f f Position the back panel guides on the extensions. Push them togethe...

12 | DEL AU www.stiebel-eltron.com INSTALLATION Installation D 00000 43 29 1 f f Fit the strainer and the plastic profile washer in the tee for the cold water inlet. ! Damage to the appliance and environment The strainer must be fitted for the appliance to function. f f When replacing the appliance,...

EN GL ISH www.stiebel-eltron.com DEL AU| 13 INSTALLATION Commissioning Operation with preheated water You can limit the maximum inlet temperature by installing a cen- tral thermostatic valve. Anti-scalding protection / temperature limit 60 43 D 00000 40 98 5 2 1 1 Position 43: Maximum temperature se...

14 | DEL AU www.stiebel-eltron.com INSTALLATION Shutting down the system 11.2 Recommissioning See chapter "Settings and displays / Following an interruption to the water supply" 12. Shutting down the system f f Isolate all poles of the appliance from the power supply. f f Drain the appliance...

EN GL ISH www.stiebel-eltron.com DEL AU| 15 INSTALLATION Troubleshooting 13.2 Indicator options for LED diagnostic traffic light Indicator options Red Illuminates in the event of a fault Yellow Illuminates during heating mode Green Flashing: Appliance is supplied with mains power 13.3 Fault table LE...

16 | DEL AU www.stiebel-eltron.com INSTALLATION Maintenance 14. Maintenance WARNING Electrocution Before any work on the appliance, disconnect all poles from the power supply. Draining the appliance You can drain the appliance for maintenance work or to protect it from frost. CAUTION Scalding Hot wa...

EN GL ISH www.stiebel-eltron.com DEL AU| 17 INSTALLATION Specification 15.2 Wiring diagram 3/PE ~ 380-415 V 85 �0 2� 02 �0 00 5� 1 Heater 2 High limit safety cut-out 3 Safety pressure limiter 15.3 DHW output DHW output is subject to the mains voltage, the appliance's con- nected load and the cold wa...

EN GL ISH www.stiebel-eltron.com DEL AU| 19 WARR $ NTY | ENVIRONMENT AND RECYCLING WARRENTY | ENVIRONMENT AND RECYCLING Warranty The warranty conditions of our German companies do not apply to appliances acquired outside of Germany. In countries where our subsidiaries sell our products, it is increa...

20 | DEL AU www.stiebel-eltron.com WARR $ NTY | ENVIRONMENT AND RECYCLING 12.3. The unit has not been operated or maintained in accord- ance with the Operating and Installation Guide. 12.4. The unit does not bear its original Serial Number or Rating Label. 12.5. The unit was damaged by any or any co...