Stanley SXPW1451BS - Manuals

Page 2 - Section; IMPORTANT; Please take note of serial number and write here for; YEARS

2 3 SUGGESTED APPLICATIONS These are some suggested applications where you could use your pressure washer:• Concrete driveway• Paved area• Car• Motorbike• Truck• Wall• Garden feature CONTENTS Section Page Contents 2 Suggested Applications 2 Introduction 3 Warranty 3 – 4 General Safety Instructions 5...

Page 3 - How to claim under this warranty.

2 3 INTRODUCTION Dear Customer,Thank you for purchasing this pressure washer which has passed through our extensive quality assurance processes. Every care has been taken to ensure that it reaches you in perfect condition. However, in the unlikely event that you should experience a problem, or if yo...

Page 4 - COMPLETE WARRANTY STATEMENT – PRESSURE WASHER

4 5 As soon as you have purchased the pressure washer, we recommend that you check to make sure it is intact and that you read the operating instructions carefully before using it. The purchase receipt for this product is to be retained and must be presented if making a claim under the terms of the ...

Page 8 - SPECIFIC SAFETY INSTRUCTIONS

8 9 SPECIFIC SAFETY INSTRUCTIONS Warning! Do not use the pressure washer in areas where there is a risk of explosion or fire from combustible materials. The sparks possibly caused when using this pressure washer may ignite combustible materials as well as flammable liquids, paint, varnish, petrol, f...

Page 9 - Stratton Engine Manual for details on warranty and servicing.

8 9 IMPORTANT FUEL - ONLY USE UNLEADED 91 PETROL (ULP - 91RON) - NO ETHANOL Fuel tank capacity – 6.6 litres (6.6 L) Use of incorrect fuel and /or oil may damage the pressure washer and will not be covered under warranty. Do not use E10 or any type of ethanol fuel as this will damage the pressure was...

Page 10 - COMPONENTS AND CONTROLS; Pin Point

10 11 COMPONENTS AND CONTROLS Pic. 1 1. Handle2. Nozzles RED - Pin Point YELLOW - 15° GREEN - 25° WHITE - 40° BLACK - Detergent 3. Gun and trigger4. Fuel tank5. Lance6. Recoil Starter7. Wheel8. High pressure hose9. Detergent controls PIC. 1 8 9 7 1 3 2 5 4 6

Page 12 - HOSE CONNECTION

12 13 Hose to Pump Pic. 5 1. Attach the high pressure hose to the pump. Pull back collar and push male connector in fully. Release collar. Ensure that the hose does not touch the muffler or goes over the top of the fuel tank. 2. Have hose lay to the back of the pump and curve to the hose hanger. Not...

Page 14 - Adding Lubricating Oil; OIL

14 15 PIC. 9B PIC. 9A PIC. 10 FILL CAP FILL CAP LEFT/RIGHT SELECTOR Adding Lubricating Oil Always use clean fresh oil as specified on page 9. Incorrect or old oil can cause the pressure washer to run rough and damage the motor; this will not be covered by warranty. 1. Ensure that engine is OFF when ...

Page 15 - Starting Handle

14 15 STARTING YOUR PRESSURE WASHER 1. Check oil level.2. Check and fill fuel. 3. Connect garden hose to cold water source. Do not turn on! 4. Connect garden hose to garden connection on pump.5. Select nozzle, see page 136. If using detergent fill and select bottle refer page 14, Pic. 10. 7. Turn ch...

Page 17 - CLEANING TIPS

16 17 CLEANING TIPS Deck Cleaning - with or without detergent Pre-rinse deck and surrounding area with fresh water. If using deck wash, place detergent suction tube directly into cleaning solution and apply to surface at low pressure. For best results, limit your work area to smaller sections of app...

Page 18 - MAINTENANCE INFORMATION; Fuel Tank Filter, Pic 18

18 19 MAINTENANCE INFORMATION If scheduled maintenance is NOT carried out then this will void your warranty. Use the Service Log on page 22 to keep track of the regular servicing. Ensure that the authorised service agent has dated, signed and stamped this log to ensure your warranty is not void. Fue...

Page 19 - MAINTENANCE SCHEDULE

18 19 Engine OIL (CHECK DAILY - ONLY USE 4 STROKE MOTOR OIL) This pressure washer is fitted with a Briggs & Stratton engine. Please refer to the enclosed Briggs & Stratton Engine Manual for details on warranty and servicing. To operate, this pressure washer requires oil in the sump, not supp...

Page 20 - TROUBLE SHOOTING

20 21 TROUBLE SHOOTING POSSIBLE CAUSE SUGGESTED FIX Engine will not start No or low fuel in the fuel tank Fill fuel tank No or low oil in sump Fill oil sump Fuel/Engine lever is OFF Turn fuel/engine lever ON Choke is set to RUN Slide choke to START Pressurised pump Turn water tap off, pull trigger t...

Page 21 - PARTS DIAGRAM; User replaceable parts listed below. All other parts must

20 21 PARTS DIAGRAM Part Description Part No. 1 Gun - trigger & Lance 84 PW1435GT 2 High pressure hose 20m QC 84 PW1451HPH 3 Nozzle yellow 84 PWNOZ 4 Nozzle black 84 PWNOZ 5 Nozzle red 84 PWNOZ 6 Nozzle white 84 PWNOZ 7 Nozzle green 84 PWNOZ 8 Wheel 84 PWWH Note: Gun, trigger and lance are all o...

Page 23 - TECHNICAL INFORMATION

22 23 TECHNICAL INFORMATION Specifications Pressure washer SXPW1451BS Maximum pressure 4200PSI Flow rate 13.5L/min Water inlet pressure 0.4MPa Water inlet temp 35oC Engine 13.5HP Briggs & Stratton 4 stroke OHV Weight 65Kg (no fuel) Fuel volume 6.6L Oil SAE 30W or SAE 15W-40 Oil Quantity 1100mL S...

Page 24 - For any queries or assistance call; Customer Service; Keep your purchase receipt, this will be required to

24 24 For any queries or assistance call Customer Service AUST. 1300 660 457 NZ 0800 474 876 Hours of operation: Monday to Friday 8.00am - 5.00pm AEST Do not return to place of purchase. Keep your purchase receipt, this will be required to make any claims under the warranty, stated on page 3. STANLE...