SPT SD-9263SSB - Manuals

5 The appliance needs to be connected to the main water valve using new hose sets. Old sets should not be reused.To save energy, in stand by mode , the appliance will switch off automatically while there is no any operation in 30 minutes . Disposal For disposing of package and the appliance please g...

6 PRODUCT OVERVIEW To get the best performance from your dishwasher, read all operating instructions before using it for the first time. IMPORTANT: NOTE : Dispenser Filter assembly Lower spray arm Inner pipe Upper spray arm Upper basket Cup rack Lower basket Cutlery basket Pictures are only for refe...

7 INSTALLATION INSTRUCTION rating plate. Only insert the plug into an electrical socket which is earthed properly. If the electrical socket to which the appliance must be connected is not appropriate for the plug, replace the socket, rather than using a adaptors or the like as they could cause overh...

8 Water Supply Attach the unicouple to the faucet adapter following the three steps below: 1. Depress the locking collar at the top of the unicouple. 2. Place the unicouple completely over the faucet adapter. 3. Release the locking collar. The unicouple should now be locked onto the faucet adapter. ...

Extension hose Water outlet How to drain excess water from hoses Syphon connection If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly into the sink. It will be necessary to drain excess water from hoses into a bowl or suitable container that is held outsi...

10 USING YOUR DISHWASHER Control Panel Operation (Button) Power Press this button to turn on your dishwasher, the screen lights up. 1 Program Select the appropriate washing program, the selected program indicator will be lit. 2 3 Delay start Press the Delay button to increase the delay start time. D...

11 Display 7 6 Rinse aidindicator If the “ ” indicator is lit, it means the dishwasher is low on dishwasher rinse aid and requires a refill. 5 Cycleindicator Rapid A shorter wash for lightly soiled loads that do not need drying. 90 Min For normally soiled loads that need quick wash. Glass For lightl...

The rinse aid is released during the final rinse to prevent water from forming droplets on your dishes, which can leave spots and streaks. It also improves drying by allowing water to roll off the dishes. Your dishwasher is designed to use liquid rinse aids. WARNING Only use branded rinse aid for di...

3 Close the rinse aid reservoir cap by rotating it clockwise. NOTE : Clean up any spilled rinse aid with an absorbent cloth to avoid excessive foaming during the next wash. 1 2 Remove the rinse aid reservoir cap by rotating it counterclockwise. Carefully pour in the rinse-aid into its dispenser, whi...

3 1 2 Press the release catch on the detergent dispenser to open the cover. Add detergent into the larger cavity (A) for the main wash cycle . For more heavily soiled wash loads, also add some detergent into the smaller cavity (B) for the pre-wash cycle . Close the cover and press on it until it loc...

Adjusting the upper basket The height of the upper basket can be easily adjusted to accommodate taller dishes in either the upper or lower basket.To adjust the height of the upper rack, follow these steps: 4 1 Pull out the upper basket. 2 Remove the upper basket. 3 Re-attach the upper basket to uppe...

Preparing And Loading Dishes Consider buying utensils which are identified as dishwasher-proof.For particular items, select a program with the lowest possible temperature.To prevent damage, do not take glass and cutlery out of the dishwasher immediately after the program has ended. Cutlery with wood...

Loading the upper basket ( ) 8 place setting Loading the lower basket ( ) 8 place setting 18 The upper basket has been designed for small plates, mugs, glasses, and plastic items marked “dishwasher safe”. Load your plates into the dishwasher in two half rows, so that the front of each plate faces th...

WARNING Do not let any item extend through the bottom.Always load sharp utensils with the sharp point down!Be sure nothing protrudes though bottom of the basket or rack to block the lower spray. Loading the cutlery basket The silverware basket can be divided into three separate modules that can be u...

PROGRAMMING THE DISHWASHER Wash Cycle Table The table below shows which programs are best for the levels of food residue on them and how much detergent is needed. It also show various information about the programs. ( )Means: need to fill rinse into the Rinse-Aid Dispenser. Program 21 Glass Heavy EC...

22 Program Running Time(min) Energy (Kwh) Water (L) Description Of Cycle Detergent Pre/Main Rapid Pre-wash(55 ℃ ) Main wash(60 ℃ ) Rinse(55 ℃ ) Rinse(58 ℃ ) Drying 60 0.56 13 0/17.8g 2. Pour in the detergent. 3. Insert the plug into the socket. The power supply refer to last page ”Product fiche”. Ma...

23 Forget To Add A Dish? WARNING It is dangerous to open the door mid-cycle, as hot steam may scald you. A forgotten dish can be added any time before the detergent dispenser opens. If this is the case, follow the instructions below: 1. Open the door a little to stop the dishwasher, after the spray ...

24 MAINTENANCE AND CLEANING External Care The door and the door seal Clean the door seals regularly with a soft damp cloth to remove food deposits.When the dishwasher is being loaded, food and drink residues may drip onto the sides of the dishwasher door. These surfaces are outside the wash cabinet ...

26 Spray arms Wash the arms in soapy and warm water and use a soft brush to clean the jets. Replace them after rinsing them thoroughly. It is necessary to clean the spray arms regularly for hard water chemicals will clog the spray arm jets and bearings. To clean the spray arms, follow the instructio...

27 Caring For The Dishwasher Frost precaution Please take frost protection measures on the dishwasher in winter. Every time after washing cycles, please operate as follows: 1. Cut off the electrical power to the dishwasher at the supply source. 2. Turn off the water supply and disconnect the water i...

28 TROUBLESHOOTING TIPS Before Calling For Service Reviewing the charts on the following pages may save you from calling for service. Problem Possible Causes What To Do Dishwasher doesn't start Fuse blown, or the circuit break tripped. Replace fuse or reset circuit breaker. Remove any other applianc...