Page 3 - Table of Contents; Washer Dimensions
Table of Contents Washer Dimensions ................................................................................ 4 Installation ............................................................................................. 5 Before You Start ..........................................................
Page 4 - Figure 1
Washer Dimensions FLW2298N_SVG A B L K J I H G F E D C Figure 1 A 24.06 in. [611 mm] B 23.19 in. [589 mm] C 40.77 in. [1036 mm] D 43 in. [1092 mm] E 32 in. [813 mm] F 36 in. [914 mm] G * 14.6 in. [371 mm] H 26.875 in. [683 mm] I 2.04 in. [52 mm] J 27.73 in. [704 mm] K (with door closed) 1.59 in. [40...
Page 5 - Figure 2
Installation Before You Start Tools For most installations, the basic tools you will need are: 9/1 6" FLW2376N_SVG 5 6 7 8 4 3 2 1 1. Safety Glasses 2. Wood Block 3. Wrench 4. Screwdriver 5. Pliers 6. Socket Wrench 7. Gloves 8. Level Figure 2 NOTE: If the washer is delivered on a cold day (below...
Page 6 - Connect Fill Hoses; WARNING
FLW2378N_SVG Figure 3 2. Remove two 9/16 inch bolts and washers holding shipping brace to weight. 3. Remove two 9/16 inch bolts and washers holding shipping brace to washer base and remove brace. FLW2296N_SVG1 Figure 4 4. Go to rear of washer and pull label from rear shipping bolts.5. Remove two 9/1...
Page 7 - Water Supply Requirements; Connecting Hoses; Figure; Figure 7; Connect Drain Hose to Drain Recepta-
Water Supply Requirements Water supply faucets must fit standard 3/4 inch [19 mm] femalegarden hose couplings. DO NOT USE SLIP-ON OR CLAMP-ON CONNECTIONS. NOTE: Water supply faucets should be readily accessi-ble to permit turning them off when washer is not beingused. Recommended cold water temperat...
Page 8 - Standpipe Installation; Figure 8; Wall Installation; Figure 9; Laundry Tub Installation; . Use the beaded strap (supplied in accessories
Install the drain hose into the drain receptacle (standpipe, wall orlaundry tub) following the instructions below. IMPORTANT: Drain receptacle must be capable of han-dling a minimum of 1-1/4 inch [32 mm] outside diame-ter drain hose. Drain Flow Rate Drain Height Flow Rate gallons per minute [lit-ers...
Page 9 - Position and Level the Washer; Wipe Out Inside of Wash Drum; Electrical Requirements
Position and Level the Washer WARNING Washers elevated above floor level must be anch-ored to that elevated surface, base or platform. Thematerial used to elevate the washer should also beanchored to the floor to ensure that the washer willnot walk or that the washer can not be physicallypulled, tip...
Page 10 - Earth/Ground Instructions
WARNING To reduce the risk of fire, electric shock, serious in-jury or death, all wiring and protective earth/groundconnections MUST conform with the latest edition ofthe National Electrical Code, ANSI/NFPA No. 70, andsuch local regulations as might apply. It is the cus-tomer’s responsibility to hav...
Page 11 - Check Installation
led and connected to a protective earth/ground in accordance withall local codes and ordinances. WARNING Improper connection of the equipment earth/groundconductor can result in a risk of electric shock.Check with a qualified electrician or service person ifyou are in doubt as to whether the unit is...
Page 12 - Fast Track for Installing the Washer; Refer to the manual for more detailed information
Installer Checklist Fast Track for Installing the Washer 1 Position Washer Near Installation Area. 5 Position and Level theWasher. FLW2299N_SVG1 CHECK CHECK 2 Remove the ShippingMaterials and InstallPlugs. FLW2359N_SVG 6 Wipe Out Inside ofWasher. FLW2303N_SVG CHECK CHECK 3 Connect Fill Hoses. FLW230...