Speed Queen ADGE9RBLACK - Manuals

Page 3 - Read all instructions before using unit.; WARNING

WARNING Risk of fire. Highly flammable material. W881 IMPORTANT: The electrical installation in the site shall comply with the Australian Electrical Standards, AS3000, SAA wiring rules, and such local regulations that might apply. In Australia and New Zealand, installa- tion must comply with the Gas...

Page 5 - Table of Contents; Safety Information

Table of Contents Safety Information ............................................................................. 6 Explanation of Safety Messages ................................................................. 6 Important Safety Instructions .........................................................

Page 6 - Explanation of Safety Messages; DANGER; Important Safety Instructions

Safety Information Explanation of Safety Messages Precautionary statements (“DANGER,” “WARNING,” and “CAU-TION”), followed by specific instructions, are found in this manualand on machine decals. These precautions are intended for the per-sonal safety of the operator, user, servicer, and those maint...

Page 8 - Energy Saving Tips; To reduce the risk of fire, explosion, serious injury or; Sort; Do not wash or dry items soiled with vegetable or

Before Drying Energy Saving Tips • Make sure the lint filter is always clean.• Do not overload the dryer.• Do not overdry items.• Remove items to be ironed while still damp.• Large loads of similar fabrics dry the most efficiently. However, dry permanent press in smaller loads to prevent wrinkling. ...

Page 10 - Control Panel; Idle Mode; Cycles; Manual

Operating Your Dryer WARNING To reduce the risk of fire, electric shock, serious injury or death to persons, read the Safety Information sec- tion before operating the dryer. W520 Control Panel Preset Cycles DRY2577N_SVG Door Open Status Heating Cooling Low Medium AUTO-SENSING MANUAL High No Heat Te...

Page 11 - Selections

digital display. The cycle time can be increased or decreased usingthe up and down arrow keypads. The time and temperature selec-tion may be adjusted manually at any time before or during the cy-cle. Favorite The Favorite cycle keypad allows the user to save different cycles,selections and options f...

Page 12 - To Dry Clothes; Close loading door. Dryer will not operate with the door open.

Cooling The Cooling status light is litduring the cool-down portion ofthe cycle. Extended The Extended status light is litduring the Anti- Wrinkle cycleextension. NOTE: The Heating or Cooling status light flashes (1 second on/1 second off) during the warm-up period. The status light stays lit until ...

Page 13 - Optional Drying Rack

NOTE: You will not be able to press the Start/Pause button to Pause the cycle until the motor is running. If the Start/Pause button is pressed while attempting to run the motor (during the warm-up period), an invalid keypress tone will sound. 6. Select the Cycle and, if desired, change the Selection...

Page 14 - Lubrication; Dryer Interior; Do not obstruct the flow of combustion and ventilation air.; Motor Overload Protector

Maintenance Lubrication All moving parts are sealed in a permanent supply of lubricant orare equipped with oilless bearings. Additional lubrication will not benecessary. Care of Your Dryer WARNING To reduce the risk of an electric shock, serious injury or death, disconnect the electrical service to ...

Page 15 - Lint Filter; CLEAN THE LINT FILTER BEFORE DRYING EACH LOAD.

Lint Filter The lint filter is located at the front of the dryer in the lower part ofthe door opening. CLEAN THE LINT FILTER BEFORE DRYING EACH LOAD. Annually remove lint filter and screw to vacuum the duct under it. DRY2757N_SVG 1 1. Lint Filter Figure 1 IMPORTANT: The lint filter must be in place ...

Page 16 - Dryer Symptom

Troubleshooting Try these troubleshooting tips before making a service call. Theymay save you time and money. Dryer Symptom Possible Cause/Solution Dryer won’t start • Make sure the power cord is plugged all the way into the electri- cal outlet. • Make sure loading door is closed.• Press Start/Pause...

Page 18 - Contact Information; Date Purchased; To reduce the risk of serious injury or death, DO NOT

Contact Information If service is required, contact the nearest Factory AuthorizedService Center. If you are unable to locate an authorized service center or are unsa-tisfied with the service performed on your unit, contact: Alliance Laundry SystemsShepard StreetP.O. Box 990Ripon, Wisconsin 54971-09...