Page 3 - WARNING
WARNING Risk of fire. Highly flammable material. W881 IMPORTANT: The electrical installation in the site shallcomply with the Australian Electrical Standards,AS3000, SAA wiring rules, and such local regulationsthat might apply. In Australia and New Zealand, instal-lation must comply with the Gas Ins...
Page 4 - FOR YOUR SAFETY
WARNING To reduce the risk of severe injury or death, follow allinstallation instructions. Save these instructions. W894 WARNING FOR YOUR SAFETY Do not store or use gasoline or other flammable va-pors and liquids in the vicinity of this or any otherappliance. W053 This product uses FreeRTOS V7.2.0 (...
Page 5 - Table of Contents; Safety Information
Table of Contents Safety Information ................................................................................... 6 Explanation of Safety Messages ..................................................................... 6 Important Safety Instructions ...............................................
Page 6 - Explanation of Safety Messages; DANGER; Important Safety Instructions
Safety Information Explanation of Safety Messages Precautionary statements (“DANGER,” “WARNING,” and “CAU-TION”), followed by specific instructions, are found in this man-ual and on machine decals. These precautions are intendedfor the personal safety of the operator, user, servicer, andthose mainta...
Page 8 - Energy Saving Tips; Sort; Cylinder with wet linens and cottons
Before Drying Energy Saving Tips • Make sure the lint filter is always clean.• Do not overload the dryer.• Do not overdry items.• Remove items to be ironed while still damp.• Large loads of similar fabrics dry the most efficiently. How- ever, dry permanent press in smaller loads to prevent wrin-klin...
Page 9 - Cylinder with wet permanent press items
Cylinder with wet permanent press items D666I_SVG Before Drying © Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT 9 Part No. D516900EN
Page 10 - Rear Control Models; Digital Display; Idle Mode; Cycles
Operating Your Dryer Rear Control Models Front Control Models DRY2791N_SVG WARNING To reduce the risk of fire, electric shock, serious in-jury or death to persons, read the Safety Informationsection before operating the dryer. W520 Digital Display The two-digit display is used to show the time remai...
Page 11 - Manual; Selections; Temp; Options; Signal; Status
ing cycles are Energy Saver cycles that help prevent over-dry-ing. When a wet load is put into the dryer it takes a certain amountof time to reach the desired dryness level. The time will varywith load size, type of fabric, amount of moisture in the load,air flow and the laundry room environment. Th...
Page 12 - Optional Drying Rack
IMPORTANT: Oil affected items can ignite spontane-ously, especially when exposed to heat sourcessuch as in a tumble dryer. The items become warm,causing an oxidation reaction in the oil. Oxidationcreates heat. If the heat cannot escape, the itemscan become hot enough to catch fire. Piling, stack-ing...
Page 14 - Lubrication; Dryer Interior; NOTE: Verify proper operation after servicing.; Motor Overload Protector
Maintenance Lubrication All moving parts are sealed in a permanent supply of lubricantor are equipped with oilless bearings. Additional lubricationwill not be necessary. Care of Your Dryer WARNING To reduce the risk of an electric shock, serious injuryor death, disconnect the electrical service to t...
Page 16 - Dryer Symptom
Troubleshooting Try these troubleshooting tips before making a service call.They may save you time and money. Dryer Symptom Possible Cause/Solution Dryer won’t start • Make sure the power cord is plugged all the way into the electrical outlet. • Make sure loading door is closed.• Press Start/Pause b...
Page 18 - Contact Information
Contact Information If you are unable to locate an authorized service center or areunsatisfied with the service performed on your unit, contact: Shepard StreetP.O. Box 990Ripon, Wisconsin 54971-0990 Date Purchased Model Number Serial Number 1. Serial Plate When contacting us about your washer, PLEAS...