SOUNDSTREAM EXC.6 - Manuals

Page 2 - Component Speaker System; Connectors

1 Component Speaker System INTRODUCTION AND REGISTRATION Congratulations on your purchase of the Soundstream EXC Component SpeakerSystem. You now own one of the finest car audio speaker systems available. As with all high quality car audio components, professional installation is recommended.Your de...

Page 3 - and; EXC Soft Dome Neodymium Tweeter

2 The EXC Component Speaker System is the result of highly focused engineering effort. Each element of the EXC system represents several advances in automotive speaker technology. When the EXC project was initiated, the following goals were established: • High performance sound reproduction in the a...

Page 4 - Try to mount the components on the same plane.; Flush Mounting; ) Secure the cup in the mounting

LOCATION AND MOUNTING 3 The first step in a successful installation is thorough planning. Choose the location for your speaker components carefully. Follow these suggestions to ensure proper imagingand the best performance: • Select a location where each tweeter and midrange/woofer can be mounted cl...

Page 5 - FIGURE

TWEETER SURFACE MOUNTING 4 1) Remove the tweeter's plastic backplate by separating the plate from the tweeter housing with your two thumbnails at one of the terminal locations, gently prying the two pieces until they snap apart. See Figure 3. 2) Mark the location in which you are going to mount the ...

Page 6 - FIGURE 6

INSTALLING THE EXC MIDRANGE- WOOFER 5 The EXC Midrange/Woofer can be mounted on the front or rear of a panel; gaskets are providedfor both options. The bolt-hole configuration will fit a variety of standard OEM patterns making itideal for direct replacement. Best performance is achieved when the spe...

Page 7 - FIGURE 7

MOUNTING THE EXC CROSSOVER 6 The EXC Passive Crossover can be mounted in virtually any location inside the vehicle. Be sure not to mount the EXC system crossover outside the vehicle, or in a locationwhere it may be exposed to dirt or moisture (e.g., the engine compartment, inside awheel housing, ins...

Page 8 - WIRING; EXC System Wiring Diagram

WIRING 7 EXC System Wiring Diagram Figure 8 shows a diagram illustrating the wiring of the EXC Component SpeakerSystem. It is important to make sure that all connections are in phase; that is positive (+) is connected to positive (+), and negative (-) is connected to negative (-), since an out-of-ph...

Page 9 - NOTES ON; about; Figure 9

8 NOTES ON BI-AMPING Bi-Wiring The EXC component system includes theEXC passive crossover which is optimizedfor the speakers. The EXC crossoverallows for dual amp inputs. See Figure 9. This feature allows for a 4 channelamplifier or two 2 channel amplifiers topower the four individual drivers of an ...

Page 11 - SPECIFICATIONS; EXC System Specifications

SPECIFICATIONS EXC System Specifications Frequency Response 70 Hz - 20,000 Hz +/-3dB 60 Hz - 20,000 Hz +/-3dB 50 Hz - 20,000 Hz +/-3dB Sensitivity 90 dB SPL at 1 meter (2.83v) 96 dB SPL at .5 meter (2.83v) 91 dB SPL at 1 meter (2.83v) 97 dB SPL at .5 meter (2.83v) 92 dB SPL at 1 meter (2.83v) 98 dB ...