Sony KV-29FX11K - Manuals

Sony KV-29FX11K – Manual in PDF format online.

Manuals:

Manual

Manual Sony KV-29FX11K

Summary

Page 2 - Input/Output Terminals; Design and specifications are subject to change without notice.

2 KV-29FX11 ITEM MODEL Television System Stereo System Channel Coverage Color System Italian B/G/H GERMAN Stereo ITALIA VHF : A-H2 (C) UHF : 21-69 PALB/G/H VHF : E2-E12 UHF : E21-E69CABLE TV (1) : S1-S41CABLE TV (2) : S01-S05, M1-M10, U1-U10 PAL, SECAMNTSC4.43, NTSC3.58(VIDEO IN) French B/G/H, D/K, ...

Page 3 - WARNING

3 KV-29FX11 Model Name Item KV-29FX11A KV-29FX11B KV-29FX11D KV-29FX11E KV-29FX11K KV-29FX11R KV-29XF11U Pal Comb OFF OFF OFF OFF OFF OFF OFF PIP OFF OFF OFF OFF OFF OFF OFF Woofer Box OFF OFF OFF OFF OFF OFF OFF Scart 1 ON ON ON ON ON ON ON Scart 2 ON ON ON ON ON ON ON Front in (3) ON ON ON ON ON O...

Page 5 - TABLE OF CONTENTS; CAUTION; CIRCUIT ADJUSTMENTS

5 KV-29FX11 TABLE OF CONTENTS CAUTION SHORT CIRCUIT THE ANODE OF THE PICTURE TUBE AND THEANODE CAP TO THE METAL CHASSIS, CRT SHIELD, OR THECARBON PAINTED ON THE CRT, AFTER REMOVAL OF THEANODE CAP WARNING !! AN ISOLATING TRANSFORMER SHOULD BE USED DURING ANYSERVICE WORK TO AVOID POSSIBLE SHOCK HAZARD...

Page 20 - Rear Cover

20 KV-2 9FX11 SECTION 2 DISASSEMBLY 4 Rear Cover 1 1 Screw 4x10 2-1. REAR COVER REMOVAL 2-2. CHASSIS ASSY REMOVAL 2-3-2. SERVICE POSITION (2) 2-3-1. SERVICE POSITION (1) 2 6 Screws (BTVTP 4x16) 2 Insert into heatsink Clip bracket into Beznet 1 Snap off from main bracket 3 2 Screws (BTVTP 4x16)

Page 22 - • REMOVAL OF ANODE-CAP; HOW TO HANDLE THE ANODE-CAP

22 KV-2 9FX11 Cushion 8 Degaussing coils 9 Spring Extension 6 Chassis assy 1 Two screws 2 Speaker 15 Picture tube 2-7. PICTURE TUBE REMOVAL Anode button a * REMOVING PROCEDURES. Turn up one side of the rubber cap inthe direction indicated by the arrow a 1 2 Using a thumb pull up the rubber cap firml...

Page 23 - Identify the plate by locating its marking.; MAIN BRACKET

23 KV- 2 9 F X11 REMOVAL AND REPLACEMENT OF THE MAIN-BRACKETBOTTOM PLATES. (1) REMOVING THE PLATES In the event of servicing being required to the solder side of the D Board printedcircuit, the bottom plates fitted to the main chassis bracket require to be removed.This is performed by cutting the ga...

Page 24 - SECTION 3

24 • When complete readjustment is necessary or a new picture tube is installed, carry out the following adjustments. • Unless there are specific instructions to the contrary,carry out these adjustments with the rated power supply. • Unless there are specific instructions to the contrary, set the co...

Page 25 - Minimize the Brightness setting.; Horizontal and vertical static convergence

25 KV-29FX11 Center dot R G B H.STAT V.STAT Magnet R G B RV702Screen C Board RV701H Stat 3-2. CONVERGENCE Preparation: • Before starting this adjustment, adjust the focus, horizontalsize and vertical size. • Minimize the Brightness setting. • Input a dot pattern from the pattern generator. (1) Horiz...

Page 26 - Purity; R G; Dynamic convergence adjustment.; Remove the deflection yolk spacer.

26 KV-29FX11 BMC (Hexapole) V.STAT Purity R G B R G B R G B R G B R G B R G B R G B B G R R G B B G R B G R R G B R G B B G R Tilt Direction • Operation of the BMC (Hexapole) magnet. • The respective dot position resulting from moving each magnet interact, so be sure to perform adjustment whilsttrac...

Page 27 - Focus; Screen corner convergence.

27 KV-29FX11 a-d: screen-cornerconvergence defect a b c d c a d b Install the permalloy assemblyfor the area that needs correcting. Permalloy. Focus (3) Screen corner convergence. • If you are unable to adjust the corner convergence properly, correct them with the use of permalloy assemblies. 3-3. W...

Page 28 - HOW TO ENTER INTO SERVICE MODE; Press the + button to enter the selected adjustment.

28 KV-29FX11 SECTION 4 CIRCUIT ADJUSTMENTS 5 + + (ON SCREEN DISPLAY) (DIGIT 5) (VOLUME + ) (TV) 4-1. ELECTRICAL ADJUSTMENTS Service adjustments to this model can be performedusing the supplied Remote Commander RM-886. HOW TO ENTER INTO SERVICE MODE 1. Turn on the main power switch and enter into the...

Page 29 - Same Level; SUB BRIGHTNESS ADJUSTMENT

29 KV-29FX11 Same Level B-Out Waveform SUB BRIGHTNESS ADJUSTMENT 1. Input a Phillips pattern. 2. Set the picture control to minimum. 3. Enter into the ‘Picture Adjustment’ service menu. 4. Adjust the ‘Sub-Brightness’ data so that there is barely a difference between the 0 IRE and 10 IRE signal level...

Page 30 - SYSTEM L BAND 1 I.F ADJUSTMENT; Enter into the service mode and select ‘Current TV status’.; TUNER AGC ADJUSTMENT; Enter into the ‘Geometry Adjustment’ service menu.

30 KV-29FX11 A TUNER / IF RV01RV02 LV01 TP1 V SIZE V LIN S CORRECTION V CENTRE H SHIFT H SIZE PIN AMP TILT CORNER PIN V ANGLE SYSTEM B/G, D/K, I & L I.F ADJUSTMENT 1. Input an off air signal of between 60-100dBuV / 75 ohm terminated, via the tuner socket. 2. Enter into the ‘IF Adjustment’ servic...

Page 34 - DY ASSY; SECTION 5

35 36 37 38 39 D ( ) HV OUT, PIN OUTPOWER SUPPLYSIRCS RECEIVE INDICATORAUDIO INY-CHROMA INHEADPHONE AMP D618 PROJECT 3 5 6 7 48 46 45 43 42 9 12 26 25 24 28 23 39 13 38 15 35 32 20 31 21 22 TO C BOARD CN703 ROT COIL V OUT - E/W V OUT + H DRIVE V SYNC HFBP EHT ABL DGC RELAY PROT AFC SIRCS SPKRL STBY ...

Page 41 - IC BLOCK DIAGRAMS; DFP

67 68 IC BLOCK DIAGRAMS 56 48 ACC DET KILLER DET V SYNC SEP GATE 1/32 50/60 ID GATE SAND CASTLE H.DRIVE WIDE Sawtooth Gen. INTER- LACE APC PAL/ NTSC fsc ID I REF HUE CLP CLP ABL HV COMP AKB 51 50 49 54 52 45 46 47 40 41 39 36 44 42 10 35 30 34 32 31 33 27 25 23 28 29 19 18 17 16 15 12 11 1 64 61 62 ...

Page 44 - REF. NO. PART.NO DESCRIPTION REMARK

71 KV-29FX11 SECTION 6 EXPLODED VIEWS REF. NO. PART.NO DESCRIPTION REMARK REF. NO. PART.NO DESCRIPTION REMARK • Items with no part number and no description are not stocked because they are seldom required for routine service. • The construction parts of an assembled part are indi-cated with a colla...

Page 46 - SECTION 7; RESISTORS

73 KV-29FX11 REF. NO. PART.NO DESCRIPTION REMARK REF. NO. PART.NO DESCRIPTION REMARK SECTION 7 ELECTRICAL PARTS LIST • Items marked “ * “ are not stocked since they are seldom required for routine serv-ice. Some delay should be anticipated when ordering these items. •• All variable and adjustable re...

Page 52 - IF

79 KV-29FX11 REF. NO. PART.NO DESCRIPTION REMARK REF. NO. PART.NO DESCRIPTION REMARK The components identified byshading and marked are criticalfor safetyReplace only with the part numberspecified. R1027 1-216-025-00 RES,CHIP 100 5% 1/10W R1028 1-216-025-00 RES,CHIP 100 5% 1/10W < TUNER > TU10...

Page 61 - VM

88 KV-29FX11 REF. NO. PART.NO DESCRIPTION REMARK REF. NO. PART.NO DESCRIPTION REMARK The components identified byshading and marked are criticalfor safetyReplace only with the part numberspecified. D VM < RELAY > RY600 £ 1-755-018-11 RELAY < SWITCH > S601 £ 1-571-433-21 SWITCH, PUSH (AC ...

Page 64 - Sony Corporation; Sony UK