Page 2 - English; Trademarks; Owner’s Record; This label is located on the drive unit’s internal chassis.; Safety Regulations; WA R N I N G; This label is located on the bottom of the drive unit enclosure.
This unit uses CD-R discs and CD-RW discs with the following mark. This unit uses CD-ROM discs with the following mark. When you use this unit as a CD player, use compact discs with the following mark. You are cautioned that any changes or modifications not expressly approved in this manualcould voi...
Page 3 - Introduction; Features; General; Integrated buffer memory.; Supported formats and modes; Outputs 16-bit digital audio data over SCSI interface.; Contents
Introduction Features This CD-R/RW drive has the following features: General ● 5 1/4 inch half-height drive form factor. ● Fast SCSI bus interface embedded (based on SCSI-2). ● Integrated buffer memory. ● Power tray loading and ejection (manual eject too). ● Housed in an airtight frame casing. Suppo...
Page 4 - Precautions; Installation; Do not move drive during operation, it may cause an error.; Transportation; Hardware Installation; Installing the Drive Unit into the Computer; Front Panel; SCSI bus interface connector
Precautions ■ Installation ● Avoid placing the drive in a location subject to:– high humidity– high temperature– excessive dust– mechanical vibration– direct sunlight. Only horizontal drive operation recommended, not vertical or tilted. ■ Operation ● Do not move drive during operation, it may cause ...
Page 5 - SCSI ID selection; Step 1: Opening the Computer
Step 3: Finding the Connector The SCSI cable should have 1 or more unused connectors on the endopposite the adapter, as shown, find a connector not in use. We recommend a connector at the very end of the 50 pin SCSI cable. Note:If no free 50 pin SCSI connector exists, see “Troubleshooting”, page 18....
Page 6 - Step 5: Setting the Jumpers
The following table shows the function of each jumper. Notes: ● The upper row of pins is (without position KEY) is ground. ● Remove jumper to set OFF, install jumper to set ON. ● ID SELECT, ACTIVE TERM, and TEST MODE are recognized whenthe power supply is turned on or the SCSI bus is reset. ● TEST m...
Page 7 - Step 6: Connecting the Drive; Attach flat SCSI cable to connector at rear of CD-RW drive.
Step 7: Mounting the Drive Insert the CD-RW drive into computer front as shown, routing cablesaccordingly. Secure drive to frame with appropriate screws. Note:Slide rails (not included) may be necessary if you cannot secure CD-RWdrive. Refer to your computer’s User’s Guide for more information. Step...
Page 8 - Storing Discs; Step 9: Installation Review; Notes; Step 10: Closing the Computer
Software Installation Please refer to CD-RW formatting software/CD manual for instruction onsoftware installation. CD-RW formatting software must first be properlyinstalled in order to write CD’s with this device. Using Discs Storing Discs ● Do not store the disc in a location subject to:– high humi...
Page 9 - Opening the drawer (tray) manually in an emergency; Turn off the computer and remove power cable.; Operating the Drive; Starting Up; Turn on the computer.
As the drive begins reading the Table of Contents (TOC) data, the busyindicator lights and remains illuminated until read is completed.When the busy indicator switches off, the drive is ready to receivecommands, data may be retrieved from the disc. After loading a disc,it takes a moment for the driv...
Page 10 - Technical Support; Troubleshooting; Should problems occur while installing or operating the drive:; Checklist; Please verify the following:; Both ends of SCSI cable are properly attached, check pin 1 position.; Additional Installation Cases; No free SCSI connector present
Technical Support If you require further support or service please contact your local Sonytechnical support professionals. For Europe (German or English) contact the hotline at: Tel.: +49 (0) 2389 - 951047 or [email protected](Monday – Thursday, 8:00 am – 4:30 pm / Friday, 8:30 am – 2:00 pm) F...
Page 11 - Specifications
Specifications ■ General Host interface SCSI-2, single ended, 50 pin ■ Audio Line out: 0.7 V at 47 k Ω Headphone: 0.55 V at 32 Ω ■ Environmental conditions Relative humidity 10% to 90% (no condensation) Climate gradient 10°C/hour, 10% humidity/hour Temperatures Operating 5°C to 45°C (41°F to 113°F) ...