Sonance 93542 - Manuals - manualsarea.com

Page 4 - DSP 2-150 MKIII FRONT PANEL; Front Panel

4 Figure 2: DSP 2-150 MKIII Two-Channel Power Amplifier Rear Panel DSP 2-150 MKIII FRONT PANEL Figure 1: DSP 2-150 MKIII Two-Channel Power Amplifier Front Panel 1 2 3 Front Panel 1. Illuminated Power Button 2. Power, Active, and Protection Indicator LED 3. Recessed Volume Level Control 5 10 8 4 7 9 ...

Page 7 - AMPLIFIER CHANNEL PROTECTION; AMPLIFIER POWER SUPPLY PROTECTION

7 Figure 9: Volume Level Control VOLUME LEVEL CONTROL Volume can be controlled from SonARC or from individual recessed volume controls on the front panel (see Figure 9). These volume controls balance the desired sound levels per channel. Volume can be controlled three different ways with SonARC V2 (...

Page 8 - SETUP OPTIONS

8 RACK EAR INSTALLATION Accessory Rack Ears are included with the DSP 2-150 MKIII when the amplifier is to be used alone in a 1U space. Unscrew the four Phillips head screws (M4 x 0.7 pitch x 10mm long) found on each side of the left and right forward section of amplifier. Use these screws to connec...

Page 10 - PASSWORD PROTECTION; NOTE: RESETTING THE NETWORK SETTINGS OR; REAR EQ SELECT

10 IP ADDRESS The second setting in the IP Setup section is the IP address. When DHCP is ON, the current IP address will be displayed. To change the IP address set the DHCP to OFF. When DHCP is turned off the IP address that the router assigned to the amplifier continues to be applied. This IP addre...

Page 11 - NOTE: WHEN AUDIO GREEN MODE IS ENABLED AND; PRINT

11 VOLTAGE Amplifier will power off immediately when the trigger voltage has been removed. When a 3-12V DC voltage or DC voltage is sent to the amplifier, it will take six to eight seconds for the amplifier to reproduce audio after going through its power up sequence. VOLTAGE GREEN Amplifier will po...

Page 12 - OUTPUT VOLUME; NOTE: FRONT PANEL VOLUME CONTROLS OVERWRITE; INPUT SETUP

12 SOURCE 2 Secondary source that based on the mode Source 2 setting described below, will either override or mix with Source 1. This input could be used for a doorbell or paging for example. MODE SOURCE 2 OFF When set to OFF, Source 2 has no effect on the operation of the channel. MIX Input levels ...

Page 15 - DSP 2-150 MKIII SPECIFICATIONS

15 DSP 2-150 MKIII SPECIFICATIONS Number of Channels 2 (1 stereo pair) Power Output - 8 ohms (Stereo) 150 watts RMS per channel (all channels driven) Power Output - 4 ohms (Stereo) 224 watts RMS per channel (all channels driven) Power Output - 8 ohms (Bridged) 473 watts Frequency Response 5Hz – 50kH...

Sonance 93542 - Manuals

Manuals:

User Manual Sonance 93542

Summary

Sonance Amplifiers Manuals