Page 2 - TABLE OF CONTENTS
TABLE OF CONTENTS Safety 2 Introduction/Box Contents 3 Front Panel/Rear Panel 4 Amplifier Power Requirements 6 Connections & Volume Level Controls 7 Protection Circuitry & LEDs/Stacking 8Network Connection Instructions 9 Basic Setup 9 Advanced Setup 10 Specifications 15 Appendix A & B 16...
Page 3 - IMPORTANT SAFETY INFORMATION; IMPORTANT: READ ALL OF THESE INSTRUCTIONS BEFORE YOU; I m p o r t a n t S a f e t y I n f o r m a t i o n
IMPORTANT SAFETY INFORMATION 1. Read Instructions — All these safety and operating instructions should be read before you operate the unit. 2. Retain Instructions — These safety and operating instructions should be retained for future reference. 3. Heed Warnings — All warnings on the unit and in the...
Page 5 - SONANCE DIGITAL INPUT MODULE (SKU 93099 SOLD SEPARATELY) FOR
Figure 3: Sonamp DSP 2-750 MKII Multi-Channel Power Amplifier Rear Panel 4 DSP 2-750 MKII Front Panel 1. Illuminated Power Button2. Power, Active & Protection Indicator LED3. Recessed Volume Level Control Figure 2: Sonamp DSP 2-750 MKII Multi-Channel Power Amplifier Front Panel 1 2 3 DSP 2-750 M...
Page 7 - IN; LEVEL; EF
Model Input Voltage Output Power (sinewave) Draw Watts 15 Amp Breaker Qty of Amplifiers 20 Amp Breaker Qty of Amplifiers DSP 2-750 MKII 100-120V AC Full Power All Channels @8 ohms 1280 1 1 Full Power All Channels @4 ohms 1780 1 1 1/8 Power All Channels @8 ohms 212 6 9 1/8 Power All Channels @4 ohms ...
Page 8 - Bridging Channels DSP 2-750 MKII; Speaker Connections
Sona nce DSP2 -7 5 0 MKII A mplifierRea r Pa nel 4 / 2 / 2 0 1 8 Die Line Do N ot Print Prints W hite 1L 1R DSP 2-750 MKII 1-R 1-L 2-R 2-L IN IN OUT OUT DSP 2-750 MKII S/N 1 - RIGHT 1 - LEFT + + _ _ + _ BRIDGE 4 Ω MIN + + _ _ VOLTAGE TRIGGER 3-30 volts AC/DC IN OUT IN OUT IR CONTROL IR STATUS TCP/IP...
Page 9 - Protection Circuitry and LEDs; Amplifier Channel Protection DSP 2-750 MKII; Rack Ear Installation DSP 2-750 MKII; Amplifier Power Supply Protection DSP 2-750 MKII
8 IMPORTANT: ALLOWING THE AMPLIFIER TO OPERATE WITH ONE OR MORE CHANNELS IN PROTECT MODE FOR AN EXTENDED PERIOD OF TIME CAN DAMAGE THE AMPLIFIER. Protection Circuitry and LEDs The Sonamp amplifiers have a multi-stage protection system to prevent damage to your amplifier and speakers. Amplifier Chann...
Page 11 - NOTE: LEFT AND RIGHT CHANNELS ARE LINKED. OUTPUT VOLUME IS; Identify Amplifier; ID Amp Mode; General Settings Tab; Output Name
10 Advanced Setup Page This page in SonARC allows you to make advanced changes to the your amplifiers settings and configuration. To start click on the Advanced Setup button from your MKII’s homepage. IP Setup DHCP On/Off DHCP ON/OFF is the first option in IP SETUP. All Sonance DSP series amplifiers...
Page 13 - NOTE: FRONT PANEL VOLUME CONTROLS OVERWRITE THIS SETTING.; EQ Setting Tab
12 In/Out Settings Tab The IN/OUT settings tab is used to assign your MKII’s input and output specifications. Input Setup Input Name This is a user entered field with a maximum of 15 characters. Use these fields to describe the type of input connected. Input Trim dB This pull down menu allows for in...
Page 16 - Specifications
15 Specifications SONAMP DSP 2-750 MKII Number of Channels 2 (1 stereo pair) Power Output - 8 ohms (Stereo) 500 Watts RMS per channel (all channels driven) Power Output - 4 ohms (Stereo) 750 Watts RMS per channel (all channels driven) Power Output - 8 ohms (Bridged) 2000 Watts Frequency Response 5Hz...
Page 18 - Out of the Box Troubleshooting; No Power; speaker location are not securely connected.; No IP Control
17 Out of the Box Troubleshooting No Power Front panel Power LED does not illuminate when AC cord is plugged into an outlet and the amp is switched on. Cause:AC cable is improperly seated either at the back of the amp or at the AC outlet. Solutions: • Verify that both ends of the power cable are sec...
Page 19 - amp channel is loose, disconnected or faulty.; Protection LEDs are Illuminated
Factory Reset Perform a factory reset procedure on the DSP amp using a small flat head jewelers screwdriver. Solutions: • With the amp powered OFF, carefully rotate the front panel accessed 1L volume control fully-counterclockwise and rotate the 1R volume control to fully-clockwise. • Press the powe...
Page 20 - EXCLUSIONS; SPECIFICALLY EXCLUDED.
©2018 Sonance. All rights reserved. Sonance is a registered trademarks of Dana Innovations. Due to continuous product improvement, all features and specifications are subject to change without notice. For the latest Sonance product specification information visit our website: www.sonance.com SONANCE...
