Page 2 - I N S T R U C T I O N M A N U A L; Important Safety Information; Read and retain instructions:
SONAMP ® 2-100 & SONAMP ® 12-50 MULTI-CHANNEL POWER AMPLIFIERS I N S T R U C T I O N M A N U A L Important Safety Information You should always follow these basic safety precautions when using your Sonamp 2-100 or Sonamp 12-50, to reduce the risk of fire, electric shock, and injury to persons: 1...
Page 3 - I N S T R U C T I O N S I M P O R T A N T E S C O N C E R N A N T L A S É C U R I T É; RISQUE D’ÉLECTRISATION; ATTENTION; ATTENTION; ATTENTION: POUR RÉDUIRE TOUT RISQUE D’ÉLECTROCUTION,; ATTENTION; RISQUE D’ÉLECTRISATION; ATTENTION; ATTENTION: POUR RÉDUIRE TOUT RISQUE D’ÉLECTROCUTION,
2 I N S T R U C T I O N S I M P O R T A N T E S C O N C E R N A N T L A S É C U R I T É 1. Lisez soigneusement ces instructions. 2. Conservez-les en lieu sûr pour toute référence future. 3. Respectez scrupuleusement tous les avertissements de sécurité. 4. Suivez toutes les instructions indiquées. 5....
Page 5 - Indicator LED
4 SONAMP 2-100 & 12-50 MULTI-CHANNEL POWER AMPLIFIER INSTRUCTION MANUAL 1L 1R 2-100 1L 1R 12-50 2L 2R 3L 3R 4L 4R 5L 5R 6L 6R LEVEL LEVEL BRIDGE OFF ON MONO STEREO 12-50 S/N VOLTAGE TRIGGER IN OUT AUTO ON O FF IN OUT IN OUT 1-LEFT 1-RIGHT LEVEL LEVEL BRIDGE OFF ON MONO STEREO LEVEL LEVEL BRIDGE ...
Page 6 - Front Panel; The power switch turns the amplifier on and off.; Rear Panel
5 Front Panel Power Switch The power switch turns the amplifier on and off. When the Sonance logo on the power switch is lit solid white, the amplifier has power and is turned ON and ready to operate. When the Sonance logo is slightly dimmed the amplifier is in standby mode. When the Sonance logo on...
Page 7 - Powering the Amplifier; LOCAL Line In Connectors; Amplifiers Power Requirements:
6 Powering the Amplifier The Sonamp 2-100 & 12-50 features a removable IEC power connector (Figure 7). A 14-gauge EIA standard 120-volt grounded power cable is included with the amplifier. Due to the amplifier’s power requirement, Sonance recommends that this cable not be replaced with another o...
Page 8 - Speaker Connections; VOLTAGE; Volume Level Controls; The volume controls are set at 50%; IMPORTANT: USE CAUTION WHEN SETTING VOLUME LEVELS
7 Speaker Connections Bridging Channels 2-100 & 12-50 Trigger Mode Control 2-100 & 12-50 You can set the Sonamp amplifiers so that they will automatically turn ON when it receives an audio signal, when it receives a control voltage from an external source, or to remain on and not enter stand...
Page 10 - SPECIFICATIONS
9 SPECIFICATIONS SONAMP 2-100 Number of Channels 2 (1 stereo pair) Power Output - 8 ohms (Stereo) 100 Watts RMS per channel (all channels driven) Power Output - 4 ohms (Stereo) 156 Watts RMS per channel (all channels driven) Power Output - 8 ohms (Bridged) 325 Watts Frequency Response 5Hz – 50kHz, b...
