Page 2 - NOTES
2 WARRANTY TABLE OF CONTENTS PACKAGE CONTENTS Package Contents .............................................2 Warranty ...........................................................2 Safety Instructions ............................................3 Electrical Requirements .................................
Page 3 - Do not block the inlet or outlet. It may
18 _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _____________________________________________________________________ _________________...
Page 4 - ELECTRICAL REQUIREMENTS; INSTALLING YOUR DEHUMIDIFIER; WARNING; PRODUCT SPECIFICATIONS
4 ELECTRICAL REQUIREMENTS OBSERVE ALL LOCAL CODES AND ORDI- NANCES. DO NOT, UNDER ANY CIRCUMSTANCES, REMOVE THE POWER SUPPLY CORD GROUND PRONG. ELECTRICAL GROUND IS REQUIRED ON THIS APPLIANCE A 115-VOLT 60Hz, AC ONLY, 15A FUSED AND PROPERLY GROUNDED ELECTRICAL SUPPLY IS REQUIRED. A time delay fuse o...
Page 5 - Error Code; ERROR CODES
16 TROUBLESHOOTING PRODUCT SPECIFICATIONS ITEM # SG-DEH-70EP-2 Moisture Removal per 24 hours 70 Pints per day (32.9 Liters per day) Power Consumption (W) 745 Watts Bucket Capacity 17 Pints (8 Liters) Power Source 115 V / 60 HZ Rated Current (Amps) 7.3A Sound Pressure Level dB (L/M/H) 45/47/49 dB(A) ...
Page 6 - CONTROL PANEL; Water does not
6 CONTROL PANEL (1) (2) (3) (12) (13) (10) (11) (6) (8) (7) (5) (4) (9) POWER ON/OFF (1) Once the unit is plugged in, the POWER INDICA-TOR (10) will light. Pressing the POWER button once will turn the unit ON and illuminate the digi-tal display (9). The fan will operate for 3 minutes to draw air thr...
Page 7 - TROUBLESHOOTING; DO NOT REMOVE THE STYROFOAM IN THE BUCKET; properly. Do not remove the Styrofoam from the float.
14 Problem Possible Causes Solutions Dehumidifier does not start. The dehumidifier is un-plugged. Make sure the dehumidifier’s plug is pushed com-pletely into the outlet. The fuse is blown / circuit breaker is tripped. Check the house fuse / circuit breaker box and replace fuse or reset breaker. Deh...
Page 8 - Option 2: GRAVITY DRAIN HOSE
8 Step Open the drain connector door. (Fig. 6) Step Install and secure the drainage joint onto the drain connector. (Fig. 7) INSTALLING THE GRAVITY DRAIN HOSE (FIG. 6) (FIG. 7) Step Place large hose clamp on the flat end of the dehumidifier drain ho se. (Fig. 8) (FIG. 8) 13 CARE AND MAINTENANCE WARN...
Page 9 - USING THE PUMP; INSTALLING THE GRAVITY DRAIN HOSE
12 1. Remove flat end of the hose by squeezing the large clamp and pulling it to- ward you. 2. Remove hose from drainage joint and cut hose to appropriate length. 3. Once cut is completed, refer to installing the Drain Hose to re-install dehu- midifier drain hose. USING THE DRAIN PUMP 1. Plug into g...
Page 10 - pump to a wall or other perpendicular flat surface with the; INSTALLING THE EXTERNAL PUMP
10 INSTALLING THE EXTERNAL PUMP Step 2: For optimal operation, it is recommended that the pump is placed on a flat and level location. Attach the water pump to a wall or other perpendicular flat surface with the included screws for security. (Fig. 12) Step 3: Remove red cap from drain hose connector...