Page 3 - SPECIFICATIONS; temperature, the air conditioner may not work properly.; PACKAGE CONTENTS; Portable Air Conditioner
3 SPECIFICATIONS • The cooling capacity is measured at an ambient temperature of DB 86 °F, WB 78 °F. • Noise level is measured at a distance of 3.28 ft away from the front of the unit, when the unit is in cooling mode. • Power consumption is measured when the fan runs at the highest speed setting. •...
Page 4 - POWER CORD AND PLUG; WARNING
POWER CORD AND PLUG 4 WARNING This unit has a grounded three pronged plug intended to fit into a three slot outlet. (A) An adapter is available for connecting three pronged plugs into two slot outlets. (B) When doing so, the green ground- ing tab extending from the adapter must be fastened under the...
Page 5 - PRODUCT DIAGRAM
PRODUCT DIAGRAM Control Panel 5 Louvers Louver Guides Casters Power Cord Filters Upper Air Intake Lower Air Intake Remote Control Holder Air Exhaust Vent
Page 6 - PARTS & WINDOW KIT ASSEMBLY; PARTS; INSTALLATION; Extend both ends of the exhaust hose approximately 6 inches.
PARTS & WINDOW KIT ASSEMBLY PARTS EXHAUST HOSE & ADAPTERS ASSEMBLY & INSTALLATION INSTALLATION When the unit is operating as an air conditioner or dehumidifier, the window kit and exhaust hose must be installed. When the unit is operating in fan mode, the window kit and exhaust hose do n...
Page 7 - SINGLE HOSE WINDOW KIT INSTALLATION
7 SINGLE HOSE WINDOW KIT INSTALLATION When installing the exhaust hose, try and keep it as flat as possible. The less angles and bends in the hose, the better the unit will perform. If bending or an angle is necessary, use single 90 ° angles like the pictures above. Multiple bends will decrease perf...
Page 9 - REMOTE CONTROL OPERATING INSTRUCTIONS
9 1) Power On and Off - Press the ON/OFF (POWER) button once to manually turn the unit on. Press the Power button once more to turn the unit off. When you manually power the unit on and off by pressing the ON/OFF button, the preset timer will be cancelled. 2) Mode Selection - Press the MODE Button r...
Page 10 - Remove batteries when remote not in use for a long time.
5) Auto-on Timer: When the air conditioner is off, it can be set to automatically turn on in 30 minutes to 24 hours at the previous set mode and fan setting. To set the Auto-on Timer, press the TIMER button on the unit or remote control. Each touch of the +/- buttons on the remote will change the ti...
Page 11 - DRAINING COLLECTED WATER
11 When the temperature or humidity is too high, the air conditioner may not be able to evaporate all of the water as quickly as needed. All moisture that is unable to be evaporated is placed in a small bank up water tank in-side the unit. When this tank is completely full, an alarm will sound, the ...
Page 12 - MAINTENANCE; and dry it thoroughly out of sunlight.; DISCLAIMER
MAINTENANCE Note: Make sure power is off and the power cord is not plugged into an electrical outlet prior to performing any maintenance on the unit. Clean or replace filter - If the air filter is blocked with a dust, the airflow volume may reduce. It is recommended to clean the filter once every tw...
Page 13 - TROUBLESHOOTING; The Remote Control is not working
PROBLEM The Air Conditioner will not start POSSIBLE CAUSES The air conditioner is unplugged or not connected well. The fuse is blown/circuit breaker is tripped. Power Failure The current interrupter device is tripped. SOLUTIONS • Make sure the air conditioner plug is pushed completely into the out- ...
Page 14 - The LCD Display is showing “H8”
PROBLEM The LCD Display is showing “E5” POSSIBLE CAUSES Low Voltage Protection SOLUTIONS • Unplug for 10 minutes and then turn on the unit. If “E5” is still dis- played, contact customer service. TROUBLESHOOTING (CONT.) The LCD Display is showing “H8” The backup water tank is full • Drain the water ...
Page 15 - WARRANTY; One Year Limited Warranty
WARRANTY One Year Limited Warranty Soleus International Inc. warrants the accompanying Soleus Air Powered by Gree Portable Air Conditioner to be free of defects in material and workmanship for the applications specified in its operation instruction for a period of ONE (1) year from the date of origi...