Snapper E281318BE, E331518KVE - Manuals

5 Section 1 - FAMILIARIZATION FIGURE 1.1 1.1 INTRODUCTION This manual has been prepared for the operator’s of the SNAPPER Rear Engine Rider. Its purpose, aside from recommending standard operating procedures and routine service requirements, is to promote SAFETY through the use of accepted operating...

6 Section 1 – FAMILIARIZATION – DECALS / SYMBOLS SERIAL NUMBER DECAL 01015 WARNING DECAL 22841 EUROPEAN NOISE CONTROL DECAL 23009 FUEL CAUTION DECAL - 29113 PATENT NUMBERS DECAL - 2-9470 EUROPEAN COMMUNITY DECAL 29776 CHUTE WARNING DECAL 29784 BATTERY STORAGE DECAL - 29948 DEFLECTOR CAUTION DECAL 29...

8 Section 2 - OPERATING INSTRUCTIONS 2.1 PRE-START CHECK LIST Make the following checks and perform the service required before each start-up. 2.1.1. Check tires and add or release air as needed to bring pressure to 12 psi in front and 12 psi in rear tires. 2.1.2. Check guards, deflectors and covers...

9 Section 2 - OPERATING INSTRUCTIONS 2.3 STARTING & OPERATION 2.3.1. ENGINE (ELECTRIC START) IMPORTANT: When the ignition key is turned to “START”, the engine will turn over, but will not start unless the Clutch/Brake pedal is pressed all the way down, the Blade Lever is in the “Off” position (S...

14 Section 3 - MAINTENANCE WARNING DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. STOP engine. STOP blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid serious burns,...

18 SECTION 3 – MAINTENANCE 3.4 SERVICE - ANNUALLY 3.4.1. Perform all maintenance as specified in “MAINTENANCE SCHEDULE” Section of this manual. 3.4.2. FUEL FILTER Service fuel filter as instructed below, on COLD ENGINE ONLY! IMPORTANT: To stop flow of fuel, tank may be removed from bracket and set o...

27 Section 4 - ADJUSTMENTS & REPAIR 4.6.6. BATTERY TESTING Battery Condition Chart State of Charge Syringe Hydrometer Digital Voltmeter Five Ball Hydrometer 100% Charged w/ Sulfate Stop 1.280 12.80v Five Balls Floating 100% Charged 1.265 12.60v Four Balls Floating 75% Charged 1.210 12.40v Three ...

28 TROUBLESHOOTING PROBLEM PROBABLE CAUSE CORRECTIVE ACTION Engine Will Not 1. Fuel tank empty. 1. Fill fuel tank with fresh fuel to proper level. Start Using 2. Engine needs choking. 2. Move choke control to “CHOKE” position. Recoil Starter 3. Spark plug wire disconnected. 3. Place spark plug wire ...

30 MAINTENANCE SCHEDULE SUBJECT SERVICE TO BE PERFORMED REFERENCE PAGES EACH USE 5 HOURS 25 HOURS 50 HOURS 100 HOURS EACH SEASON Engine Check Oil Level Page 8 X Engine Initial Oil Change Page 14 X Engine Periodic Oil Change Page 14 X* Air Pre-Cleaner Service Sponge Pre-Cleaner Element Engine Manual ...

31 MAINTENANCE/REPLACEMENT PARTS MAINTENANCE PARTS Engine Speed Control (Briggs Engine) 2-4155 Engine Speed Control (Kohler Engine) 2-2483 Clutch/Brake Cable 2-9913 Brake Cable 2-2344 28” Cutter Blade (Standard - Not Air Lift Compatible) 3-5635 28” Cutter Blade (Standard - Air Lift Compatible) 1-951...

32 3 YEAR LIMITED WARRANTY For three (3) years from purchase date for the original purchaser's residential, non-commercial use, SNAPPER, through any authorized SNAPPER dealer will replace, free of charge (except for taxes where applicable), any part or parts found upon examination by the factory at ...

33 SERVICE NOTES ______________________________________________________________________________ ______________________________________________________________________________ ______________________________________________________________________________ ______________________________________________...

36 Safety Instructions & Operator’s Manual for EUROPEAN REAR ENGINE RIDING MOWER SERIES 18 IMPORTANT Snapper products are built using engines that meet or exceed all applicable emissions requirements on the date manufactured. The labels on those engines contain very important emissions informati...