Snapper 1726315-02 - Manuals

Page 3 - Table of Contents

1 Attaching & Removing the Turbo Attaching the Turbo..........................................7Removing the Turbo ........................................7Adjustments .....................................................8Storage ............................................................8Front ...

Page 4 - GENERAL WARNINGS; SAFETY DECALS

2 Read and obey all operation and warning decals. ROTATINGBLADES SHUT OFF MOWERAND TRACTORBEFORE SERVICINGOR CLEANING BLOWERAND MOWER. DANGER 1700259 • This shield must be in place at all times during operation. • Mower deflector must be in down position when blower is removed. 1717291 WARNING Safet...

Page 5 - OPERATING WITHOUT THE TURBO; General; RECOMMENDED ACCESSORIES; AFTER OPERATION

3 BEFORE OPERATION Clear the lawn of all sticks, stones, wire and other debriswhich may be caught or thrown by the mower blades. Check grass condition. If wet, wait until later in the day.If grass is wet, as the grass catcher is likely to becomeplugged. For efficient grass collection, air circulatio...

Page 6 - INITIAL SETUP & ASSEMBLY; Install Stacked Arbor Pulley

4 Initial Setup & Assembly Figure 2. Assemble the New CoverA. Belt Cover E. Hinge B. Knob F. Screw, #10-32 x 3/8 C. Left Hand Cover G. 5/16 Push nut D. Locknut, #10-32 G Figure 1. Deflector, Stone Guard, and Cover A. Deflector C. Belt Cover B. Stone Guard A B C INITIAL SETUP & ASSEMBLY Prepa...

Page 7 - Initial Setup & Assembly; Assemble & Install Deflector

5 Initial Setup & Assembly Assemble & Install Deflector 1. The two holes for mounting the deflector must be drilled out. Turn the deflector over, and notice thatthese two holes are started. Finishing drilling the two11/32 inch holes (See Figure 4). 2. See Figure 4. Connect the deflector (A) ...

Page 8 - Assemble Turbo

6 Initial Setup & Assembly Assemble Turbo 1. Assemble the turbo. Install the bracket (A, Figure 5) and upstop (B) as follows: NOTE: Upstop (B. Figure 5) has short and long leg. Thedifference is the thickness of bracket (A). Place long legon housing and short leg on top of bracket. Washer(s)may n...

Page 9 - Removing the Turbo; ATTACHING THE TURBO; REMOVING THE TURBO

7 Attaching & Removing the Turbo WARNING To operate without the collection system, theblower assembly MUST be removed and thedeflector MUST be in the down position. The deflector is spring loaded. when attaching orremoving the blower, hold the deflector up; thenallow the deflector to go down int...

Page 10 - ADJUSTMENTS; Pulley Adjustments; Upstop Adjustment; STORAGE; FRONT; Attaching & Removing the Turbo

8 ADJUSTMENTS Pulley Adjustments If the mower deck belt has stretched over time, thestacked idler pulley (B, Figure 10) may need to bemoved to the outer hole in the mower deck to take up thebelt slack. If the mower idler pulley (B) is mounted in the outer holein the deck, then the turbo idler pulley...

Page 11 - Front Bracket Hole Template

9 Front Bracket Hole Template Line up SquareHole onTemplate tosquare Hole ofDeck Line up “Edge ofMower” Line onTemplate to Edgeof Mower Mark and DrillTwo 13/32”Holes Line Up With Edge of Mower Line Up WithExisting Square Hole

Snapper 1726315-02 - Manuals

Manuals:

Manual Snapper 1726315-02

Summary

Snapper Manuals