Snapper 1695464 - Manuals

3 Safety Rules and Information SAFETY DECALS This unit has been designed and manufactured to pro-vide you with the safety and reliability you would expectfrom an industry leader in outdoor power equipmentmanufacturing. Although reading this manual and the safety instructionsit contains will provide ...

4 Before Operation Clear the lawn of all sticks, stones, wire and other debriswhich may be caught or thrown by the mower blades. Check grass condition. If wet, wait until later in the day.If grass is wet, the grass catcher is likely to becomeplugged. For efficient bagging, air circulation under them...

5 General Operating Instructions CAUTION Before you begin operating the unit be certainyou have read all of the safety and operationalinformation of this instruction sheet, as well asthe Operator’s Manual for the tractor and anyother attachments. Never operate on slopesgreater than 17.6% (10°). Afte...

Turbo Installation 1. Remove and discard existing baffle from the left side of the mower deck. It is replaced by turbo baffles. 2. Install the left (23-1/2” long) baffle and right (26-1/2” front baffle (A and B, Figure 1) using six carriagebolts (C), lockwashers (D), and nuts (E). Be sure thebolts a...

Turbo Installation Install Deflector and Hinge 1. Install the new deflector and hinge assembly (A, Figure 3) onto 54-inch mower deck. 2. Secure front of hinge bracket using a new carriage bolt (B), cylinder spacer (C), lockwasher (D), and nut(E). 3. Secure back of hinge bracket using carriage bolt (...

D A B Install Upright Support 1. Set the upright support (A, Figure 7) onto pins of hitch plate (B) 2. Secure with rod (C) and hair pin (D). C Figure 7. Install Upright SupportA. Upright Support C. Rod B. Hitch Plate D. Hair Pin Turbo Installation / Triple Catcher Bag Installation Install Hitch Plat...

Triple Catcher Bag Installation Install Cover Assembly 1. Attach the collector cover (A, Figure 9) to bag and cover support (B) using hinge pivots (C). 2. Secure the collector cover using cover hinge pins (D)and hair pins (E). A E C Figure 9. Install Cover AssemblyA. Collector CoverB. Bag and Cover ...

Triple Catcher Bag Installation Connect Upper and Lower Tubes 1. Slide upper tube (A, Figure 11) into opening in col-lector cover (B). 2. Slide lower tube (C) over opening in turbo assembly (D). 3. Slip one end of rubber strap (E) through clamp (F) on lower tube. Figure 11. Connect Upper and Lower T...

Triple Catcher Bag Installation / Turbo Removal Figure 12. Install Carrier and Front Weight(s)A. Carrier, Weight D. Weight(s) B. 1/2-13 x 1-1/4, E. Rod Capscrews F. Safety Clips C. 1/2-13 Locknuts A B F D E Install Carrier and Front Weight(s) 1. Install carrier (A, Figure 12) as shown and secure wit...