Simplicity Turbo Vacuum Collection System - Manuals

Page 2 - Table of Contents

1 Attaching & Removingthe Turbo Vacuum Collector Attaching the Turbo..........................................8Removing the Turbo ........................................8Adjustments .....................................................9Storage ......................................................

Page 3 - GENERAL WARNINGS; SAFETY DECALS

2 Read and obey all operation and warning decals. ROTATINGBLADES SHUT OFF MOWERAND TRACTORBEFORE SERVICINGOR CLEANING BLOWERAND MOWER. DANGER 1700259 Safety Rules& Information Read these safety rules and follow them closely. Failure to obey these rules could result in loss of control ofunit, sev...

Page 4 - OPERATING WITHOUT THE TURBO; General; WARNING; RECOMMENDED ACCESSORIES; AFTER OPERATION

3 BEFORE OPERATION Clear the lawn of all sticks, stones, wire and other debriswhich may be caught or thrown by the mower blades. Check grass condition. If wet, wait until later in the day.If grass is wet, as the grass catcher is likely to becomeplugged. For efficient grass collection, air circulatio...

Page 5 - Remove Deflector & Cover; Install New Idler Pulley Assembly

4 Initial Setup & Assembly Figure 1. Deflector, Stone Guard, and Cover A. Deflector C. Belt Cover B. Spring D. Rod A B C D Figure 3. Install New PulleyA. Capscrew, 3/8 x 3-1/4 D. Spacer B. Thick Washer E. Lockwasher C. Pulley Assembly F. Hex Nut A B C D E F Figure 2. Idler Pulley BracketA. Idler...

Page 6 - Initial Setup & Assembly; Assemble & Install New Belt Cover

5 Initial Setup & Assembly Assemble & Install New Belt Cover 1. Assemble the pulley cover (G, Figure 4) to the new belt cover. Using 10-32 x 3/8 machine screws and#10-32 nut-washer assemblies. The screws must beinserted from inside the belt cover so that nuts (D)are outside. 2. Secure knob (...

Page 7 - Assemble & Install Deflector

6 Initial Setup & Assembly Assemble & Install Deflector 1. The two holes for mounting the deflector must be drilled out. Turn the deflector over, and notice thatthese two holes are started. Finishing drilling the two11/32 inch holes (See Figure 5). 2. See Figure 5. Connect the deflector (A) ...

Page 8 - Assemble Turbo

7 Initial Setup & Assembly Assemble Turbo 1. Assemble the turbo. Install the bracket (A, Figure 6) and upstop (B) as follows: NOTE: Upstop (B. Figure 6) has a short and a long leg.The difference is the thickness of bracket (A). Place longleg on housing and short leg on top of bracket.Washer(s) m...

Page 9 - ATTACHING THE TURBO; REMOVING THE TURBO

8 Attaching & Removingthe Turbo Vacuum Collector WARNING To operate without the collection system, theblower assembly MUST be removed and thedeflector MUST be in the down position. The deflector is spring loaded. when attaching orremoving the blower, hold the deflector up; thenallow the deflecto...

Page 10 - ADJUSTMENTS; Pulley Adjustments; Upstop Adjustment; STORAGE; Attaching & Removing the Turbo; FRONT

ADJUSTMENTS Pulley Adjustments If the mower deck belt has stretched over time, thestacked idler pulley (B, Figure 11) may need to bemoved to the outer hole in the mower deck to take up thebelt slack. If the mower idler pulley (B) is mounted in the outer holein the deck, then the turbo idler pulley (...