Simplicity 1694383 319E - Manuals

Simplicity 1694383 319E – Manual in PDF format online.

Manuals:

Manual

Manual Simplicity 1694383 319E

Summary

Page 2 - THIS PAGE INTENTIONALLY BLANK

THIS PAGE INTENTIONALLY BLANK (FOR PLACEMENT ONLY - DO NOT PRINT)

Page 5 - Table of Contents; Safety Rules & Information; WARNING

1 Table of Contents Safety Rules & Information General Operation ..................................................2 Slope Operation ......................................................2 Children ...................................................................3 Emissions ......................

Page 6 - GENERAL OPERATION

2 Safety Rules & Information GENERAL OPERATION • Read, understand, and follow all instructions in the manual and on the unit before starting. • Only allow responsible adults, who are familiar with the instructions, to operate the unit (local regulationscan restrict operator age). • Clear the are...

Page 7 - Safety Rules; CHILDREN

3 Safety Rules CHILDREN Tragic accidents can occur if the operator is not alert to thepresence of children. Children are often attracted to theunit and the operating activity. Never assume that childrenwill remain where you last saw them. • Keep children out of the area and under the watchful care o...

Page 9 - Safety Decals / Identification Numbers; SAFETY DECALS; LLEE; IDENTIFICATION NUMBERS

5 Safety Decals / Identification Numbers SAFETY DECALS Safety warning decals are placed at strategic locations on the snowthrower as a constant reminder to the operator ofthe most important safety precautions. All warning, caution and instructional messages on your snowthrower shouldbe carefully rea...

Page 10 - CONTROL LOCATIONS

6 Features & Controls CONTROL LOCATIONS The information below briefly describes the function of individual controls. Starting, stopping, and driving require thecombined use of several controls applied in specific sequences. To learn what combination and sequence of controlsto use for various tas...

Page 12 - Operation; CHECKS BEFORE EACH START-UP; DANGER; OPERATIONAL WARNINGS; Clearing The Discharge Chute; Discharge Chute Adjustment

8 Operation GENERAL OPERATION CHECKS BEFORE EACH START-UP 1. Make sure all safety guards are in place and all nuts, bolts and clips are secure. 2. Check the fuel supply. Fill the tank no closer than 1/4 to 1/2 inch of top of tank to provide space for expan-sion. See your engine Owner’s Manual for fu...

Page 14 - STARTING THE ENGINE; STOPPING THE ENGINE

10 Operation STARTING THE ENGINE NOTE: The snowthrower engine is designed to operateat cold temperatures. Avoid operating the snowthrower ifair temperature is 40° F or warmer. Engine will be diffi-cult to start in warm weather. 1. Insert engine key into the switch and turn key (B, Figure 2) to the O...

Page 15 - OPERATING THE SNOWTHROWER; After Each Use; SNOWTHROWING TIPS; Starting After Storage

11 Operation OPERATING THE SNOWTHROWER Before operating snowthrower, review the CHECKSBEFORE EACH START UP on page 8 of this manual.Refer to FEATURES & CONTROLS for control locations. 1. Rotate the discharge chute to the desired direction. 2. Pull the auger control back against the handle to eng...

Page 16 - MAINTENANCE SCHEDULE

RegularMaintenance 12 CHECK AUGER CABLE & STOPPINGTIME 1. Visually check the cable (C, Figure 3) for kinks, fray- ing, or severed cable strands. Replace if damaged orworn. 2. Start the engine. 3. Engage the auger control (A) and hold for five sec- onds. 4. Release the auger control (A). The auge...

Page 17 - TROUBLESHOOTING

13 Troubleshooting, Adjustments, & Service PROBLEM PROBABLE CAUSE CORRECTIVE ACTION Engine Will Not StartUsing Recoil Starter 1. Fuel tank empty. 1. Fill fuel tank with fresh fuel/oil mix. 2. Engine needs choking & priming. 2. Move choke control to "CHOKE" position.Push primer bulb t...

Page 18 - AUGER CONTROL ADJUSTMENT; Inspection; Adjustment

14 Troubleshooting, Adjustments, & Service Before beginning any repair stop the engine,remove the key, disconnect the spark plug wire,and wait for all moving parts to stop. WARNING DO NOT over-tighten the cable. The control cablemust have some slack when in the disengagedposition for the auger b...

Page 20 - AUGER DRIVE BELT REPLACEMENT

Figure 10. Belt Diagram - PTO PulleyA. Belt GuideB. Idler PulleyC. PTO PulleyD. Drive Belt O FF O FF 16 Troubleshooting, Adjustments, & Service AUGER DRIVE BELT REPLACEMENT Inspect belt frequently for signs of excessive wear.Visually check for cracking, fraying, severed or exposedbelt strands. 1...

Page 21 - AUGER FLITE SHOE REPLACEMENT

17 Troubleshooting, Adjustments, & Service Figure 11. Auger FlitesA. Auger B. Flite ShoeC. Self-Tapping Screws AUGER FLITE SHOE REPLACEMENT Inspect the flite shoes frequently for signs of excessivewear. Visually check flite shoes for cracking, fraying,and severed or exposed belts. 1. Turn the en...

Page 22 - SPECIFICATIONS; Engine; Chassis; REPLACEMENT PARTS

18 Specification, Parts, &Accessories SPECIFICATIONS Engine Make Tecumseh Model HSK600 Spec 1691V / 1702V Horsepower 3 @ 4300 rpm Displacement 6 cu. in. Oil Type 2-Cycle Starter Recoil, or Recoil with Electric Start Chassis Chute Rotation 200 degrees Fuel Tank Cap. 1.25 Qt. Overall Height 36” Ov...