Sharp HT-SB602 - Manuals - manualsarea.com

Page 2 - Accessories; The following accessories are included.; Special Notes

E-1 Accessories The following accessories are included. Remote Control (RRMCGA331AWSA) Subwoofer Stand x 2 Audio Cable x 1 HDMI Cable x 1 IR Transmitter x 1 Wall Mount Angle x 2 Pattern Paper NFC tag x 1 Velcro tape (hook type) x 1 Velcro tape (loop type) x 2 “AAA” size battery (UM- 4, R03, HP-16 or...

Page 3 - Precautions; General; Volume control; Controls and indicators; Sound Bar Front Panel; Left Channel Speakers

E-2 Precautions  General  Keep your equipment at least 10 cm of free space along the sides, top and back for proper ventilation. 10 cm 10 cm 10 cm 10 cm 10 cm 10 cm 10 cm  Use the unit on a fi rm, level surface free from vibration.  Keep the unit away from direct sunlight, strong magnetic fi eld...

Page 4 - Display; Dolby Digital Indicator; Subwoofer; NFC detection area; Sound Bar Rear Panel; Optical IN Socket

E-3 Controls and indicators (continued)  Display DIGITAL DIGITAL 1 2 3 1. Dolby Digital Indicator 2. DTS Indicator 3. Muting Indicator  Subwoofer 5 3 4 2 6 1 FRONT VIEW REAR VIEW 1. NFC detection area 2. Power / Pairing Indicator 3. Bass Refl ect Duct 4. Woofer 5. SW LINK (Subwoofer Link) button 6...

Page 5 - Remote Control

E- 4 Controls and indicators (continued) 1 2 4 5 7 8 9 12 16 17 18 19 13 15 14 3 6 11 10 20 22 23 24 26 27 29 30 33 34 35 31 32 21 25 28  Remote Control 1. Remote Control Transmitter 2. ON / STANDBY Button3. HDMI 2 Button4. HDMI 1 Button5. OPTICAL Button6. MUSIC (Sound Mode) Button 7. CINEMA (Sound...

Page 6 - Sound bar preparation; To mount the sound bar on the wall; Slot the sound bar into the wall mount angle.

E-5 Sound bar preparation To mount the sound bar on the wall Caution :  Be very careful to prevent the sound bar 3.7 kg from falling when mounting on the wall.  Before mounting, check the wall strength. (Do not put on the veneer plaster or whitewashed wall. The sound bar may fall.) If unsure, cons...

Page 7 - Falling prevention; When mounting on the wall; Align and fi x the sound bar to wall mount angle.; Tie the safety wires tightly.; When placing on the shelf / table

E- 6 Falling prevention  Safety wires (not supplied) are useful to prevent the sound bar from falling off.  2 persons are required to perform this procedure. When mounting on the wall 1 Loop the safety wires (not supplied) into each hole of the wall mount angle as shown. Wall surface 2 Loop the sa...

Page 8 - Placing the system; Placing the stand; System connections

E-7 Placing the system Installation image: T V VCR DVD player Subwoofer Sound Bar Place the system as shown. Remove the protective fi lm covering the sound bar and subwoofer before turn on the system. Notes :  The front panel of the sound bar is not removable.  The transmission distance of the wir...

Page 9 - HDMI Connection; Audio and Video signal

E-8 System connections (continued)  IR ( Infrared) transmitter connection If the TV’s remote sensor is blocked by the sound bar, use the IR transmitter to relay the signal to the TV. 1. Connect the IR transmitter to IR out terminal to allow the TV’s remote signal to pass through. 2. Place the infra...

Page 11 - Remote control operation :; Remote control; Battery installation; Open the battery cover.

E-10 Audio connections to TVs, DVD players, VCRs, etc. (continued)  Connecting a TV, or DVD player, etc. Connect to the TV using an optical digital cable or an audio cable. To audio output terminals Sound Bar TV or Audio cable (commercially available) To AUDIO IN input terminals To OPTICAL IN (opti...

Page 12 - Test of the remote control; General control; To turn the power on; To set the sound bar to standby mode :; Standby mode

E-11 Remote control (continued)  Test of the remote control Point the remote control directly at the remote sensor on the sound bar. The remote control can be used within the range shown below: 15° 15° Remote sensor 0.2 m - 6 m General control Make sure to enable the HDMI CEC when making HDMI conne...

Page 14 - Auto detect signal; The unit will enter standby mode if:; D sound mode; Dolby Digital

E-13 General control (continued)  APC (Auto Power Off Control) This sound bar can be set to turn off automatically if no signal is detected. (Except Bluetooth function) 1. Press the APC button repeatedly to select the time. APC 15 MIN APC 20 MIN APC 10 MIN APC 5 MIN 2. The sound bar will enter the ...

Page 15 - Bluetooth one touch connection via NFC; About NFC technology; NFC detection area; NFC tag set up

E-14 Bluetooth one touch connection via NFC  About NFC technology Near Field Communication (NFC) is a set of standards for devices (smartphones /tablets) to establish radio communi - cation with each other by touching /tapping them together or bringing them into close proximity.Using NFC in this pr...

Page 16 - Bluetooth one touch connection via NFC (continued); NFC connection for audio playback; Listening to

E-15 Bluetooth one touch connection via NFC (continued)  NFC connection for audio playback Check that :  Your device (smartphone / tablet) has an NFC function.  NFC function on your device is turned on.  Screen lock function of the device is off.  This unit is not in Eco mode. 1 Touch your devi...

Page 17 - Indicator

E-16 Listening to Bluetooth enabled devices (continued) Indicators: Indicator Condition Bluetooth status Blinks In waiting or pairing mode Lights up Connected No indication Unconnected However, the indication status is not displayed during standby mode.  Pairing with other Bluetooth source devices ...

Page 18 - Watching TV; Other operable button; Troubleshooting chart; Symptom

E-17 Operating the TV with the remotecontrol You can operate Sharp TVs with this system’s remote control.  Watching TV Point the remote control at the TV. 1 Press the T V ( ) ON / STANDBY button to turn on the T V. 2 Pressing the T V CH + or – button enables T V channel switching. 3 Press the T V V...

Page 20 - Maintenance; Cleaning the cabinet; Error indicators and warnings; Specifi cations; Sound Bar

E-19 Maintenance  Cleaning the cabinet Periodically wipe the cabinet with a soft cloth. Caution :  Do not use chemicals for cleaning (petrol, paint thinner, etc.). It may damage the cabinet fi nish.  Do not apply oil to the inside of each component. It may cause malfunctions. Error indicators and...

Page 21 - For Australia and New Zealand customers; NEW ZEALAND; SHARP CUSTOMER SERVICES; AUSTRALIA; SHARP APPROVED SERVICE CENTRE

For Australia and New Zealand customers FOR LOCATION ENQUIRIES WITHIN NEW ZEALAND REGARDING YOUR LOCAL SHARP CORPORATION OF NEW ZEALAND LIMITED VISIT OUR WEBSITE AT SHARP CUSTOMER SERVICES TELEPHONE: 09 573 0111 FACSIMILE: 09 573 0113 FOR LOCATION ENQUIRIES WITHIN AUSTRALIA REGARDING YOUR LOCAL SHAR...

Page 22 - Congratulations on Your Purchase!; WARRANTY PERIODS; WARRANTY; Consumer Electronic Products

SHARP CORPORATION Congratulations on Your Purchase! This Sharp product is warranted against faults in material and manufacture for theperiod as stated in the table below. If service is required during the warranty period, please contact your nearest SharpApproved Service Centre. These repairs would ...