Page 2 - FOR YOUR PROTECTION
2 To aid in answering questions if you call for service or for reporting loss or theft, please recordbelow the model and serial number located on the right side of the unit. FOR YOUR PROTECTION TO PHONE: Dial 1-800-BE-SHARP (237-4277) for: SERVICE (for your nearest Sharp Authorized Servicer)PARTS (f...
Page 3 - SHARP ELECTRONICS CORPORATION
3 SHARP ELECTRONICS CORPORATION warrants to the first consumer purchaser that this Sharp brand product (the "Product"),when shipped in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option,either repair the defect or replace the...
Page 4 - INSTALLATION INSTRUCTIONS; CHECK WINDOW AREA; LOCATION
4 INSTALLATION INSTRUCTIONS Before beginning installation, read these instructions carefully.Use the enclosed MOUNTING KIT for proper installation. The mounting kit is designed for wooden sill double or single hung sash-type windows. Minimum opening(Without mounting kit) 19 11 / 16 " (500mm) Win...
Page 5 - ACCESSORIES; SUGGESTED TOOLS
5 11 10 9 8 6 7 3 4 5 1 2 11 10 9 8 7 6 5 4 3 2 1 ACCESSORIES No. Accessories Q'ty Right closure assembly 1 Left closure assembly 1 Window sash foam seal 1 1. Screw driver (medium size Phillips)2. Tape measure or ruler3. Knife or scissors INSTALLATION INSTRUCTIONS 6 7 2 2 SUGGESTED TOOLS Window sash...
Page 6 - INSTALLATION
6 Insert the right closure assembly and theleft closure assembly into the top angleand the bottom channels.Secure the right and left closure to thecabinet with six of the provided screws.(L= 13 / 32 ", 10mm) 2 3 Open the window sash and place the airconditioner on the sill. Balance the unit on t...
Page 8 - PRECAUTIONS; CAUTION FOR USE
8 IMPORTANT: Points to keep in mind when using your air conditioner. • Install the air conditioner by following the installation instructions given in the previous section of this manua l. • Make sure the unit is the correct capacity for the area you want to cool. • Do not modify any part of this pr...
Page 9 - NOTES ON OPERATION
9 PRECAUTIONS • Allow 3 minutes for the compressor to restart cooling. If you turn the air conditioner off and immediately restart it, allow three minutes for the compressor torestart cooling. There is an electronic device in the unit that keeps the compressor off three minutes forprotection. • If a...
Page 10 - PARTS NAMES; UNIT; HOW TO OPERATE
10 PARTS NAMES UNIT CONTROL PANEL 1 Front Cabinet 2 Air Inlet (Indoor Side) 3 Horizontal Louvers 4 Vertical Louvers 5 Air Outlet (Indoor Side) 6 Control Panel 7 Rear Cabinet 8 Air Inlet (Outdoor side) 9 Filter (Pull the filter handle to the right to remove.) 0 Filter Handle q Power Cord HOW TO OPERA...
Page 11 - During cooling operation; COOLING OPERATION
11 HOW TO OPERATE --- Lower temp. --- Raise temp. Touch POWER ON/OFF pad. • The unit is preset at 74 ° F and HIGH COOL. This will show in the displaywhen the power is first turned on. • POWER indicator and SELECTOR in- dicator (COOL) will light. To turn off the unit, touch POWERON/OFF pad again . • ...
Page 12 - TO CHANGE FAN SPEED AND OPERATION MODE; During operation; NOTES ON OPERATION MODE:
12 POWER ON/OFF F hr SELECTOR TIMER ON/OFF ENERGY SAVER COOL / FAN TEMP SELECTOR indicator SELECTOR pad TO CHANGE FAN SPEED AND OPERATION MODE During operation Touch SELECTOR pad and select theoperation mode and fan speed. • SELECTOR indicator and display will light in order as you touch. HOW TO OPE...
Page 13 - ENERGY SAVER
13 HOW TO OPERATE ENERGY SAVER TO CHANGE AIR FLOW DIRECTION Horizontal louvers Adjust UP/DOWN air flow The horizontal louvers are used to adjust the UP / DOWN direction of air flow, and the verticallouvers are used to adjust the LEFT / RIGHT direction of air flow for uniform and efficient coolingof ...
Page 14 - ON TIMER OPERATION; When the unit is not operating
14 HOW TO OPERATE ON TIMER OPERATION (If you wish to start the operation6 hours and 30 minutes later, setthe delay time as shown above.) 1 Touch the TIMER ON/OFF pad to set thedelayed start time. • The time setting will change as you touch the pad. The display will change as follows; • The timer wil...
Page 15 - OFF TIMER OPERATION; TO CANCEL THE TIMER SETTING
15 HOW TO OPERATE OFF TIMER OPERATION • This unit has a built-in timer that can be programmed to shut the unit off up to 12 hours in advance. You can set the timer to stop in increments of 30 minutes (0.5 hours) up to 9.5 hours in advanceof the stop time, or in 1 hour increments from 10 to 12 hours ...
Page 16 - INSTALLING BATTERIES; ATTACHING THE REMOTE CONTROL HOOK; HOW TO USE THE REMOTE CONTROL; USING THE REMOTE CONTROL
16 Remove the battery compartment cover. Insert the batteries in the compartment,making sure the and polaritiesare properly aligned. Replace the cover. HOW TO OPERATE INSTALLING BATTERIES Use two size-AAA (R03) batteries. Battery compart-ment cover NOTES:• The battery life is approximately one year ...
Page 17 - OPERATING WITH THE REMOTE CONTROL; TRANSMITTER; SELECTOR button
17 POWER TEMP. TEMP. SELECTOR SET TIMER/OFF ON/OFF • The time setting will change as you push the button. The display will change as follows; • The last OFF time setting is memorized by the unit and will appear on the display when the button is pushed. • The timer will be set, 5 seconds after the SE...
Page 18 - CLEANING AND MAINTENANCE; CLEANING THE FILTER; REMOVE THE FILTER
18 CLEANING AND MAINTENANCE CLEANING THE FILTER If the filter is clogged with dust, the amount of air flow willbe reduced, resulting in poor cooling performance. Thefilter should be cleaned every 10 days. At the beginning ofevery cooling season or after a long period of inactivity,clean the filter b...
Page 19 - BEFORE CALLING FOR SERVlCE
19 BEFORE CALLING FOR SERVlCE IF YOUR AIR CONDITIONER DOES NOT OPERATE PROPERLY, PLEASE CHECKTHE FOLLOWING ITEMS BEFORE CALLING FOR SERVICE. AIR CONDITIONER DOES NOT OPERATE AT ALL • Is the unit plugged in or is the plug loose? • Is the fuse blown or the circuit breaker tripped? • Did you restart th...