Page 2 - FOR YOUR PROTECTION; SERVICE (for your nearest Sharp Authorized Servicer)
2 To aid in answering questions if you call for service or for reporting loss or theft, please recordbelow the model and serial number located on the right side of the unit. DATE OF PURCHASE Dealer Name Address City State Zip Telephone FOR YOUR PROTECTION TO PHONE: Dial 1-800-BE-SHARP (237-4277) for...
Page 3 - SHARP ELECTRONICS CORPORATION
3 SHARP ELECTRONICS CORPORATION warrants to the first consumer purchaser that this Sharp brand product (the "Product"),when shipped in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option,either repair the defect or replace the...
Page 4 - INSTALLATION INSTRUCTIONS; CHECK WINDOW AREA
4 INSTALLATION INSTRUCTIONS Before beginning installation, read these instructions carefully.Use the enclosed MOUNTING KIT for proper installation. The mounting kit is designed for wooden sill double or single hung sash-type windows. Minimum opening(Without mounting kit) Mounting kit fully closed Mo...
Page 5 - Accessories; Top angle; WARNING; : Make sure the unit is turned off and unplugged before working.; ITEMS PACKED WITH THIS UNIT
5 No. Accessories Q'ty Right closure assemblyLeft closure assemblyWindow sash foam seal 111 1. Screw driver (medium size Phillips)2. Tape measure or ruler3. Knife or scissors4. Cotton gloves INSTALLATION INSTRUCTIONS Screws(L=1", 25.4mm) Top angle 7 1 9 Screws(L= 1 / 4 ", 6mm) Window sash fo...
Page 8 - PRECAUTIONS; CAUTION FOR USE
8 IMPORTANT: Points to keep in mind when using your air conditioner. • Install the air conditioner by following the installation instructions given in theprevious section of this manua l. • Make sure the unit is the correct capacity for the area you want to cool. • Do not modify any part of this pro...
Page 9 - NOTES ON OPERATION
9 PRECAUTIONS • Allow 3 minutes for the compressor to restart cooling. If you turn the air conditioner off and immediately restart it, allow three minutes for the compressor torestart cooling. There is an electronic device in the unit that keeps the compressor off three minutes forprotection. • If a...
Page 10 - HOW TO OPERATE; PARTS NAMES
10 9 12 1 2 3 4 5 6 7 13 1011 8 UNIT CONTROL PANEL HOW TO OPERATE Front panelAir inlet (Indoor side)Vertical louversHorizontal louversAir outlet (Indoor side)Exhaust leverControl panel CabinetAir outlet (Outdoor side)Air inlet (Outdoor side)Filter handleFilter (Pull the filter handle to the right to...
Page 11 - COOLING OPERATION; During operation; NOTES ON OPERATION MODE:
11 HOW TO OPERATE Cooling operation with high fan speed. Cooling operation with medium fan speed. Cooling operation with low fan speed. Fan only operation with high fan speed. Fan only operation with medium fan speed. Fan only operation with low fan speed. Touch POWER ON/OFF pad. • The unit is prese...
Page 12 - • Display will change as you touch; During cooling operation; TO CHANGE TEMPERATURE SETTING; TO CHANGE AIR FLOW DIRECTION
12 HOW TO OPERATE --- Lower temp. Touch the TEMPERATURE settingpad to adjust the temperature set-ting. • Temperature can be set within the range of 64 ° F to 86 ° F. • Display will change as you touch the pad. NOTES: • In fan only (HIGH FAN, MED FAN, LOW FAN) operation, the temperature display will ...
Page 13 - ENERGY SAVER OPERATION; SLEEP OPERATION
13 HOW TO OPERATE ENERGY SAVER OPERATION During normal operation, the thermostat automatically controls cooling and the fan runs continu-ously. When the ENERGY SAVER OPERATION is selected, the thermostat automaticallycontrols cooling and the fan automatically stops when the compressor is not operati...
Page 14 - ON TIMER OPERATION; When the unit is not operating
14 HOW TO OPERATE ON TIMER OPERATION (If you wish to start the operation6 hours and 30 minutes later, setthe delay time as shown above.) 1 Touch the TIMER ON/OFF pad to set thedelayed start time. • The time setting will change as you touch the pad. The display will change as follows; • The timer wil...
Page 15 - OFF TIMER OPERATION; TO CANCEL THE TIMER SETTING; NOTES FOR ON/OFF TIMER SETTING AND OPERATION:
15 HOW TO OPERATE OFF TIMER OPERATION • This unit has a built-in timer that can be programmed to shut the unit off up to 12 hours in advance. You can set the timer to stop in increments of 30 minutes (0.5 hours) up to 9.5 hours in advanceof the stop time, or in 1 hour increments from 10 to 12 hours ...
Page 16 - INSTALLING BATTERIES; HOW TO USE THE REMOTE CONTROL; USING THE REMOTE CONTROL
16 HOW TO OPERATE Open the battery compartmentcover. Insert and slide the batteries intothe compartment, making surethe and polarities areproperly aligned. Close the cover. INSTALLING BATTERIES Use two size-AA (R6) batteries. Battery compartment cover NOTES: • The battery life is approximately one y...
Page 17 - OPERATING WITH THE REMOTE CONTROL; TRANSMITTER; SELECTOR button; OFF TIMER button; SLEEP button
17 HOW TO OPERATE OPERATING WITH THE REMOTE CONTROL AIR CONDITIONER ON / OFF • The time setting will change as you push the button. The display will change as follows; TEMP.TEMP. --- Raise temp. setting 1 ° F at a time. --- Lower temp. setting 1 ° F at a time. TRANSMITTER TEMP. button POWER ON/OFF b...
Page 18 - CLEANING THE FILTER; REMOVE THE FILTER; CLEANING OF THE FRONT PANEL AND CABINET
18 ENERGY EFFICIENCY TIPS CLEANING AND MAINTENANCE CLEANING THE FILTER If the filter is clogged with dust, the amount of air flow willbe reduced, resulting in poor cooling performance. Thefilter should be cleaned every10 days. At the beginningof every cooling season or after a long period ofinactivi...
Page 19 - BEFORE CALLING FOR SERVlCE
19 BEFORE CALLING FOR SERVlCE IF YOUR AIR CONDITIONER DOES NOT OPERATE PROPERLY, PLEASE CHECKTHE FOLLOWING ITEMS BEFORE CALLING FOR SERVICE. AIR CONDITIONER DOES NOT OPERATE AT ALL • Is the unit plugged in or is the plug loose?• Is the fuse blown or the circuit breaker tripped?• Did you restart the ...