Sennheiser SET810 - Manuals

28 SET 810 S English Only use one of the two audio inputs on the transmitter (MIC or LINE). Connect the power cable to the POWER socket on the transmitter. Plug the power supply into a household electrical outlet. Pull the power supply unit out of the electrical outlet when the unit will not be used...

SET 810 S 29 English Where to place the transmitter Place the transmitter so that the in-frared light beam is pointed directly at the receiver, i. e. there should be no obstacles in the light path bet-ween transmitter and receiver. Gui-de the cables backwards. Avoid exposure to direct sunlight. Dire...

30 SET 810 S English Using the receiver The receiver is turned on automatical-ly as soon as a 3.5 mm stereo jack plug is inserted into the socket at the top of the receiver. Affix the receiver to the clothing by means of its integrated attachment clip. Make sure the receiver is positio-ned correctly...

SET 810 S 31 English Using the induction neck loop Put the EZT 1011 induction neck loop around your neck and insert its plug into the socket at the top of the receiver. Set your hearing aid to position "T". Adjusting the volume Adjust the receiver's volume with the operating control. Make su...

32 SET 810 S English Turning the automatic compression system on Use the COM switch (compressi-on) at the rear of the transmitter to turn the automatic compressi-on system on. This system repro-duces soft passages louder and decreases loud sounds. Choose the setting that suits your liste-ning prefer...

SET 810 S 33 English Charging the battery Place the receiver into the transmitter's charging compartment, with the operating control at the front. Pull the 3.5 mm stereo plug out of the receiver to turn the receiv-er off. The left LED on the transmitter must light up. Charge the battery for 24 hours...

SET 810 S 35 English Additional information This system uses infrared light which is emitted by the transmitter and re-ceived by the receiver. Please note that infrared light emitted by other light sources may interfere with the useful signal of the Set 810 S.If the light path between transmitter an...

SET 810 S 37 English Accessories Only use original Sennheiser spare parts and accessories. ATTENTION : Components from other manufacturers (e.g. for power supply or battery) may cause damage to the unit and will invalidate the waranty. The following accessories are available from your authorized dea...

38 SET 810 S English BA 151 rechargeable battery By using a spare battery, you can use the receiver for more than four hours of continuous operation. Always store the spare battery in the small charging compartment at the right of the transmitter. The right LED on the transmitter lights up green to ...

SET 810 S 39 English MKE 800 TV external microphone If your TV doesn't have a headphone output, SCART or RCA socket, you can use your Set 810 S together with the MKE 800 TV microphone. Fix the microphone to the loudspeaker of your TV by means of Velcro tape. Connect the microphone connector to the M...

40 SET 810 S English If problems occur... - Are all jack plugs connected correctly?- Are the receiver and sound source turned on and is the volume of the receiver and sound source sufficient? - Is the rechargeable battery inserted properly into the receiver?- Have you charged the battery for at leas...

SET 810 S 41 English Additional information for hearing aid acousticians Adjustments for hearing disabilities Attention: In order to ensure interference-free reception, only use the potentiometers shown below. Turn the operating control fully to the left (0). Remove the operating control by carefull...

SET 810 S 45 English Manufacturer declarations CE Declaration of Conformity This equipment is in compliance with the essential requirements and other relevant provisions of Directi-ves 1999/5/EC, 89/336/EC or 73/23/EC. The declaration is available on the internet site at www.sennhei-ser.com.Before p...