Sears 944.529571- Manuals

Page 2 - IMPORTANT; Safe Operation Practices for Walfc-Behind Snow Throwers

IMPORTANT Safe Operation Practices for Walfc-Behind Snow Throwers This snow thrower is capabie of amputating hands and feet and throwing objects, Faiiure to observe the foiiowing safety instructions couid resuit in serious injury. A Look for this symbol to point out Important safety precautions. It...

Page 3 - PRODUCT SPECIFICATIONS; CUSTOMER RESPONSIBILITIES; TABLE OF CONTENTS

6, When cleaning, repairing or inspecting the snow thrower, stop the engine and make certain the collector/impel- ler and all moving parts have stopped. Disconnect the spark plug wire and keep the wire away from the plug to prevent someone from accidentally starting the engine, 7, Do not run the eng...

Page 5 - PARTS PACKED SEPARATELY IN CARTON

PARTS PACKED SEPARATELY IN CARTON (2) FLAT WASHERS (2) CARRIAGE BOLTS 3/8-16x2.25 (2) HANDLE KNOBS ASSEMBLY / PRE-OPERATION Read these Instructions and this manual In Its entirety before you attempt to assemble or operate your new snow thrower. Reading the entire manual will familiar ize you with t...

Page 9 - OPERATION; KNOW YOUR SNOW THROWER; F R; DANGER; ADANGER; A DANGER

OPERATION KNOW YOUR SNOW THROWER READ THIS OWNER'S MANUALAND ALL SAFETY RULES BEFORE OPERATING YOUR SNOWTHROWER. Oompare the illustrations with your snow thrower to famiiiarize yourseif with the iocation of various controis and adjustments. Save this manuai for future reference. These symbols may ap...

Page 15 - MAINTENANCE; MAINTENANCE SCHEDULE; GENERAL RECOMMENDATIONS

MAINTENANCE MAINTENANCE SCHEDULE FILL IN DATES AS YOU COMPLETE REGULAR SERVICE T R O w E R Check for Loose Fasteners ✓ ✓ Clean / Inspect Snow Thrower ✓ ✓ Check / Replace V-Belts ✓ Lubrication Chart ✓ ✓ Check Engine Oil Level ✓ Change Engine Oil ✓ Inspect Muffler ✓ Check / Replace Spark Plug ✓ Empty ...

Page 16 - Synthetic

MAINTENANCE AUGER GEAR CASE • The gear case was filled with lubricant to the proper level at the factory. The only time the lubricant needs attention is if service has been performed on the gear case, • If lubricant is required, use only Ronex ED #1 grease, TRACTION DRIVE SYSTEM DO NOT lubricate the...

Page 17 - SERVICE AND ADJUSTMENTS

SERVICE AND ADJUSTMENTS WARNING: To avoid serious injury, before performing any service or adjustments: A 1. Be sure the on/off switch is in the OFF position. 2. Remove safety Ignition key. 3. Make sure the augers and all moving parts have completely stopped.4. Disconnect spark plug wire from spark ...

Page 20 - STORAGE

STORAGE Immediately prepare your unit for storage at the end of the season or if the unit will not be used for 30 days or more. A WARNING: Never store the snow thrower with gasoline in the tank Inside a building where fumes may reach an open flame, spark or pilot light as on a furnace, water heater,...

Page 21 - TROUBLESHOOTING

TROUBLESHOOTING See appropriate section in manuai unless directed to a Sears service center/department. PROBLEM CAUSE CORRECTION Does not start 1. Fuel shut-off valve (If so equipped) In OFF position. 1. Turn fuel shut-off valve to OPEN position. 2. Safety Ignition key Is not Inserted. 2. Insert saf...

Page 35 - REPAIR PARTS

REPAIR PARTS CHASSIS/PULLEYS SNOW THROWER - - MODEL NUMBER 944.529571 KEYNO. PARTNO. 423185X615 DESCRIPTION ENGINE MOUNT PLATE KEY PART NO. NO. C'-'C* p.Jr^ '''OSLii 1 2 3 418694X615 150406 428867 DESCRIPTION B&S ENGINE MODEL 20M314-1370-E2 FRAME BOLT 3/8-16SOREW 5/16-18 X .750 NOTE: All compone...

Page 47 - SERVICE NOTES

Page 48 - Sears Parts and Service

Get it fixed, at your home or ours! Just Call: 1-800-4-MY-HOME® ( 1 - 800 - 469 - 4663 ) 24 hours a day, 7 days a week For the repair of major brand appliances in your own home... no matter who made it, no matter who sold it! For your nearest Sears Parts and Service location, to bring in products li...