Sears 919.18416- Manuals

Page 2 - TABLE OF CONTENTS; SAFETY GUIDELINES - DEFINITIONS; AWARNING

TABLE OF CONTENTS Page SAFEW GUIDELINES..................................................................................... 2 WARNING CHART........................................................................................ 3 SPECIFICATION CHART.....................................................

Page 3 - IMPORTANT SAFETY INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS • SAVE THESE INSTRUCTIONS * AWARNING IMPROPER OPERATION OR MAINTENANCE OF THIS PRODUCT COULD RESULT IN SERIOUS INJURY AND PROPERTY DAMAGE. READ AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFORE USING THIS EQUIPMENT. HAZARD WHAT CAN HAPPEN HOW TO PREVENT IT A...

Page 5 - SPECIFICATION CHART; GLOSSARY; ACCESSORIES FOR USE WITH SEARS AIR COMPRESSORS

SPECIFICATION CHART Model No. Horsepower Displacement CFM at Max. Pressure Bore Stroke Voltage - Single Phase Minimum Branch Circuit Requirement ‘Fuse TypeAmperage at Max. Pressure Air Tank Capacity - Gallons Approximate Cut-in Pressure Approximate Cut-out Pressure SCFM@ 90 psig SCFM@ 40 psig UL Lis...

Page 6 - INSTALLATION AND BREAK-IN PROCEDURES; Location of the Air Compressor

GENERAL INFORMATION You have purchased an air compressor unit consisting of a two cylinder, single stage air compressor pump, an ASME air tank, associated controls and instruments. This air compressor must be permanently mounted in place. Your air compressor can be used for operating paint spray gun...

Page 7 - Piping

INSTALLATION AND BREAK-IN PROCEDURES (Cont.) AWARNING EXCESSIVE VIBRATION MAY WEAKEN THE AIR TANK AND CAUSE AN EXPLOSION. THE OUTFIT MUST BE MOUNTED AS DESCRIBED AND ILLUSTRATED BELOW. SS-IS25-CD 3/e FLAT WASHER (SUPPLIED ON LEGS AS PART OF PACKAGING) CAC-1003 ISOLATOR WASHER (SUPPLIED IN PARTS KIT)...

Page 8 - ACAUTION; OPERATING PROCEDURES; MAINTENANCE

Break-In Procedures ACAUTION Serious damage may result if the following break-in instructions are not closely followed. This procedure is required only once; before the air compressor is put into service. Some form of piping or shut-off valve must be installed before beginning the break-in procedure...

Page 10 - Pulley and Flywheel - Alignment; TROUBLESHOOTING GUIDE

NOTE The belt shoul d be centered over the g rooves on the flywheel and motor pulley. 6. Push the motor back into regular position and tighten bolts securely. Proper tension is approxi mately 1/4" belt deflection measured midway be tween the pulley and flywheel when a 3 pound weight or equival...

Page 12 - AIR COMPRESSOR DIAGRAM

Page 13 - PARTS LIST

PARTS LIST KEY NO. PART NUMBER DESCRIPTION 1 SSF-953-ZN Self Tapping Screw 10x5/8 (6 used) 2 CAC-22-2 Belt Guard 3 SSF-8113-ZN Lock Nut 4 CAC-2-1 Bracket 5 CAC-362-1 Belt Guard Closure 6 SSP-9401 Connector Body 7 SSP-7812 Nut-Sleeve Assembly 1/2“ (2 used) 8 SSP-7811 Nut Sleeve Assembly 1/4" 9 SS...

Page 14 - COMPRESSOR PUMP DIAGRAM

COMPRESSOR PUMP DIAGRAM 66 (oil (ill plug) 66 (oil drain plug) 14 - Eng

Page 16 - SINGLE STAGE

OWNERS MANUAL MODEL NO. 919.184160 When requesting service or ordering parts, always provide the following information: • Model Number • Part Number • Part Description • Name of Item FULL ONE YEAR WARRANTY AIR COMPRESSOR If this air compressor fails due to a defect in material or workmanship within ...