Sears 721.85062- Manuals

Page 2 - ENGLISH; YOUR SAFETY FIRST; BEFORE YOU START; • Proper installation is the installer's responsibility!; Figure 1; See Figure 2; BE SURE TO READ THE FOLLOWING SAFETY INSTRUCTIONS:; Figure1; AVOID ELECTRICAL SHOCK!; YOU COULD GET AN ELECTRIC SHOCK; IF YOU DO NOT DISCONNECT THE POWER, YOU COULD GET AN ELECTRIC SHOCK.; WARNING

2 ENGLISH YOUR SAFETY FIRST BEFORE YOU START • Proper installation is the installer's responsibility! - Read the entire manual before you begin. - The model number label is located on the oven front of oven behind doon See Figure 1 . - Mounting plate is located on back side of microwave oven. See Fi...

Page 3 - excessive microwave energy.; DO NOT USE A FUSE IN THE NEUTRAL OR GROUNDING CIRCUIT.; • THIS APPLIANCE MUST BE GROUNDED!; • DO NOT, UNDER ANY CIRCUMSTANCES, REMOVE; MUST; Figure 3

3 ENGLISH YOUR SAFETY FIRST ENGLISH If you do not use the microwave oven as instructed, you could be exposed to excessive microwave energy. If you use the grounding plug improperly, you risk electric shock and or fire! - Check with a qualified electrician if you are not sure whether the oven is prop...

Page 4 - • MAKE SURE YOU HAVE ENOUGH SPACE AND SUPPORT.; Do not use a plastic cover.; CAUTION; Figure 4

YOUR SAFETY FIRST 4 ENGLISH • MAKE SURE YOU HAVE ENOUGH SPACE AND SUPPORT. - Mount the oven against a flat, vertical wall, so that it is supported by the wall. The wall should be constructed of minimum 2" x 4" wood studding and 3/8" thick drywall or plaster/lath. - ATTACH AT LEAST ONE of...

Page 5 - THE FOLLOWING PARTS ARE SUPPLIED WITH THE OVEN:; One rear wall template -; Not Actual Size

5 ENGLISH PARTS, TOOLS, MATERIALS 12 REAR WALL TEMPLATE B. A. F. CUT OUT FOR WALL VENTED ONLY 12 REAR WALL TEMPLATE B. A. F. CUT OUT FOR WALL VENTED ONLY ENGLISH THE FOLLOWING PARTS ARE SUPPLIED WITH THE OVEN: NOTE: Depending on your ventilation requirements, you may not use all of these parts. 12 R...

Page 6 - Pencil; Plumb line; Caulking gun

6 ENGLISH PARTS, TOOLS, MATERIALS YOU WILL NEED THE FOLLOWING TOOLS AND MATERIALS FOR THE INSTALLATION: Carton or other heavy material for covering the counter top. Clear tape (for taping the templates to the wall). Phillips screwdriver Pencil Flat blade screwdriver Plumb line Measuring tape • If yo...

Page 7 - STEP 1 : PREPARE THE ELECTRICAL CONNECTIONS; AVOID ELECTRICAL SHOCK! THIS APPLIANCE MUST BE GROUNDED!; Figure 5; Figure 5; • DO NOT, UNDER ANY CIRCUMSTANCES, REMOVE THE POWER SUPPLY CORD

7 ENGLISH STEP 1 : PREPARE THE ELECTRICAL CONNECTIONS AVOID ELECTRICAL SHOCK! THIS APPLIANCE MUST BE GROUNDED! 1. Locate the grounded electric outlet for this oven in the cabinet above the oven, as shown in Figure 5 . NOTE: The outlet should be on a circuit dedicated to the microwave oven (120V, 60H...

Page 8 - Figure 7; Figure 9; Figure 6; Figure 9; Figure 8; clearance within the wall for the exhaust duct.; REMEMBER AS YOU INSTALL THE VENTING:; STEP 2 : PREPARE THE VENTING SYSTEM; THIS OVEN MUST BE PROPERLY VENTED!; Room Venting

8 ENGLISH NOTE: The ductwork you need for outside ventilation is not included with your oven. The standard ductwork fittings and length are shown in Figure 10 , page 9. You may vent your oven in one of three ways. Do Not vent into a wall cavity, an attic, or an unused area. Roof Venting: If your ove...

Page 9 - STANDARD FITTINGS; must not

9 ENGLISH STEP 2 : PREPARE THE VENTING SYSTEM STANDARD FITTINGS NOTE: If the existing duct is round, you must use a rectangular-to-round adapter, with a rectangular 3" extension duct installed between the damper assembly and the adapter to prevent the exhaust damper sticking. DUCT LENGTH The tot...

Page 10 - STEP 3 : PREPARE THE VENTING BLOWER; DO NOT PULL OR STRETCH THE BLOWER WIRING!; Before You Start; at source by removing fuse or throwing circuit breaker.

10 ENGLISH STEP 3 : PREPARE THE VENTING BLOWER DO NOT PULL OR STRETCH THE BLOWER WIRING! Pulling and stretching the blower wiring could result inelectrical shock. • Your microwave oven is shipped with the blower assembled for room venting. If you want wall-venting or roof-vented installation, you mu...

Page 12 - STEP 4 : PREPARE THE WALL AND UPPER CABINET FOR INSTALLATION; MEASURE AND TACK / TAPE UP; oven if you cannot find a wall stud.

12 ENGLISH STEP 4 : PREPARE THE WALL AND UPPER CABINET FOR INSTALLATION MEASURE AND TACK / TAPE UP THETEMPLATE 1. Using a plumb line and measuring tape, find and mark the vertical center line V V on the back wall, as in Figure 24 . 2. Find and mark one or two points where the studs are on the wall. ...

Page 13 - Drill the Holes in the Wall and Upper cabinet; supply cord hole with the power supply cord bushing.

13 ENGLISH STEP 4 : PREPARE THE WALL AND UPPER CABINET FOR INSTALLATION Drill the Holes in the Wall and Upper cabinet 1. Drill holes on the circles. If there is a stud, drill a 3/16" hole for lag screws. If there is no stud, drill a 3/4" hole for toggle screws. Make sure to use at least 1 la...

Page 14 - STEP 5 : INSTALL THE MOUNTING PLATE TO THE WALL; THE OVEN MUST BE CONNECTED TO

14 ENGLISH A B C A C B D E E D STEP 5 : INSTALL THE MOUNTING PLATE TO THE WALL THE OVEN MUST BE CONNECTED TO AT LEAST ONE WALL STUD 1. Draw a vertical line on the wall at the center of the 30" wide space. Use the mounting plate as the template for the rear wall. Place the mounting plate on the w...

Page 15 - STEP 5 : INSTALL THE MOUNTING PLATE TO THE WALL

15 STEP 5 : INSTALL THE MOUNTING PLATE TO THE WALL ENGLISH FOR WALL-VENTING • Make the box cutout for the rear wall duct. - 1 piece mounting plate: Using a pencil, put dots through slots F and G, and through holes H and I. Remove the mounting plate and draw lines extending through the points. This w...

Page 16 - STEP 6 : ATTACH THE OVEN TO THE WALL; install this microwave oven.

16 ENGLISH STEP 6 : ATTACH THE OVEN TO THE WALL 1. Carefully lift microwave oven and hang it on support tabs (See Figure 28 ) at the bottom of the mounting plate. Reaching through upper cabinet, thread power supply cord through the power supply cord hole in the bottom of the upper cabinet. See Figur...

Page 18 - MEMO

Page 20 - Impreso en China