Page 2 - WARNING; This manual covers the operating instructions
FAILURE TO FOLLOW SAFE OPERATING PRACTICES MAY RESULT IN SERIOUS INJURY. * Keep all safety shields in place.* Before performing any maintenance or service, stop the machine and remove the spark plug wire.* If a mechanism becomes clogged, stop the engine and wait for all moving parts to come to a com...
Page 3 - DIRECTION REFERENCE; DANGER
1 1.1 INTRODUCTION This manual has been prepared to provide theinformation you need to correctly assemble, operate,and maintain this grass catcher. Read it carefully andkeep it for future reference. The replacement of any part on this product by otherthan the manufacturer's authorized replacement pa...
Page 4 - ASSEMBLY INSTRUCTIONS; Remove all packaging materials. Lay out the; CUTTER DECK SHOWN
2 3.1 ASSEMBLY INSTRUCTIONS -NOTE- Use the illustrated parts list as a partnumber reference when following theassembly instructions. 1. Remove all packaging materials. Lay out the mounting hardware and the catcher assemblyparts for easy access. Prepare the work areamaking sure that it is a clean, sa...
Page 5 - VIEW FROM RIGHT SIDE; Install the blower assembly to the mounting
3 DISCHARGE CHUTE OPENING FRONT OF CUTTER DECK REAR OF CUTTER DECK VIEW FROM RIGHT SIDE OF CUTTER DECK Figure 2-52"GC-STT install art CUTTER DECK BELL CRANK LIFT LINK SPACER SPACER NUT NUT WASHER BOLT, 3/8-16 x 1-1/2" BOLT, 3/8-16 x 1-1/4" 52" Cutter Deck FIGURE 3-3 8. Install the bl...
Page 6 - MOUNTING PIN
4 FIGURE 3-5 RIGHT SIDE OF CUTTER DECK SHOWN (Note: Some parts not shown for viewing purposes.) 2006 GC-STC-V install art 3 BLOWER ASSEMBLY MOUNTING BRACKET MOUNTING PIN TIGHTEN MOUNTINGBRACKET HARDWARE HAIRPIN QUICKPIN FIGURE 3-4 61" Cutter Deck DISCHARGE CHUTE OPENING FRONT OF CUTTER DECK REAR...
Page 10 - MAINTENANCE CHART - RECOMMENDED SERVICE INTERVALS; MAINTENANCE; HOURS; GREASE FITTING
8 5.1 MAINTENANCE CHART - RECOMMENDED SERVICE INTERVALS * Perform these maintenance procedures more frequently under extreme dusty or dirty conditions. MAINTENANCE HOURS Break-In 8 20 40 100 200 500 Procedure Comments (First 10) X Check all hardware for tightness X Inspect hose and adapter X Check b...
Page 11 - NOTES
Page 22 - LIMITED WARRANTY- COMMERCIAL ACCESSORY
LIMITED WARRANTY- COMMERCIAL ACCESSORY Any part of the Scag commercial accessory manufactured by Scag and found, in the reasonable judgment of Scag,to be defective in material or workmanship, will be repaired or replaced by an Authorized Scag Service Dealer withoutcharge for parts and labor. The Sca...
Page 23 - PRINTED IN USA
PART NO. 03181 PRINTED 7-2005 PRINTED IN USA © 2005SCAG POWER EQUIPMENTDIVISION OF METALCRAFT OF MAYVILLE, INCWWW.SCAG.COM