Sanyo TVQ-EXA089K - Manuals

6 2 Dimensions 2.1 External Dimensions 2.2 Footprint * Dimensions given in inches and millimeters (mm in parentheses). ① Waste Outlet ② Electrical Field Connection ③ Refrigeration Outlet (8-, 12-ft models) (End Case)

7 3 Unloading and Carpentry Procedures 3.1 NSF Certification The merchandisers described in this manual are built to meet the requirements of American National Standard/NSF International Standard 7. Each merchandiser bears a nameplate identifying the type of application for which it was certified: T...

9 3.7 Joining Instructions 3.7.1 Applying gasket (for connecting cases or installing side panels). ① Make sure that all merchandisers are resting level. ② Make sure that all required parts for joining are present (gasket, bolts, joint covers, nuts, etc.). ③ Remove wire racks, deck pans, and air gril...

12 3.8 Installing side panels ① Apply gasket as indicated below. ② Temporarily fix the side panel in place with M8 bolts as indicated (see right). Pass bolts through connection holes in the sides of the 8-ft/ 12-ft wide island cases, then finish fixing the bolts in place from the 8-ft/ 12-ft case si...

14 3.10 Installing handrail and bumper Attaching the Bumper 1. Attach Maintenance Bumper (length 39-3/8 inches) to bumper brackets over the electrical connection box (“raceway”) on each merchandiser. The raceway is located on the right end of each merchandiser. 2. Attach Full-Length Bumpers between ...

15 4 Refrigeration, Plumbing & Electrical Procedures 4.1 Piping (Plumbing, Refrigeration) ● U-trap installation Install U-trap referring to the drawing below. ● Sealing the refrigerant pipe opening Seal pipe completely. Insufficient sealing may cause the following problems: • Insufficient coolin...

16 4.2 Electrical Data Please refer to Specifications section and nameplate attached to merchandiser for electrical information. 4.3 Electrical – Guidelines & Precautions All wiring and electrical field work must comply with the National Electrical Code (“NEC”) and other applicable local codes. ...

19 5 Operation 5.1 Load Limits In order to maintain proper temperature and unit performance, the air curtain in each merchandiser must remain unobstructed: • Do not stock shelves beyond the marked load limits. • Do not block discharge or return air grilles. • Do not block airflow in any other way (w...

20 5.2 Installing FDA/NSF Thermometer Magnet The suggested locations for the thermometers required by NSF/ANSI 7 and the FDA Food Code are indicated above. It is the responsibility of the purchaser/end user of this product to determine the locations within the food storage area that best meet these ...

21 6 Care and Cleaning Guidelines In order to keep merchandisers sanitary and in good working order, we recommend thorough periodic cleaning as follows: 6.1 Daily Cleaning 6.1.1 Exterior Panels a. Exterior panels should be cleaned with water only. Wet a soft cloth and wring it out to wipe down panel...

22 7 Service 7.1 Replacing Fan Motors and Blades To replace the fan motors: ① Unplug the fan motor harness and remove socket covers. ② Push fan motor harness through hole in plenum. ③ Detach fan motor mounting bracket from plenum and pull up to remove.