Sanyo RCS-SH1UA - Manuals

1 1 - 4 Air outlet Cellingpanel(optional) Names of Parts INDOOR UNIT SEMI-CONCEALED X type (4-WAY) Air outlet Air intake WALL-MOUNTED K type Air intake Air outlet CEILING-MOUNTED T type Air intake CONCEALED DUCT U type Air outlet(optional) Ceiling Air intake(optional) REMOTE CONTROL UNITS (optional)...

1 1 - 5 O: VENTILATION button G: CHECK button Remote Cotrol Unit • With this remote controller, you can operate indoor units up to 8 units. • Once you set your operation conditions, you can operate the units only by pressing the ON/OFFoperation button. • For the U type, the flap position is not show...

1 1 - 9 To warm up the system, the power mains must be turned on at least five (5) hours before operation. STEP 1 To start the air conditioner Press the operation button (ON/OFF button). STEP 2 Setting the mode Press the MODE button to select the mode of your choice. [ (AUTO), (HEAT), (DRY), (COOL) ...

1 1 - 10 Adjusting the Airflow Direction I Semi-concealed type 4-way type (X) This air conditioner is equipped with auto flaps.You can set the airflow direction to a specific angle or to the sweepmode using the remote control unit. (Refer to the description of theremote control unit.) Do not move th...

1 1 - 11 Adjusting the Airflow Direction (continued) I Wall mounted type (K) A. Vertical directions (automatic) Confirm that the remote control unit has been turned on. Press the FLAPbutton to start the flap moving up and down. If you want to stop theflap movement and to direct the air in the desire...

1 1 - 12 Special Remarks • Once the room temperature reaches the level that was set, the unitrepeats the cycle of turning on and off automatically. • In order to prevent the humidity in the room from rising again, the indoorfan also turns off when the unit stops operating. • The fan speed is set to ...

1 1 - 13 Setting the Timer Use this mode to turn off the appliance automaticallyafter the length of time set. Use this mode to turn the appliance off automaticallyafter the same set time every time. Use this mode to start the appliance automatically afterthe length of time set. When two remote contr...

1 1 - 15 Care and Cleaning 1. For safety, be sure to turn the air conditioner off and also to disconnect the power before cleaning. 2. Do not pour water on the indoor unit to clean it. This will damage the internal components and cause an electric shock hazard. Clean the air intake and outlet side o...

1 1 - 17 Troubleshooting If your air conditioner does not work properly, first check the following points before requesting service. If it stilldoes not work properly, contact your dealer or a service center. Tips for Energy Saving Avoid • Do not block the air intake and outlet of the unit. If eithe...

2 Save These Instructions! RCS-SH80UA.WL RCS-BH80UA.WLRCS-SH1UA • INSTRUCTION MANUAL Wireless Remote Controller for SplitSystem For information on installing the wireless remote controller, refer to the INSTALLATION INSTRUCTIONSaccompanying the outdoor unit. 05-368 PAC-i_IM_Sec2 12/7/05 4:36 PM Page...

2 2 - 5 Unit Display and Operation Controller for K, X, and T Types (continued) SERVICINGswitches ON/OFF operation button This button is for turning the air conditioner on and off (automatically setting cooling or heating operation). SWEEP button Use this button to make the airflow direction sweep u...

2 2 - 8 Using the Wireless Remote Controller (continued) When using the wireless remote controller, always point the unitʼs transmitterhead directly at the air conditionerʼs receiver. The wireless remote controller can be operated from either a non-fixed posi-tion or a wall-mounted position.To ensur...

2 2 - 12 Description A: When you press the SENSOR button, the (SENSOR) indicator appears or disappears. B: The currently selected operation mode is displayed. C: When setting the timer, the selected timer mode is displayed. D: The currently selected FAN SPEED, FLAP ANGLE and SWEEP statusare displaye...

2 2 - 15 Special Remarks • Because this appliance heats a room by utilizing the heat of the outsideair (heat pump system), the heating efficiency will fall off when theoutdoor temperature is very low. If sufficient heat cannot be obtained withthis heat pump, use another heating appliance in conjunct...

3 3 - 4 How to Use the System Controller I Functions of buttons A: ALL/ZONE/GR SELECT button Use this button to select one of the following: ALL: Used for turning all the air conditioners on and off. ZONE: Used for turning all the air conditioners of each zone on andoff. GR: Used for turning all the...