Samsung 524 - Manuals

Samsung 524 – Manual in PDF format online.

Manuals:

Manual

Manual Samsung 524

Summary

Page 2 - • You can select one of five sound; Time saving function; ENG; Feature; TO PREVENT ELECTRICAL SHOCK,; CAUTION; TO PREVENT DAMAGE WHICH MAY

The number on this symbol representsthe reference page. Mutual responsive dialogic picture By adopting dialogic method (if youselect one menu, another picture isdisplayed) everybody can easily executethe next operation and verify optionalconditions. One method makes every operation easy By identifyi...

Page 3 - Symbols; Press Push Important Note; You have just purchased; Contents

☛ ➢ Symbols Press Push Important Note 3 ENG ne e e n You have just purchased a SAMSUNG television. Please take the time to read these instructions, as they will enable you to set up your television easily. Contents ◆ C ONNECTING AND P REPARING Y OUR T ELEVISION ■ Feature ...............................

Page 4 - Safety Instructions

4 ENG Place this TV on a stable stand ortable. Avoid exposing the TV set todirect sunlight and other sourcesof heat. Do not step on or twist thepower cord. Adequate ventilation is essentialto prevent failure of electricalcomponents. Do not attempt to disassemblethis TV set yourself. Do not overload ...

Page 5 - Rear of TV; Inserting the Batteries in the Remote Control; Connecting the Aerial (or Cable Television Network)

5 You must insert or replace the batteries in the remote control whenyou : ◆ Purchase the television. ◆ Find that the remote control is no longer operatingcorrectly. 1 Remove the cover on the underside of the remote control by sliding it offwith your thumb. 2 Insert two AAA or equivalent batteries p...

Page 6 - MODEL NAME; How to Use this Manual

➣ Function available refer to: TELETEXT STEREO PIP 6 MODEL NAME TTX STEREO 109cm 132cm NICAM A2 SP434JMF SP521/ 524JMF O O O SP434PTR SP521/ 524PTR O O O ENG 1 Check the Model Number of your TV set; the Model Number is shown onthe rear cover name plate on the set. Use the table below to confirm whic...

Page 7 - Method 1; Outdoor Antenna Connections; Round 75-ohm coaxial cable; VHF Antenna; Antenna Connections

7 ENG on ch w e, h VHF/UHF 75 Ω Method 1 Method 2 Outdoor Antenna Connections Round 75-ohm coaxial cable Flat 300-ohm twin lead cable Round 75-ohm coaxial cable Rear of TV VHF/UHF Antenna VHF Antenna Antenna Connections 11318A#2 8/17/05 12:42 PM Page 7

Page 8 - Video Connections

8 ENG Video Connections R I AUDIO I L (MONO) VIDEO3 INPUT S-VIDEO2 INPUT VCR AUDIO OUT (R) (L) VIDEO OUT S-VIDEO 2 INPUT VIDEO IN 3 VIDEO (MONO) L-AUDIO-R VCR AUDIO OUT (R) (L) VIDEO OUT S-VIDEO1 VHF/UHF 75 Ω WIRELESSHEADPHONE MONITOR -OUT AV-2 VIDEO AV-1 L-AUDIO-R (MONO) VCR AUDIO OUT (R) (L) VIDEO...

Page 9 - Self Checkup Function

9 ENG Video Connections (cont.) 1 Connect an optional AUDIO/VIDEO cable from the VIDEO OUT jack on the rear of the VCR to the VIDEO IN jack onthe rear of the TV. 2 Connect another optional audio/video cable from the AUDIO OUT jacks on the rear of the VCR to the AUDIO IN jackson the rear of the TV. ◆...

Page 12 - Audio Connections

12 ENG 1 Adjust the volume of the TV to minimum. 2 Connect an optional audio/video cable from the Audio out jacks on the rearof the TV to the AUDIO IN jacks on the AUDIO. 3 Position the INPUT SELECTION switch on the audio to AUX and adjustthe volume. ➣ ◆ You can hear a more vivid stereo sound throug...

Page 13 - Front Control; Front of TV

13 ENG MUTE V O + L V - O L CH CH TV/VIDEO MENU R I AUDIO I L (MONO) VIDEO3 INPUT S-VIDEO2 INPUT Menu Button TV/ Video Selection Button Mute Button Volume Up/Down Button Channel Up/Down Button Audio Input Terminal Video Input Terminal S-Video Terminal Audio Input Terminal Video Input Terminal S-Vide...

Page 14 - The Control Range of Transmitter.; Remote Controls

14 ENG P PF M POWER TV/VIDEO SLEEP DISPLAY MUTE 3 1 2 6 4 5 9 7 8 P/C -/-- 0 S.STD SURROUND S.MODE P.STD MENU P.MENU CH VOL VOL SWAP CH SCAN STILL ROTATE MULTI PinP ON + LIST/FLOF MIX INDEX TV/TEXT CANCEL STORE SUBPAGE F/T/B HOLD PAGE REVEAL CONV. ESCAPE R/B i ? Mute buttonDisplay button Direct Chan...

Page 15 - You can execute every operation by pressing CH; Switching your Television On and Off

15 ENG 1 Plug the mains lead into an appropriate wall socket. ☛ The main voltage is indicated on the rear of the TV set andthe frequency is 50Hz or 60Hz. 2 Press the POWER button on the front panel to switch the television on. ◆ If you have already stored channels, the channel selected when youlast ...

Page 17 - Area Select by Country; AREA; TV Channel selection mode

17 ENG he to d ce g ns in e. e i s s Area Select by Country AREA Asia/W. Europe CIS/E. Europe China Hongkong/UK Australia NZ/Indonesia South Africa America TV SYSTEM B/G,H: West European TV Standard D/K: East European TV Standard D/K: China TV Standard I: British TV Standard (UHF Only) B/G,H: Austra...

Page 18 - When storing channels manually, you can choose:

18 ENG M When storing channels manually, you can choose: ◆ Whether or not to store each of the channels found. ◆ The number by which you wish to identify each stored channel. Method 1: To memorise channels by searching channels. 1 Press the MENU button on the TV set. ◆ Move to “Setup” option by pres...

Page 19 - Method 2 : To memorise channels by searching frequency.

19 ENG Method 2 : To memorise channels by searching frequency. 1 Press the MENU button on the TV set. ◆ Move to “Setup” option by pressing CH ▲ or CH ▼ buttons and press the VOL+ or VOL– buttons. 2 Move to “Manual store” option by pressing CH ▲ or CH ▼ buttons and press the VOL+ or VOL– buttons. ◆ P...

Page 21 - red

21 If the reception is clear, you do not have to fine-tune the channel,as this is done automatically during the search and store operation. If however the signal is weak or distorted, you may have to fine-tune the channel manually. 1 Press the MENU button on the TV set. ◆ Move to “Setup” option by p...

Page 22 - You can exchange the numbers of two channels, in order to:

22 ENG Bo Y e You can exchange the numbers of two channels, in order to: ◆ Modify the numeric order in which the channels have beenautomatically stored. ◆ Give easily remembered numbers to the channels that youwatch most often. 1 Press the MENU button and move to “Setup” option. ◆ Press VOL + or VOL...

Page 23 - Picture Adjustment

23 ENG By pressing the P.STD button, you can sequentially select any oneof the five possible preferred analogue picture presets. 1 Press the P.STD button. ◆ Whenever this button is pressed, the mode will be changed as follows. ➞ Custom ➞ Standard ➞ Dynamic ➞ Movie ➞ Mild Custom Select this mode to v...

Page 24 - Picture Menu Adjustment

24 ENG e.g. Brightness Adjustment by “P.MENU” button. 1 Press the “P. MENU” button on the remote control. ◆ “Picture” menu is displayed. 2 Move to “Brightness” by pressing the CH ▲ or CH ▼ button and press the VOL+ or VOL–button. 3 Adjust “Brightness” by VOL+ or VOL – buttons. 4 When you have finish...

Page 25 - Custom; Sound Adjustment

25 ENG e y There is a choice of four audio settings. By pressing the S.STDbutton any one of the five settings can be in the sequenceillustrated. 1 Press the S.STD button. ◆ whenever this button is pressed, the mode will be changed as follows. ➞ Custom ➞ Standard ➞ Music ➞ Movie ➞ Speech Custom Selec...

Page 26 - Mono; Stereo Mode Functions

26 By pressing the S. MODE button, you can determine the way in which the audio signal is produced at theloudspeakers and AV output. ➣ 1. When the power is switched ON, the mode is automatically preset at either “DUAL-I” or “STEREO”, depending on the current transmission. 2. When the receiving condi...

Page 27 - NOISE TIMER Mode; Setting the Timer

”, D rt, n ce m 27 ENG You can select a time period of between 15 and 180 minutes afterwhich the television automatically switches to standby mode. 1 Press the SLEEP button. ◆ Whenever this button is pressed, the time will be changed. Off ➞ 15 ➞ 30 ➞ 45 ➞ 60 ➞ 90 ➞ 120 ➞ 150 ➞ 180 ➞ Off ◆ During the...

Page 28 - If this happens, refer to “Clock” on the previous page.; Setting the On/Off Timer

28 PC L B N L D ENG By setting the ON/OFF time, the set carries out alarm and automatic off function. 1 Press the MENU button. ◆ The “Menu” picture is displayed on the screen. 2 Move “Time” option by pressing the CH ▲ or CH ▼ buttons and press the VOL+ or VOL– buttons. ◆ “Time” picture is displayed ...

Page 29 - Extra Functions

29 ENG Press the MENU button. Move to a function by pressing the CH ▲ or CH ▼ button. Adjust it by pressing the VOL+ or VOL– button. Language ◆ To view the “MENU” mode with the language spokenin your Area. Blue screen ◆ When no picture signal is input, or the signal is weak,the screen reverts to a b...

Page 31 - On the condition of Multi PIP it is impossible to execute

31 ENG y s e ”, CH VOL VOL SWAP CH SCAN STILL ROTATE MULTI PinP ON LIST/FLOF MIX INDEX TV/TEXT CANCEL STORE SUBPAGE F/T/B HOLD PAGE REVEAL CONV. ESCAPE R/B i ? ➣ Preference : Concerning the functions of “PinP : On”. PIP ON/OFF button ◆ Press this button to operate ON/OFF function of PIPon the remote...

Page 32 - changes to white; button on the remote control.; ESCAPE; button to switch to the TV mode. And; Convergence Adjustment

32 ENG TV SU IN CA TealTadTeoTTeT ➝ ➝ ➝ ➝ ➝ Red (or Blue) LIST/FLOF MIX INDEX TV/TEXT CANCEL STORE SUBPAGE F/T/B HOLD PAGE REVEAL CONV. ESCAPE R/B i ? If Color blurring occurs on the picture or picture is out of focus,press the CONV. for adjustment.Upon completion of the adjustment, the color of “ “...

Page 33 - SUBPAGE button; CANCEL Button; Teletext Operation

33 ENG TV/TEXT button ◆ Press this button to change from TV to teletext mode. ( ) ◆ Press again this button to change back to TV mode. SUBPAGE button ◆ To view a particular subpage, after pressing this button, the subpage number with the numeric buttons. ( ) Press the “SUBPAGE” button again to resto...

Page 34 - NUMERIC button; Press the TTX button to return to TELETEXT mode.

34 ENG ➣ Teletext Operation F/T/B button ◆ This function is used when the characters on the TV screen are hard to read. Pressing it the 1st time expands ( ) the TOP half of the display only. Pressing it the 2nd time expands the bottom half of the display only. Pressing it the 3rd time returns the di...

Page 35 - LIST mode

35 ENG 1 (Teletext must be selected first.) Select the “list” mode by pressing the LIST/FLOF button ( ). Pressing this button will switch between the “LIST and FLOF” modes. 2 To select a memory position, press one of the “colour-coded” buttons. 3 Enter the page number of the desired teletext page by...

Page 36 - Specification

36 ENG ➣ For cable channels in “America” area the actual channel may be different from that shown in the table. AREA RECEIVE CHANNEL CH. ASIA/ CIS/ CHINA HK/UK AUSTR- NZ/IN- SOUTH AMERICA CABLE DISPLAY W.EUROPE E.EUROPE ALIA DONESIA AFRICA OTHERS AMERICA 00 – – – – 0 – – – – – 01 – 1 1 – 1 1 – – 01 ...

Page 38 - Trouble Shooting

38 ENG No picture. ◆ Not plugged into A.C. supply. No sound. ◆ Not switched on. ◆ Check contrast, brightness and volume settings. Normal picture. ◆ Check volume level. No sound. ◆ Check sound mute button on remote control. ◆ Check system No colour. ◆ Check colour level. Normal sound. ◆ Check system ...

Page 39 - Memo

Page 40 - – AFTER SALES SERVICE; – Do not hesitate to contact your retailer or service agent; ELECTRONICS

– AFTER SALES SERVICE – Do not hesitate to contact your retailer or service agent if a change in the performance of your product indicatesthat a fault condition may be present. ELECTRONICS AA68-11318A (ENG) 11318A#3 8/17/05 12:44 PM Page 40