Page 3 - by warranty. In addition to following recommended installation; SAFETY INFORMATION; ATTENTION; Unplug the refrigerator before cleaning and making repairs.; PROPER GROUNDING REQUIRED
NOTICE: Loss or spoilage of products in your refrigerator/freezer is not covered by warranty. In addition to following recommended installation procedures you must run the refrigerator/freezer 24 hours prior to usage. SAFETY INFORMATION WARNING: Use this appliance for its intended purpose as describ...
Page 4 - APPLIANCE DISPOSAL
■ Make sure that the unit is not resting on or against the electrical cord and plug. ■ To minimize personal injury, do not hang on the drawers. ■ Do not store any flammable and explosive gas or liquids inside the unit. ■ Do not attempt to alter or tamper with the electrical cord. APPLIANCE DISPOSAL ...
Page 5 - INSTALLATION/OPERATION; UNCRATING; Install the unit on strong and leveled surfaces
INSTALLATION/OPERATION IMPORTANT!!! PLEASE READ BEFORE INSTALLATION ■ If the unit has recently been transported, please let unit stand still for a minimum of 24 hours before plugging it in. ■ Make sure that the unit drops down to desired temperature before loading the unit with product. ■ Maker sure...
Page 6 - ELECTRIC INSTALLATION & SAFETY; INFORMATION; SETUP
■ Select a location away from heat and moisture-generating equipment - high ambient temperature will cause the compressor to overwork, leading to higher energy bills and gradual breakdown of the unit. - malfunction due to high ambient temperature will void warranty ELECTRIC INSTALLATION & SAFETY...
Page 7 - A. Open drawer completely. Roller clips will be in the down position.
REMOVAL A. Open drawer completely. Roller clips will be in the down position. B. While holding the sides of the drawer, use your hands to lift side track of drawer C. Lift drawer and remove from channel.
Page 8 - A.Lower rear rollers into channel slots.
INSTALLATION A.Lower rear rollers into channel slots. B. make two side tracks of drawer horizontal, lower front rollers into channel. C. Make sure drawer tracks are in the right position.
Page 9 - OPERATIONS; STARTUP; MAINTENANCE AND CLEANING; CLEANING THE CONDENSER COIL
OPERATIONS STARTUP A. The compressor is ready to operate. Plug in the cooler. B. DIGITAL THERMOSTAT are factory-set to give refrigerators an approxiate temperature of 35°F, Allow unit to function several hours, completely cooling cabinet before changing the control setting. Temperature Control Locat...
Page 11 - grain
examples of items that can be abrasive to stainless steel’s surface. • Deposits left on stainless steel can leave spots. Hard water can leave spots. Hard water that is heated can leave deposits if left to sit for too long. These deposits can cause the passive layer to break down and rust stainless s...