Ryobi Ry30002, Ry30002a, Ry30041, Ry30041a - Manuals

Page 6 SYMBOLS The following signal words and meanings are intended to explain the levels of risk associated with this product. SYMBOL SIGNAL MEANING DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death orserious injury. WARNING: Indicates a potentially haz...

Page 7 UNPACKING INSTRUCTIONS ■ ■ ■ ■ ■ Carefully remove the product from the carton. ■ ■ ■ ■ ■ Inspect the product to make sure no breakage ordamage occurred during shipping. ■ ■ ■ ■ ■ Do not discard the packing material until you haveinspected and operated the product. ■ ■ ■ ■ ■ If any parts are d...

Page 8 FEATURES Fig. 1a THROTTLE TRIGGER STARTER GRIP CHOKE LEVER FRONT HANDLE COUPLER DRIVE SHAFT HOUSING STRING HEAD CURVED SHAFT GRASS DEFLECTOR PRIMER BULB KNOB CS30 (RY30000, RY30000A, RY30021, RY30021A) REAR HANDLE

Page 10 ATTACHING THE POWER HEAD TO THEATTACHMENT See Figure 2. WARNING: Never attach or adjust any attachment while power headis running. Failure to stop the engine can cause seriouspersonal injury. The attachment connects to the power head by means of acoupler device. 1. Loosen the knob on the cou...

Page 15 OPERATION FUELING AND REFUELING THE TRIMMER FUEL MIXTURE This product is powered by a 2-cycle engine and requirespre-mixing gasoline and 2-cycle oil. Pre-mix unleadedgasoline and 2-cycle engine oil in a clean 1 gallon containerapproved for gasoline. Recommended fuel: This engine is certified...

Page 18 STOP OPERATION Fig. 22 Fig. 21 THROTTLE TRIGGER IGNITION SWITCH STARTER GRIP THROTTLE TRIGGER IGNITION SWITCH STARTING INSTRUCTION LABEL PRIMER BULB STARTING AND STOPPING See Figures 21, 22, and 23. Trimmer should be on a flat, bare surface for starting. 1. Slowly press the primer bulb seven...

Page 19 MAINTENANCE You can often make adjustments and repairs describedhere. For other repairs, have the trimmer serviced by anauthorized service dealer. SPOOL REPLACEMENT NEW PREWOUND SPOOL See Figures 24 and 25. If replacing string only, refer to “String Replacement” later inthis manual. Use only...

Page 20 STRING REPLACEMENT See Figures 26, 27, and 28. Use only monofilament string. Use original manufacturer's replacement string for best performance. String Diameter: CS30 - .080 in. (2.0 mm) SS30 - .095 in. (2.4 mm) BC30 - .095 in. (2.4 mm) 1. Stop the engine, disconnect the spark plug wire. Ho...

Page 21 MAINTENANCE CLEANING THE EXHAUST PORT ANDMUFFLER Depending on the type of fuel used, the type and amount ofoil used, and/or your operating conditions, the exhaust portand muffler may become blocked with carbon deposits. Ifyou notice a power loss with your gas powered tool, aqualified service...

Page 23 PROBLEM POSSIBLE CAUSE SOLUTION IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER. TROUBLESHOOTING 1. Check spark. Remove spark plug. Reattach the spark plug cap and lay spark plug onmetal cylinder. Pull the starter rope and watchfor spark at spark plug tip. ...

Page 25 WARRANTY RYOBI TECHNOLOGIES INC. LIMITED WARRANTY FEDERAL AND CALIFORNIA EMISSIONCONTROL SYSTEMS NONROAD AND SMALL OFF-ROAD ENGINES The U.S. Environmental Protection Agency (EPA), the California Air Resources Board (CARB), and Ryobi Technologies Inc. are pleased toexplain the Emission Contro...

983000-401 RYOBI TECHNOLOGIES INC. 1428 Pearman Dairy Road Anderson, SC 29625 Post Office Box 1207 Anderson, SC 29622 Phone 1-800-860-4050 • SERVICE Now that you have purchased your tool, should a need ever exist for repair parts or service,simply contact your nearest Ryobi Authorized Service Center...