Ryobi 310BVr- Manuals

RULES FOR SAFE OPERATION • Do not touch the engine or muffler. These parts get extremely hot from operation. When turned off they remain hot for a short time. • Do not operate the engine faster than the speed needed to do the job. Do not run the engine at high speed when not in use. • Always stop th...

RULES FOR SAFE OPERATION SYMBOL MEANING • WEAR EYE AND HEARING PROTECTION WARNING: The operation of any power tool can be the source of thrown objects and loud noise which can cause severe eye injury and hearing loss. Always wear safety glasses or goggles eye protection meeting ANSI Z87.1 standards ...

RULES FOR SAFE OPERATION KNOW YOUR UNIT APPLICATIONS Models 280r and 310BVr - As a BLOWER: • Cleaning yards, garages, driveways, porches, patios. Model 310BVr only - As a VACUUM: • Picking up ieaves, iight debris, etc. Throttle

ASSEMBLY INSTRUCTIONS BLOWER TUBE AND NOZZLE ASSEMBLY A WARNING: Do not install tubes while unit is running to avoid serious personal injury. 1. Align the grooves in the blower tube with the pins in the blower outlet. 2. Grasping the tube firmly with both hands, push the tube into the blower outlet ...

ASSEMBLY INSTRUCTIONS INSTALLING THE ADAPTER ONTO THE UPPER VACUUM TUBE (MODEL 310BVr ONLY) A WARNING: Do not install while unit is running to avoid serious personal injury. 1. Turn the blower upside down (Fig. 4). Hold the blower between your knees to install the adapter and vacuum tubes. 2. Locate...

ASSEMBLY INSTRUCTIONS 5. Grasping the upper vacuum tube firmly with both hands (Fig. 9), turn the vacuum tube clockwise (Fig. 10) until the two (2) tabs of the adapter snap into the two (2) square indentations of the upper vacuum tube (Fig. 11). NOTE: This assembly requires the use of both hands bec...

OIL AND FUEL INFORMATION OIL AND FUEL MIXING INSTRUCTIONS Old and/or improperly mixed fuel are the main reasons for the unit not running properly. Be sure to use fresh, clean unleaded fuel. Follow the instructions carefully for the proper fuel/oil mixture. Definition of Blended Fuels Today's fuels a...

STARTING/STOPPING INSTRUCTIONS STARTING INSTRUCTIONS A WARNING: Operate this unit oniy in a weii- ventiiated area outdoors. Carbon monoxide exhaust fumes can be iethai in a confined area. A __ ^------------------------------------------------------------------------- WARNING: Avoid accidentai starti...

OPERATING INSTRUCTIONS HOLDING THE BLOWER/VACUUM Before operating the unit, stand in the operating position. Check for the follow ing: • Operator is wearing proper clothing, such as boots, safety glasses or goggles, ear/hearing protection, gloves, long pants, and long sleeve shirt. A WARNING: To avo...

OPERATING INSTRUCTIONS VACUUM OPERATING PROCEDURES (MODEL 310BVr ONLY) A WARNING: DO NOT OPEN THE DOOR WITH THE ENGINE RUNNING! To do so can result in serious personal injury caused by contact with the rotating biades. NOTE: Do not wear rubber or any other insulated gloves to avoid static electricit...

MAINTENANCE AND REPAIR INSTRUCTIONS SPARK ARRESTOR MAINTENANCE Removing the Muffler A WARNING: Make sure the muffler is cool before removing it from the housing to prevent serious personal injury. 1 Remove the 10 screws holding the unit housing together with a T20 Torx or flat blade screwdriver (Fig...

MAINTENANCE AND REPAIR INSTRUCTIONS Initial High Speed Mixture and Idle Speed Mixture Needle Settings 4. Insert a small flat blade screwdriver through the hole at the back of the top handle (Fig. 37). Turn both the high speed mixture and idle speed mixture needles out (counterclockwise) until the li...

TROUBLESHOOTING ENGINE WILL NOT START C A U S E A C T I O N Choke in incorrect position Refer to Starting/Stopping instructions on page 13 Empty fuei tank Fill fuel tank with properly mixed fuel Primer buib wasn't pressed enough Press primer bulb fully and slowly 5-7 times until fuel is visible in t...

SPECIFICATIONS ENGINE Type................................................................................... ...................................................................2-Cycle, Air-Cooled Displacement .............................................................................................

MANUFACTURER’S LIMITED WARRANTY FOR: RYOBI ® The limited warranty set forth below is given by MTD SOUTHWEST INC (“MTD”) with respect with new merchandise purchased and used in the United States, its possessions and territories. MTD warrants this product against defects in materiai and workmanship fo...