Roland PD-105X - Manuals - manualsarea.com

Page 2 - USING THE UNIT SAFELY; ALWAYS OBSERVE THE FOLLOWING

2 USING THE UNIT SAFELY 002b • Do not open or perform any internal modifications on the unit. (The only exception would be where this manual provides specific instructions which should be followed in order to put in place user-installable options.) ......................................................

Page 3 - IMPORTANT NOTES; Placement

3 IMPORTANT NOTES Placement 354a • Do not expose the unit to direct sunlight, place it near devices that radiate heat, leave it inside an enclosed vehicle, or otherwise subject it to temperature extremes. Excessive heat can deform or discolor the unit. 355b • When moved from one location to another ...

Page 4 - Main Features

4 • Snare/tom pad with mesh head allowing for excellent feel, dynamics and low level acoustics sound. • Rim shots and playing with brushes is possible. • The pad can mount on a V-Drums drum stand and/or commercially available tom stands (vertical rod type or horizontal pipe type p. 5) (PD-125X/105X ...

Page 5 - Stand with horizontal pipe; Mounting the Pads

5 The PD-125XS (dedicated snare pad) has no mounting bracket so can only be used with a snare stand. Make sure that the snare stand you are using is able to support a 12-inch shell. The PD-125X/105X can be attached to a stand that has either a vertical rod or a horizontal pipe. Stand with vertical r...

Page 6 - Connecting to the Percussion Sound Module

6 Use the included stereo cables to connect pads to your percussion sound module (sold separately). Connect the L-shaped end of the cable to the pad’s OUTPUT jack. Using a monaural cable will NOT allow rim shots or positional sensing. Refer to the table below for details on trigger inputs of sound m...

Page 7 - Adjusting the Head Tension; Replacing the Head

7 Before playing you must adjust the pad tension first. You can tune/adjust the head tension as you would with an acoustic drum, to get the same dynamic “feel.” The pad will function at it’s best if you are sure to: • Adjust the head evenly so that it does not sag. • Adjust the tuning bolts so that ...

Page 8 - Replacing the Shell Covering

8 • Applying excessive force to the sensor located under the head can damage it and/or interfere with accurate triggering. • Be careful not to hurt your fingers on the corners or points of the metal parts. 1. Loosen all tuning bolts, and remove the hoop and head. 2. Remove the frame. 3. Use a Philip...

Page 9 - Covering size

9 9. Install the frame in the shell. The frame’s output jack will be pointing in the same direction as the bracket. 10. Attach the hoop and head, and tighten the tuning bolts. 11. Adjust the tension of the head. Refer to “Adjusting the Head Tension” (p. 7). Covering size PD-125XS/PD-125X • 77 (Width...

Page 10 - Playing Methods

10 Head shots fig.Head.e Only playing the head and with certain snare sounds, the playing position will change the sound’s nuance. See the TD-20X/TDW-20/TD-20/TD-12 owner’s manual for more info about which sounds allow this. Rim shots fig.Rim.e Strike the head and the rim of the pad simultaneously. ...

Page 11 - Specifications

11 PD-125XS/PD-125X/PD-105X: V-Pad In the interest of product improvement, the specifications and/or appearance of this unit are subject to change without prior notice. Specifications PD-125XS PD-125X PD-105X Pad size 12 inch 12 inch 10 inch Trigger 2 (Head, Rim) Bracket – – – o o Dimensions 358 (W)...

Page 12 - WARNING

WARNING This product contains chemicals known to cause cancer, birth defects and other reproductive harm, including lead. For C.A. US (Proposition 65) For China For EU Countries PD-125X_125XS_105X_e.book 12 ページ２００９年５月１８日　月曜日　午前９時２３分

Page 13 - Information

AFRICA EGYPT Al Fanny Trading Office 9, EBN Hagar Al Askalany Street,ARD E1 Golf, Heliopolis, Cairo 11341, EGYPTTEL: (022)-417-1828 REUNION Maison FO - YAM Marcel 25 Rue Jules Hermann,Chaudron - BP79 97 491Ste Clotilde Cedex,REUNION ISLANDTEL: (0262) 218-429 SOUTH AFRICA T.O.M.S. Sound & Music (...