Page 2 - NOTICE
NOTICE FEDERAL EMISSION COMPONENT DEFECT WARRANTY and CALIFORNIAEMISSION CONTROL WARRANTY are applicable to only those enginescomplied with EPA (Environmental Protection Agency) and CARB (CaliforniaAir Resources Board) emission regulations in the U.S.A. AIR INDEX To show compliance with California e...
Page 3 - FEDERAL EMISSIONS COMPONENT DEFECT WARRANTY
FEDERAL EMISSIONS COMPONENT DEFECT WARRANTY EMISSIONS COMPONENT DEFECT WARRANTY COVERAGE - This emission warranty is applic-able in all States, except the State of California Fuji Heavy Industries Ltd. and Robin America Inc., Wood Dale Illinois, (herein "ROBIN AMERICA")warrant(s) to the init...
Page 9 - FOREWORD; E H
FOREWORD Thank you very much for purchasing a ROBIN ENGINE. Your ROBIN ENGINE can supply the power to operate varioussorts of machines and equipment.Please take a moment to familiarize yourself with the properoperation and maintenance procedures in order to maximizethe safe and efficient use of this...
Page 10 - CONTENTS
CONTENTS 1. SAFETY PRECAUTIONS ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ 1 2. COMPONENTS ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ 4 3. PRE-OPERATION CHECKS ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・...
Page 11 - SYMBOLS
Read the owner's manual. Stay clear of the hot surface. Exhaust gas is poisonous.Do not operate in an unventilated area. Stop the engine before refueling. Fire, open flame and smoking prohibited. On (Run) Plus ;positive polarity Off (Stop) Battery Engine oil Engine start (Elec-tric start) Add oil SY...
Page 12 - EXHAUST PRECAUTIONS; SAFETY PRECAUTIONS; FIRE PREVENTION
EXHAUST PRECAUTIONS ■ Never inhale exhaust gas.It contains carbon monoxide, a color-less, odorless and extremely danger-ous gas which can cause uncon-sciousness or death. ■ Never operate the engine indoors orin a poorly ventilated area, such astunnel, cave, etc. ■ Exercise extreme care when operat-i...
Page 16 - CHECK ENGINE OIL
3. PRE-OPERATION CHECKS − 5 − CHECK ENGINE OIL (DAILY) Before checking or refilling engine oil, be sure the engine is not running and is located on a stable, level surface. ■ If the oil level is below the lower levelline on the oil gauge, refill with theproper oil (see table) to the upperlevel.OIL C...
Page 18 - BATTERY INSTALLATION; PARTS NEEDED; KEY SWITCH CABLE
4. BATTERY INSTALLATION − 7 − CABLE LENGTH CABLE DIA. WIRE GAUGE AWG (BS) BWG SAE JIS Less than 1.5 m 7.3 mm 1 6 AV15 1.5 m to 2.5 m 8.5 mm 0 4 AV20 2.5 m to 4.0 m 10.8 mm 3/0 2 AV30 PARTS NEEDED ■ Use a battery rated 12V-30AH orlarger. ■ Use a proper cable and ground wireto connect battery and key ...
Page 19 - WIRING; WIRING DIAGRAM
− 8 − WIRING ■ Connect positive terminal of theelectric starter and positive termi-nal of the battery with batterycable. ■ Ground negative terminal of thebattery to the body of engine ormachine with ground wire. NOTE Tighten bolts and nuts on terminalssecurely so they will not be loosenedby vibratio...
Page 20 - OPERATING YOUR ENGINE; CHOKE KNOB; STARTING; FUEL VALVE; ELECTRIC STARTER
5. OPERATING YOUR ENGINE − 9 − Pull the choke knob. ■ If the engine is cold or the ambienttemperature is low, pull the chokeknob fully. ■ If the engine is warm or the ambienttemperature is high, pull the chokeknob half-way, or keep it fully open. CHOKE KNOB STARTING 1 (Provided by the equipment manu...
Page 21 - RUNNING
− 10 − ■ After starting the engine, gradu-ally open choke by pushing thechoke knob and finally keep itfully opened. ■ Do not fully open the chokeimmediately when the engine iscold or the ambient temperatureis low, because the engine maystop. CHOKE KNOB After the engine starts, set thespeed control l...
Page 22 - STOPPING; SPEED CONTROL LEVER
− 11 − STOPPING Set the speed control lever at thelow speed position and allow theengine to run at low speed for 2 or3 minutes before stopping. SPEED CONTROL LEVER 2 Turn the key switch to the "STOP"position. ELECTRIC STARTER 3 Close the fuel valve. FUEL VALVE STOPPING ENGINEWITH THE FUEL VA...
Page 23 - EASY TROUBLESHOOTING; WHEN ENGINE WILL NOT START:; Is there enough compression?; WARNING
6. EASY TROUBLESHOOTING − 12 − WHEN ENGINE WILL NOT START: ■ Perform the following checks before you take the engine to your Robin dealer. ■ If you still have trouble after completing the checks, take the engine to yournearest Robin dealer. Is there enough compression? If the spark plug is loose, ti...
Page 24 - Is your battery well charged ?
− 13 − Is your battery well charged ? Check the battery, it may be dischargedand unable to operate the electricstarter. Consult your nearest dealer or serviceshop. EH63-65 EPA/CARB 取説EU1728 02.7.31 10:30 AM ページ13
Page 25 - MAINTENANCE SCHEDULE; DAILY INSPECTION; PERIODIC MAINTENANCE
− 14 − 7. MAINTENANCE SCHEDULE DAILY INSPECTION Before running the engine, check the following service items. PERIODIC MAINTENANCE Periodic maintenance is vital to safe and efficient operation of your engine.Check the table below for periodic maintenance intervals. IT IS ALSO NECESSARY FOR THE USER ...
Page 27 - ENGINE OIL CHANGE
8. "HOW-TO" MAINTENANCE − 16 − INSPECTING THE SPARKPLUG ■ Clean off carbon deposits on thespark plug electrode using a plugcleaner or wire brush. ■ Check electrode gap.Adjust gap to : 0.03 inches(0.7mm to 0.8mm) ■ Use a proper spark plug :NGK BP6ES 0.03 in(0.7 to 0.8 mm) ENGINE OIL CHANGE ■ ...
Page 28 - CAUTION
− 17 − ENGINE OIL FILTER REPLACEMENT ■ Initial engine oil filter replacement shouldbe performed after 20 hours of operation.Thereafter replace the engine oil filterevery 200 hours. ■ When installing a new oil filter, apply oilto O-ring, attach the oil filter in positionand tighten 2/3 turns by hand ...
Page 30 - HIGH ALTITUDE ENGINE OPERATION
− 19 − HIGH ALTITUDE ENGINE OPERATION ■ Please have an authorized Robin America service dealer modify this engine if it is to be run continuously above 5,000 feet (1,500 meters). Failure to do so,may result in poor engine performance, spark plug fouling, hard starting, andincreased emissions. ■ Carb...
Page 31 - ENGINE OIL; CLEAN AND STORE; PREPARATIONS FOR STORAGE
ENGINE OIL ■ Change the engine oil with fresh oil. ■ Remove the spark plug, pour about 5cc of engine oil into the cylinder,slowly start the engine for 2 or 3seconds, and re-install the sparkplug. CLEAN AND STORE ■ Remove the spark plug wires fromthe spark plugs. ■ Slowly turn the crankshaft until re...