ROBERTS 996 - Manuals - manualsarea.com

Page 2 - Controls; Dial scale pointer

1 Controls 1. Dial scale pointer 2. Telescopic aerial 3. Waveband switch 4. Power on indicator 5. Tuning control (Top) 2 3 1 4 5

Page 3 - DC input socket

If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) 2 Controls 6. Carry strap 7. DC input socket 8 (Left) 7 8. Volume / On/Off control 9. Headphone socket 10. Battery compartment (Right) 10 9 6

Page 4 - Battery operation; battery cover

3 Battery operation 1. Remove the battery cover on the back of the unit by sliding the cover in the direction of the arrow. 2. Insert four LR6 (AA size) batteries into the spaces in the compartment. Take care to ensure all batteries are inserted with the correct polarity as shown next to the battery...

Page 5 - Operation via an AC adaptor (not included); Plug the mains adaptor into the; IMPORTANT; The mains adaptor is used as the means of connecting the

If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) 4 Operation via an AC adaptor (not included) The AC adaptor for use with the Classic 996 should provide 6 volts DC output at 300mA centre pin negative. 1. Place your radio on a ﬂ at surface. 2. Plug the ...

Page 6 - Operating your radio - FM

5 Operating your radio - FM 1. Switch on your radio by rotating the Volume control anti-clockwise until a click is heard. The Power on indicator will light up. 2. For FM reception fully extend the Telescopic aerial and then angle and rotate for best reception. 3. Set the Waveband switch to the FM wa...

Page 7 - Operating your radio - Medium and Long wave

If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) 6 Operating your radio - Medium and Long wave 1. Switch on your radio by rotating the Volume control anti-clockwise until a click is heard. The Power on indicator will light up. 2. Select the Waveband sw...

Page 8 - Headphone socket; Headphone Socket

Headphone socket A 3.5mm Headphone Socket located on the right hand side of your radio is provided for use with either headphones or an earpiece. Inserting a plug automatically mutes the internal loudspeaker. IMPORTANT: Excessive sound pressure from earphones and headphones can cause hearing loss. 7

Page 9 - General; The name plate is located on the back of your radio.

If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) 8 General Do not allow this radio to be exposed to water, steam or sand. Do not leave your radio where excessive heat could cause damage such as in a parked car where the heat from the sun can build up e...

Page 10 - Power Requirements

9 Circuit Features Loudspeaker 76mm Headphone socket 3.5mm dia Output Power 400mW into 8 ohms Aerial System FM Telescopic aerial MW Built-in Ferrite aerial LW Built-in Ferrite aerial Speciﬁ cations Power Requirements Mains AC 230 volts, 50Hz only (adaptor not included) Batteries 4 x LR6 (AA size) Ba...

Page 11 - Guarantee; The guarantee does not cover:

If you need any further advice, please call our Technical Helpline on :- 020 8758 0338 (Mon-Fri) Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated...

Issue 1 ROBERTS RADIO TECHNICAL SERVICES 97-99 Worton Road Isleworth Middlesex TW7 6EG Technical Helpline :- 020 8758 0338 (Mon-Fri during ofﬁ ce hours) Web site: http://www.robertsradio.co.uk © 2010 Roberts Radio Limited