Rinnai EN13L - Manuals

Rinnai 4 Operation Manual ABOUT YOUR PORTABLE CONVECTOR HEATER NAVIGATING THE REMOTE CONTROL ON button Operates the heater. OFF button Stops the heater. Up and Down buttons Used to raise or lower the set temperature. Infra red transmitter Transmits signal to heater. Battery The remote control is pow...

Rinnai 5 Operation Manual FEATURES FEATURES COMMON TO ALL MODELS PUSH BUTTON IGNITION Only one touch of the STANDBY/ON switch is required to operate theheater. CHILD LOCK When the Child Lock is activated all controls other than theSTANDBY/ON switch will be locked. Deactivating the lock releasesthe c...

Rinnai 6 Operation Manual IMPORTANT POINTS The appliance is not intended for use by young children or infirm persons without supervision. Young children should always be supervised to ensure that they DO NOT play with the appliance. DO NOT allow children or elderly persons to sleep in the warm air d...

Rinnai 8 Operation Manual INSTALLATION UNPACKING THE APPLIANCE Check for damage. If the heater is damaged, DO NOT INSTALL and contact your supplier for advice. WHAT’S IN THE BOX The following items should also be included in the carton: This Operation Manual and Remote Controlwith Battery. BEFORE IN...

Rinnai 9 Operation Manual INSTALLATION CHECKING ROOM SIZE The heaters MUST NOT be installed in a room smaller than specified, these are: The Avenger 25 minimum room size 62.5 m³. The Dynamo 15 minimum room size 37.5 m³. The * Enduro 13 minimum room size 32.5 m³. To determine if the intended room mee...

Rinnai 10 Operation Manual HOW TO OPERATE THE HEATER TO TURN THE HEATER ON Before you begin, ensure that the Gas and Power have been connected correctly to the appliance. To turn the appliance on press the ON/OFF button located on the control panel. For models that are equipped with a remote control...

Rinnai 11 Operation Manual HOW TO OPERATE THE HEATER TO TURN THE HEATER OFF To turn the heater off while it is in operation press the ON/OFF button located on the control panel. For models that are equipped with a remote control the OFF button may also be used. The On/Combustion indicator will go ou...

Rinnai 13 Operation Manual TIMER OPERATION - AVENGER & DYNAMO PROGRAMMING TIMER 2 Pressing the Set Times button again after setting programming Timer 1 (four presses from the beginning) selectsthe Timer 2 ‘On’ programming mode which allows adjustment ofthe time when the heater switches ‘On’ (or ...

Rinnai 16 Operation Manual LOCK AND SAFETY DEVICES USING THE LOCK FUNCTION The Lock function will avoid accidental operation andprevent small children from altering the heater settings. To Activate the Lock To activate the Lock function press both the Up andDown buttons simultaneously. The function ...

Rinnai 17 Operation Manual CARE AND MAINTENANCE Your heater needs very little maintenance, but the following information will help you to keep it lookinggood and working efficiently. AIR FILTERS Dusty filters reduce heating effectiveness. DO NOT wait for Filter indicator to come on before cleaning f...

Rinnai 18 Operation Manual CARE AND MAINTENANCE TROUBLE SHOOTING CHECKLIST Use the following chart to help determine whether a service call is required, however if you are unsureabout the way your heater is operating, contact Rinnai or your local agent. ERROR CODES Your heater is also fitted with se...

Rinnai 19 Operation Manual SPECIFICATIONS GENERAL SPECIFICATIONS WEIGHT AND MEASURES General Description: Portable Gas Convector Heaters. Gas Control: Electronic control Burner Surface Combustion Burner Gas Connection: 3/8” MI BSP into 1.5 metre flexible gas hose with bayonet connection Convection F...

Rinnai 20 Operation Manual SPECIFICATIONS WIRING DIAGRAM BLOCK DIAGRAM

E&TG 12-014 21 RA TSD 12-014 Issue 6 - 24/09/14 Head Office 100 Atlantic Drive,Keysborough, Victoria 3173P.O. Box 460BRAESIDE VIC 3195Tel: (03) 9271 6625Fax: (03) 9271 6622 National Help Line Tel: 1300 555 545* Fax: 1300 555 655**Cost of a local call Higher from mobile or public phones. Australi...