QSC WL2102-w - Manuals - manualsarea.com

Page 2 - IMPORTANT SAFETY PRECAUTIONS AND EXPLANATION OF SYMBOLS; Disclaimer

1 2 IMPORTANT SAFETY PRECAUTIONS AND EXPLANATION OF SYMBOLS Install in accordance with instructions by QSC Audio Products, LLC instructions and under the supervision of a licensed Professional Engineer. WARNING! Before placing, installing, rigging, or suspending any speaker product, inspect all hard...

Page 3 - Introduction; Rear

1 2 Introduction The WideLine-10 loudspeaker system has been designed to provide a compact system that has unique dispersion characteristics, high-power handling and extended low-frequency response. Its primary uses include ballrooms, theatres, night clubs, houses of worship, and small to medium siz...

Page 4 - TRI AMP/BI AMP Switch; SELECT

3 4 TRI AMP/BI AMP Switch TRI AMP: Shading network is NOT applied (shading must be provided by upstream signal processing). Connect the full-range input signal to pins 1+ and 1-, connect the shaded (processed) signal to pins 2+ and 2-. To flip shaded transducer location, use the mF (UNSHADED) SELECT...

Page 5 - Input Connections; Neutrik NL8FC Cable Connector Pinout; Table 1: Input Connector Wiring, BI AMP and TRI AMP Modes

3 4 Input Connections The input connectors are a pair of Neutrik NL8’s wired in parallel. Connections for bi-amp and tri-amp vary (Table 1) . The pin designations for the NL8FC cable connector is shown for reference, bottom right. Note! In TRI AMP mode, the MF (UNSHADED) SELECT switch position deter...

Page 6 - Rigging; Rules for Suspension

5 6 Rigging Rules for Suspension Correct use of all suspension hardware and components is imperative in sound system rigging and deployment. • Always calculate suspended loads before lifting to ensure suspension components and hardware are used within their respective load limits. • Research local c...

Page 7 - Front Articulated Joint (Knuckle) Hardware

5 6 Rigging WideLine-10 enclosures use a three-point suspension system. The system consists of front, left/right, captive articulated joints and a single rear link bar. Articulation is in 2° increments using the first location on the link bar. With the use of the second location, 1° degree increment...

Page 9 - WL SmALL Grid

7 8 AF2102-LA The link arm is located on the bottom side of the frame assembly. Use this link for attaching the rear of the first enclosure. The frame allows for up or down angle options for use with either stacking or suspending. The 4° “normal” locations on the link system will yield a net 0° vert...

Page 10 - Care; Dimensions

9 10 Stacking the WL SmALL Grid The WL SmALL GRID comes with two aluminum I-bars used for aligning and securing the frame to QSC’s 215SB or 215PCm subwoofer. To use the I-bars, simply slide each one into the small frame’s L-track and secure with a stud fitting. Then, turn the frame over (I-bars on t...

Page 11 - Specifications

9 10 WL2102 WL2102-w Configuration Bi-amp or tri-amp mode Transducers Low-frequencyHigh-frequency 2 x 400 W, 16 Ω 10" woofer, 3" voice coil, ceramic magnet assembly 1.4" exit, 3" titanium diaphragm, neodymium magnet assembly Frequency Response (±3 dB) 1 55 Hz – 18 kHz (with recommend...