Pyramid CDR40DX - Manuals - manualsarea.com

Page 2 - CONTENTS

2 CONTENTS Installation .....................................................................................................3 DIN Front-Mount (Method A) ..................................................................................3 Installing the unit .............................................

Page 3 - INSTALLATION; driving function of the driver.; Installing the unit

3 INSTALLATION Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver. • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. • Use o...

Page 4 - Removing the unit

4 1. Dashboard2. Nut (5mm)3. Spring washer4. Screw (5 x 25mm)5. Screw6. Strap Be sure to use the strap to secure the back of the unit in place. The strap canbe bent by hand to the desired angle. 7. Plain washer Removing the unit 1. Frame2. Insert fingers into the groove in the front of frame and pul...

Page 5 - HOW TO REMOVE AND INSTALL THE FRONT PANEL; Keep the front panel into the case.; REMOVING THE FRONT PANEL

HOW TO REMOVE AND INSTALL THE FRONT PANEL 1. Press the release button and pull-off the front panel. Keep the front panel into the case. 2. To install the front panel, insert the panel into the housing and make sure the panel is properly installed, otherwise, abnormalities occurs on the display or so...

Page 6 - WIRING CONNECTION

6 WIRING CONNECTION GREY GREY/BLACK MAIN UNIT WHITE WHITE/BLACK LEFT SPEAKER RIGHTSPEAKER Rch RED Lch WHITE (FOR RCA LINE OUT VERSION ONLY) (GREY) RCA CABLE ANTENNA CONNECTOR RED YELLOW BLACK BLUE POWER ANTENNA GROUND (B–) MEMORY BACK-UP IGNITION SWITCH (B+) (FOR POWER ANT. VERSION ONLY)

Page 7 - OPERATION; GENERAL OPERATION; BALANCE; Slide VOL button (3) to left or right to adjust volume level.; TONE CONTROL

OPERATION 7 GENERAL OPERATION ON/OFF Press PWR button (1) to turn on the unit. Press it again to turn it off. BALANCE Slide BAL button (2) to left or right to adjust sound balance between left and rightspeakers. VOLUME Slide VOL button (3) to left or right to adjust volume level. TONE CONTROL Slide ...

Page 8 - RADIO OPERATION

8 RESET BUTTONRESET button (17) is placed on the housing and must be activated with either a ballpoint pen or thin metal object. The RESET button (17) is to be activated for the following reasons:• Initial installation of the unit when all wiring is completed.• All the function buttons do not operat...

Page 9 - CD OPERATION

9 CD OPERATION DISC PLAY Gently insert a compact disc with the label side facing up into the disc slot (13). Thedisc is then automatically loaded into the unit and starts playing with the first track ofthe disc. The digital display will indicate the track number and the time of the track. EJECT Pres...

Page 10 - SPECIFICATION

10 GENERAL P ower Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 163 (D) x 50 (H) mm Tone Controls- Bass (at 100 Hz) : ± 10 dB - Treble (at 10 KHz) : ± 10 dB Maximum Output P ower : 7W x 2 (ch) Current Drain : 3 Ampere CD PLAYER Signal to Noise Ratio : More than 60...

Page 11 - TROUBLE SHOOTING; Symptom

11 TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problemspersist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition switch is If the power supply is properly not on. connected to the ca...