Premier Mounts WMK-027 - Manuals

Page 2 - Contact Premier Mounts with any questions; Warning Statements; Attaching the Projector Arm

Page 2 Installation Instructions Table of Contents PREMIER MOUNTS DOES NOT WARRANT AGAINST DAMAGE CAUSED BY THE USE OF ANY PREMIER MOUNTS PRODUCT FOR PURPOSES OTHER THAN THOSE FOR WHICH IT WAS DESIGNED OR DAMAGE CAUSED BY UNAUTHORIZED ATTACH- MENTS OR MODIFICATIONS, AND IS NOT RESPONSIBLE FOR ANY DA...

Page 3 - Parts List; Upper Mounting Bracket; Installation Tools; Phillips Screwdriver; Extension Hardware Pack

Installation Instructions Page 3 Parts List This mount is shipped with all proper installation hardware and components. Make sure that none of these parts are missing and/or damaged before beginning installation. If there are parts missing and/or damaged, please stop the installation and contact Pre...

Page 4 - Determining the Installation Height; will represent the lower edge of the wall plate.; Legend

Page 4 Installation Instructions Determining the Installation Height Step 1 . Measure distance from center of lens to the top of the PDS-PLUS bracket. Step 2 . Add the distance from the ground to the top of the screen (A), the recommended offset from the projector manual (B), the measurement from St...

Page 5 - Installation Instructions; Wood Stud Installation; locate the center of the stud; Once the holes have been; Completed Installation

Installation Instructions Page 5 Wood Stud Installation DEAD CENTER MUST BE LOCATED ON THE STUD FOR CORRECT AND SAFE INSTALLATION. Step 1. Use an electronic stud finder (commercially available) to locate the center of the stud that is in the wall. Step 2. Use a pencil to mark the first mounting hole...

Page 6 - Solid Surface Installation

Page 6 Installation Instructions Solid Surface Installation Concrete drill bits are commercially available. Step 1. Place the wall plate against the wall and use a level to make sure the wall plate is level from top to bottom. Step 2. Use a pencil to mark the location of the mounting holes. Step 3. ...

Page 7 - Utilizing the Storage Feature; Open the storage door that is located on the side of; Locate the mounting hook cutout on the top of the wall plate.

Installation Instructions Page 7 WMK-027 Utilizing the Storage Feature The storage feature may be used to store electronic components. There is an accessible door on each side of the storage enclosure. It may be securely held shut with the use of four (4) M5 x 12mm security head screws. It may be ea...

Page 8 - Throw Distance Calculation; . Refer to the projectors Users Manual to; Front Mounted Lens; to distance listed in projector Users Manual.; Rear Mounted Lens; . Use a tape measure to mark the appropriate

Page 8 Installation Instructions Please review the Operator’s Manual that came packaged with your projector before attaching the upper mounting bracket. The correct throw distance (the distance from the projector to the screen) must be determined prior to mounting the projector. Throw Distance Calcu...

Page 9 - M6 x 12mm security head screws.; Upper Mounting Bracket Installation

Installation Instructions Page 9 Security Wrench WMK-027 Step 1 . Insert the inner slide plate into the projector arm. Step 2 . Determine which adjustment slot will be best for the projector placement. Step 3 . Raise the upper mounting bracket into position. Step 4 . Align the mounting holes of the ...

Page 10 - Base Box Installation; Raise the base box projector mount to the upper mounting bracket.; must be determined prior to mounting the projector.

Page 10 Installation Instructions WMK-027 Base Box Installation Base Box M6 x 12mm Screws Step 1. Raise the base box projector mount to the upper mounting bracket. Step 2. Align the two (2; one each side) mounting holes. Step 3. Using a screwdriver/security wrench, insert and tighten two (2) M6 x 12...

Page 11 - Cable Management; . Route the cables through one end of the WMK-027 and out the other end.

Installation Instructions Page 11 Cable Management WMK-027 Electronic Components Electronic Components Cables Cables WMK-027 WMK-027 Cable Opening Cable Opening Projector Hook-Ups Projector Hook-Ups Electronic Components Cable Opening Step 1 . The cable access holes are located at the end of the sho...

Page 12 - Technical Specifications

WMK-027 Page 12 Installation Instructions Technical Specifications All measurements are in inches(mm).