Page 2 - TO PREVENT ACCIDENTAL INJURIES:; To use the Model 445, simply snug up the flooring with; Videos and Instructions,
Always wear approved front and side EYE PROTECTION when operating this Nailer. Others in the work area should also wear front and side EYE PROTECTION . Eye protection will help guard against flying nails and debris, which could cause severe eye injury. EAR PROTECTION may be required to prevent heari...
Page 3 - WARNING; We will not be responsible for oil stains.; OPERATION; Read these instructions carefully before you use the Nailer.
WARNING Whenever air is connected to the Nailer, keep body parts away from the nail discharge path. Disconnect the air line before making adjustments or repairs on the Nailer. Only connect air to an unloaded Nailer so as to prevent accidental discharge. Consult the drawing for the appropriate adapte...
Page 4 - TO LOAD MODEL 445 SN:
TO LOAD MODEL 445 XLL, LL or SL: Place up to two sticks (200 Powercleats) into the Nail Channel feed slot. Pull back the spring loaded Nail Pusher over the nails until it contacts the last nail and slowly release the Nail Pusher. TO LOAD MODEL 445 XLS, LS or SS: Place one stick (100 Powercleats) int...
Page 6 - REASSEMBLING THE NAILER:
WARNING The U-Cup Lip Seals #23 and #24 look alike, but they are different, DO NOT mix them up. 3. Carefully wipe off the Lip Seal surface with a clean rag and lubricate it generously with the supplied Mobile DTE Light Air Tool Oil lubricant. Piston Rod U-Cup Lip Seal (#24): 1. Remove the old U-Cup ...
Page 7 - Pneumatic Seal Part Numbers and Locations
6 TO CLEAR A NAIL JAM (continued): 3. Separate the Foot and gate with a screw driver just enough to clear out the jammed nail. 4. Put thread locking compound on all screws and reassemble the components. Pneumatic Seal Part Numbers and Locations 7
Page 8 - DESCRIPTION; Key
MODELS 445 XLL, XLS, LL, LS, SL, SS & SN PARTS LIST KEY: S=Sold Separately, A= Sold as part of assembly, K=Sold as part of a Kit ITEM # PART NO. DESCRIPTION QTY. REQ’D Key Assembly or Kit 1 09-445-29701 BODY 1 N/A 2 09-445-29702 CAP 1 S 3 09-445-29703 HANDLE, LONG 1 A A-6 4 09-445-29703.1 HANDLE...
Page 10 - SCHEMATIC
10 SCHEMATIC MODELS 445 XLL, XLS, LL, LS, SL, and SS
Page 12 - POWERCLEATS LENGTH DETERMINATION CHART; tested in the field before proceeding.; ” 16 GAGE POWERCLEATS®
12 POWERCLEATS LENGTH DETERMINATION CHART This chart will assist you in determining the proper length of Powercleats to use for various thicknesses of flooring. Approximate vertical penetration of the Powercleat under the hardwood floor is shown for each application. This is only a guide. Results sh...
Page 13 - POWERNAILER MODEL 445 TROUBLE SHOOTING CHART
PROBLEM POSSIBLE CAUSE SOLUTION 1 Driving blade does not retract 1. Zero or Low air pressure Check air supply for 70 psi minimum to 110 psi maximum 2. Lack of lubrication Manually lubricate through male air inlet fitting 3. Excessive dirt inside nailer Disassemble and clean 4. Bent or burred driving...
