Powermatic WP2412 - Manuals

8 Unpacking Open shipping crate and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Read this instruction manual thoroughly for assembly, maintenance and safety instructions. Contents of the Shipping Container 1 Planer 3 Lifting hooks 4 Open-end wrenc...

9 Installation Tools required for installation wrench set (provided) level forklift or crane with straps 1. Remove the crate from around the planer and any fasteners securing the planer to the skid. 2. Remove the side cov ers and place the lifting hooks into the slots (Figure 1). Place straps under ...

10 2. Make sure the voltage of the power source corresponds to the v oltage of the planer as recorded on the motor plate. 3. Open the electrical enclosure on the left side of the machine (Figure 3) by loosening the screws and sliding the panel upward. 4. Connect the three phases to the terminals mar...

11 3. The Reset button (Figure 5) will light up if the machine becomes ov erloaded. Press this button to re-start the machine. 4. The Emergency Stop Button shuts down all operations on the planer. An automatic brake stops the motor within 10 seconds. A similar stop button can be found at the back of...

13 9. After adjusting or changing knives, the digital display should be checked and recalibrated if necessary. See “Calibrating Digital Display.” Belt Tension & Replacement Note: Belts should be replaced as a matched set of three. 1. Loosen the three bolts (A, Figure 10) which hold the motor sup...

14 Feed Rollers The infeed and outfeed rollers and chipbreaker hav e been factory set. Howev er, if spring tension adjustment should ev er be necessary, use the appropriate adjustment assembly located beneath the lip of the frame – one is shown in Figure 13. 1. Loosen the nut and turn the screw in o...

15 Troubleshooting: Operating Problems Trouble Probable Cause Remedy Table rollers not set properly. Adjust rollers to proper height. Inadequate support of long boards. Support long boards with extension rollers. Unev en feed roller pressure front to back. Adjust feed roller tension. Dull kniv es. R...

16 Troubleshooting: Mechanical & Electrical Problems Trouble Probable Cause Remedy Board thickness does not match digital display Digital display not calibrated properly. Follow calibration procedures. Inadequate chain tension. Adjust chain tension. Sprockets misaligned. Align sprockets. Chain j...

18 Replacement Parts Replacement parts are listed on the following pages. To order parts or reach our serv ice department, call 1-800-274-6848 between 7:00 a.m. and 6:00 p.m. (CST), Monday through Friday. Having the Model Number and Serial Number of your machine av ailable when you call will allow u...

30 Parts List: Electrical Box Index No. Part No. Description Size A .............. WP2412-601 ........... Fuse Holder ................................... 3 poles, 50 A B .............. WP2412-602 ........... Fuse Holder ......................................1 pole, 32A C .............. WP2412-603 .....

32 Parts List: Control Panel Index No. Part No. Description Size J ............... WP2412-701 ........... Main On-Off Switch............................................ K .............. WP2412-702 ........... ELGO Read-out Z 20 ......................................... L ............... WP2412-703 ....

36 WMH Tool Group 2420 Vantage Drive Elgin, Illinois 60123 Phone: 800-274-6848 www.wmhtoolgroup.com