Powermatic PF-BS - Manuals

8 Mounting Hole Location NOTE: Dimensions are in inches, hole sizes are metric. Figure 1

9 Assembly and Installation Tools needed for assembly: 8.5mm drill bit M10 x 1.5P tap 17mm wrench Remove the clear plastic from around the Stock Feeder and Fence Assembly. Exposed metal surfaces hav e been giv en a protectiv e coating at the factory. This should be removed with a soft cloth moistene...

10 3. Tighten the handle (A, Figure 3). If necessary, move the Fence slightly to bring it parallel with the blade. 4. When satisfied, mark the location of the second hole using the hole in the Fence base as your template. 5. Remove the Fence from the table, and drill and tap the second hole. 6. Plac...

11 Grounding Instructions Electrical connections must be made by a qualified electrician in compliance with all relevant codes. This machine must be properly grounded to help prevent electrical shock and possible fatal injury. As receiv ed from the factory, the PF-BS Stock Feeder will run on either ...

12 Adjustments Fence Movement To move the fence toward or away from the saw blade, loosen the lock handle (A, Figure 10) and rotate the knob (B, Figure 10). A millimeter scale is inscribed on the edge of the rack (C, Figure 10). After adjustment, re-tighten lock handle (A, Figure 10). Spring Tension...

13 Changing Feed Rate 1. Loosen the two hex nuts (one is shown in Figure 13) that hold the motor to the motor mount. Use a 12mm wrench. Do not remov e the hex nuts, loosen them only enough so that the motor can be pivoted. 2. Pivot the motor counterclockwise, as shown in Figure 13. This will produce...

14 2. Set the desired rate of feed on the Stock Feeder by moving the belt to the proper pulley groov es. Proper rate of feed will depend upon the hardness and thickness of the workpiece, and is best learned through experience. 3. Set the Fence so that the dimension on the scale (C, Figure 10) matche...

15 Arm Axis Keep the axis of the arm lubricated with a good quality general purpose grease, inserted through the grease fitting (Figure 18). Fence At least once a week, place a light coat of oil on the sliding column of the fence. Also place a drop of oil on each roller pin. See Figure 19. Figure 18...

17 Replacement Parts Replacement parts are listed on the following pages. To order parts or reach our serv ice department, call 1-800-274-6848 between 7:00 a.m. and 6:00 p.m. (CST), Monday through Friday. Having the Model Number and Serial Number of your machine av ailable when you call will allow u...

18 Parts List: Fence Assembly Index No. Part No. Description Size Qty 1 ............... PFBS-101 ............... Roller Fence ...................................................... ................................... 1 2 ............... PFBS-102 ............... Column ..................................

20 Parts List: Feeder Assembly Index No. Part No. Description Size Qty 1 ............... BB-6202ZZ.............. Ball Bearing ....................................................... 6202ZZ ....................... 1 2 ............... BB-6204Z................ Ball Bearing ................................

24 WMH Tool Group 2420 Vantage Drive Elgin, Illinois 60123 Phone: 800-274-6848 www.wmhtoolgroup.com